Maria Elisabete Machado

Investigation of sulphur compounds in coal tar using monodimensional and comprehensive two-dimensional gas chromatography

Coal is a non renewable fossil fuel, used mainly as a source of electrical energy and in the production of coke. It is subjected to thermal treatment, pyrolysis, which produces coke as a main product, in addition to a condensed liquid by-product, called tar. Tar is a complex mixture of organic compounds which contains different chemical classes, presenting aromatic and sulphur heterocyclic compounds. In general, identification of these compounds requires steps of isolation and fractionation, mainly due to co-elution of these compounds with polyaromatic hydrocarbons (PAH). The objective of this work is to characterize the sulphur compounds present in the coal tar obtained via pyrolysis, using comprehensive two-dimensional gas chromatography with time-of-flight mass spectrometry detector (GC×GC/TOFMS). Coal samples from the State of Paraná, Brazil were subjected to laboratorial scale pyrolysis. Several experimental conditions were tested, such as sample weight (5, 10 and 15g), heating ramp (10, 25 and 100°C/min) and final temperature (500, 700 and 900°C). Samples were analyzed by one dimensional gas chromatography (1D-GC) coupled to a quadrupole mass spectrometry detector (GC/qMS) and two-dimensional gas chromatography with time-of-flight mass spectrometry detector (GC×GC/TOFMS). The higher amount of sulphur compounds was obtained at a final temperature of 700°C and a heating ramp of 100°C/min. The main classes observed in the color plot were thiophenes, benzothiophenes and alkylated dibenzothiophenes. GC×GC/TOFMS allowed the identification of the greater number of compounds and the separation of several sulphur compounds from one another. Moreover, separation of sulphur compounds from polyaromatic hydrocarbons and phenols was achieved, which was not possible by 1D-GC. Comparing GC×GC/TOFMS and 1D-GC (SIM mode) also showed that 1D-GC, one of the most employed quantification tools for sulphur compounds, can be misleading for detection, identification and quantification, as the number of isomers of sulphur compounds found was greater than theoretically possible.

Comparison between pre-fractionation and fractionation process of heavy gas oil for determination of sulfur compounds using comprehensive two-dimensional gas chromatography.

The separation of the organic sulfur compounds (OSC) of petroleum or its heavy fractions is a critical step and is essential for the correct characterization of these compounds, especially due to similar physical and chemical properties of polycyclic aromatic sulfur heterocycles (PASH) and polycyclic aromatic hydrocarbons (PAH). This similarity results in coelutions among PAH and PASH and for this reason former steps of fractionation are required before gas chromatographic analysis. The objective of this study was to evaluate the potential of GC×GC for the separation and identification of OSC in a heavy gas oil sample without fractionation, after pre-fractionation in an alumina column and also after fractionation process. This last one was performed with a modified stationary phase manufactured and characterized in the laboratory, called Pd(II)-MPSG, where palladium is chemically linked to silica through mercaptopropyl groups. The fractions obtained from both procedures were analyzed by GC×GC/TOFMS, which was effective to separate and identify various classes of OSC. A hundred and thirty-five compounds were tentatively identified in the sample that was only pre-fractionated. However, when the fractionation was also performed with the Pd(II)-MPSG phase, a larger number of sulfur compounds were found (317). Results have shown that the analysis of a pre-fractionated sample by GC×GC/TOFMS is suitable when the goal is a general characterization of classes of compounds in the sample, while a more detailed analysis of PASH can be performed, using also the fractionation Pd(II)-MPSG phase. GC×GC/TOFMS played a major role in the comparison of samples obtained from pre-fractionation and fractionation steps due to its high peak capacity, selectivity, organized distribution of chromatographic peaks and resolution.

