Marco Dignum

Flow cytometry and adenosine tri-phosphate analysis: Alternative possibilities to evaluate major bacteriological changes in drinking water treatment and distribution systems

An ever-growing need exists for rapid, quantitative and meaningful methods to quantify and characterize the effect of different treatment steps on the microbiological processes and events that occur during drinking water treatment and distribution. Here we compared cultivation-independent flow cytometry (FCM) and adenosine tri-phosphate (ATP) analysis with conventional cultivation-based microbiological methods, on water samples from two full-scale treatment and distribution systems. The two systems consist of nearly identical treatment trains, but their raw water quality and pre-treatment differed significantly. All of the drinking water treatment processes affected the microbiological content of the water considerably, but once treated, the finished water remained remarkably stable throughout the distribution system. Both the FCM and ATP data were able to describe the microbiology of the systems accurately, providing meaningful process data when combined with other parameters such as dissolved organic carbon analysis. Importantly, the results highlighted a complimentary value of the two independent methods: while similar trends were mostly observed, variations in ATP-per-cell values between water samples were adequately explained by differences in the FCM fingerprints of the samples. This work demonstrates the value of alternative microbial methods for process/system control, optimization and routine monitoring of the general microbial quality of water during treatment and distribution.

Bacterial Colonization of Pellet Softening Reactors Used during Drinking Water Treatment

ABSTRACT Pellet softening reactors are used in centralized and decentralized drinking water treatment plants for the removal of calcium (hardness) through chemically induced precipitation of calcite. This is accomplished in fluidized pellet reactors, where a strong base is added to the influent to increase the pH and facilitate the process of precipitation on an added seeding material. Here we describe for the first time the opportunistic bacterial colonization of the calcite pellets in a full-scale pellet softening reactor and the functional contribution of these colonizing bacteria to the overall drinking water treatment process. ATP analysis, advanced microscopy, and community fingerprinting with denaturing gradient gel electrophoretic (DGGE) analysis were used to characterize the biomass on the pellets, while assimilable organic carbon (AOC), dissolved organic carbon, and flow cytometric analysis were used to characterize the impact of the biological processes on drinking water quality. The data revealed pellet colonization at concentrations in excess of 500 ng of ATP/g of pellet and reactor biomass concentrations as high as 220 mg of ATP/m3 of reactor, comprising a wide variety of different microorganisms. These organisms removed as much as 60% of AOC from the water during treatment, thus contributing toward the biological stabilization of the drinking water. Notably, only a small fraction (about 60,000 cells/ml) of the bacteria in the reactors was released into the effluent under normal conditions, while the majority of the bacteria colonizing the pellets were captured in the calcite structures of the pellets and were removed as a reusable product.

The Influence of the Removal of Specific NOM Compounds by Anion Exchange on Ozone Demand, Disinfection Capacity, and Bromate Formation

This research on a pilot scale focuses on the reaction of ozone with natural organic matter (NOM) for three water qualities with different dissolved organic carbon (DOC) concentrations and NOM compositions, obtained after several stages of an anion exchange process. It was shown that for the same ozone dosage per DOC, the ozone demand was higher, less bromate was formed and a lower disinfection capacity was reached for water containing mainly humic substances, than for water where the humic substances were partly removed. It can be concluded that NOM composition, specifically the humic substances, influences the ozone demand, disinfection capacity and bromate formation.