Identification of organic sulfur compounds in coal bitumen obtained by different extraction techniques using comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometric detection

The determination of organic sulfur compounds (OSC) in coal is of great interest. Technically and operationally these compounds are not easily removed and promote corrosion of equipment. Environmentally, the burning of sulfur compounds leads to the emission of SOx gases, which are major contributors to acid rain. Health-wise, it is well known that these compounds have mutagenic and carcinogenic properties. Bitumen can be extracted from coal by different techniques, and use of gas chromatography coupled to mass spectrometric detection enables identification of compounds present in coal extracts. The OSC from three different bitumens were tentatively identified by use of three different extraction techniques: accelerated solvent extraction (ASE), ultrasonic extraction (UE), and supercritical-fluid extraction (SFE). Results obtained from one-dimensional gas chromatography (1D GC) coupled to quadrupole mass spectrometric detection (GC–qMS) and from two-dimensional gas chromatography with time-of-flight mass spectrometric detection (GC × GC–TOFMS) were compared. By use of 2D GC, a greater number of OSC were found in ASE bitumen than in SFE and UE bitumens. No OSC were identified with 1D GC–qMS, although some benzothiophenes and dibenzothiophenes were detected by use of EIM and SIM modes. GC × GC–TOFMS applied to investigation of OSC in bitumens resulted in analytical improvement, as more OSC classes and compounds were identified (thiols, sulfides, thiophenes, naphthothiophenes, benzothiophenes, and benzonaphthothiophenes). The roof-tile effect was observed for OSC and PAH in all bitumens. Several co-elutions among analytes and with matrix interferents were solved by use of GC×GC.

Speciation of nitrogen-containing compounds in an unfractionated coal tar sample by comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry.

Comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry (GC×GC/TOFMS) has shown great skill in analyzing complex mixtures such as fossil fuels, especially for compounds at low concentrations. The analysis of N-polyaromatic compounds (NPAC) in coal and crude oil is a great challenge for analytical chemistry due to its environmental and technological importance, and also its diversity of concentration in the matrix. This study is the first report in the applicability of GC×GC/TOFMS for detection of NPAC in a coal tar sample with no fractionation. Normally these compounds are analyzed after sample treatment, making the process expensive and time consuming. However, the higher separation power of GC×GC/TOFMS, compared to 1D-GC, produces cleaner mass spectra in complex samples, which helps in identification of analytes with no pre-fractionation. In this paper, the main objectives were to demonstrate the applicability of GC×GC/TOFMS in the speciation and separation between basic and neutral NPAC from coal tar sample derived from fast pyrolysis, without prior sample fractionation. The methodology used here consisted of chromatographic injection of the diluted sample using a conventional columns set and data analysis by ChromaTOF/Excel™ software. Some basic compounds (pyridines and quinolines) and neutral ones (carbazoles and indoles) were detected with good chromatographic separation and spectral similarity. Tools like spectral deconvolution, extracted ion chromatogram (EIC) and dispersion graphics allowed greater security on the identification and separation of NPAC in this complex sample of coal tar, with no pre-treatment.

Determination of aromatic sulphur compounds in heavy gas oil by using (low-)flow modulated comprehensive two-dimensional gas chromatography-triple quadrupole mass spectrometry.

The present research is focused on the development of a flow-modulated comprehensive two-dimensional gas chromatography-triple quadrupole mass spectrometry (FM GC × GC-MS/MS) method for the determination of classes of aromatic organic sulphur compounds (benzothiophenes, dibenzothiophenes, and benzonaphthothiophene) in heavy gas oil (HGO). The MS/MS instrument was used to provide both full-scan and multiple-reaction-monitoring (MRM) data. Linear retention index (LRI) ranges were used to define the MRM windows for each chemical class. Calibration solutions (internal standard: 1-fluoronaphthalene) were prepared by using an HGO sample, depleted of S compounds. Calibration information was also derived for the thiophene class (along with MRM and LRI data), even though such constituents were not present in the HGO. Linearity was satisfactory over the analyzed concentration range (1-100 mg/L); intra-day precision for the lowest calibration point was always below 17%. Accuracy was also satisfactory, with a maximum percentage error of 3.5% (absolute value) found among the S classes subjected to (semi-)quantification. The highest limit of quantification was calculated to be 299 μg/L (for the C1-benzothiophene class), while the lowest was 21 μg/L (for the C4-benzothiophene class).

Preliminary studies of bio-oil from fast pyrolysis of coconut fibers.

This work studied fast pyrolysis as a way to use the residual fiber obtained from the shells of coconut ( Cocos nucifera L. var. Dwarf, from Aracaju, northeastern Brazil). The bio-oil produced by fast pyrolysis and the aqueous phase (formed during the pyrolysis) were characterized by GC/qMS and GC×GC/TOF-MS. Many oxygenated compounds such as phenols, aldehydes, and ketones were identified in the extracts obtained in both phases, with a high predominance of phenolic compounds, mainly alkylphenols. Eighty-one compounds were identified in the bio-oil and 42 in the aqueous phase using GC/qMS, and 95 and 68 in the same samples were identified by GC×GC/TOF-MS. The better performance of GC×GC/TOF-MS was due to the possibility of resolving some coeluted peaks in the one-dimension gas chromatography. Semiquantitative analysis of the samples verified that 59% of the area on the chromatogram of bio-oil is composed by phenols and 12% by aldehydes, mainly furfural. Using the same criterion, 77% of the organic compounds in the aqueous phase are phenols. Therefore, this preliminary assessment indicates that coconut fibers have the potential to be a cost-effective and promising alternative to obtain new products and minimize environmental impact.

Palladium(II) chemically bonded to silica surface applied to the separation and identification of polycyclic aromatic sulfur heterocycles in heavy oil

Separation of polycyclic aromatic sulfur heterocycles among themselves and also from interferents in petrochemical matrices is a challenging task because of their low concentration, matrix complexity, and also due to the presence of polyaromatic hydrocarbons, as they present similar physico-chemical properties. Therefore, the objective of this work was preparation, characterization, and application of a stationary phase for separation of these compounds in a heavy gas oil sample and their identification by comprehensive two-dimensional gas chromatography. The stationary phase was prepared by grafting mercaptopropyltrimethoxisilane onto a silica surface, followed by palladium(II) chloride immobilization. Elemental analysis, thermogravimetry, nitrogen adsorption-desorption isotherms, infrared analysis, and scanning electron microscopy were performed to characterize this solid phase. Sulfur compounds were separated in an open column packed with the stationary phase and analyzed by comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometric detection. The number of compounds tentatively identified was 314 and their classes were thiophenes, benzotiophenes, dibenzothiophenes, naphthothiophenes, benzonaphthothiophenes, and dinaphthothiophenes. Separation among sulfur compounds and polyaromatic hydrocarbons was successful, which is a difficult goal to achieve with the traditionally employed solid phases. Some recalcitrant compounds (dibenzothiophenes with substituents of two and four carbons) were fully separated and tentatively identified.

Quantification of nitrogen compounds in diesel fuel samples by comprehensive two‐dimensional gas chromatography coupled with quadrupole mass spectrometry

Although several methods for the analysis of nitrogen compounds in diesel fuel have been described in the literature, the demand for rapid, sensitive, and robust analyses has increased in recent years. In this study, a comprehensive two-dimensional gas chromatographic method was developed for the identification and quantification of nitrogen compounds in diesel fuel samples. The quantification was performed using the standard addition method and the analysis was conducted using comprehensive two-dimensional gas chromatography coupled with fast quadrupole mass spectrometry. This study is the first to report quantification of nitrogen compounds in diesel fuel samples using the standard addition method without fractionation. This type of analysis was previously performed using many laborious separation steps, which can lead to errors and losses. The proposed method shows good linearity for target nitrogen compounds evaluated (m-toluidine, 4-ethylaniline, indole, 7-methylindole, 7-ethylindole, carbazole, isoquinoline, 4-methylquinoline, benzo[h]quinolone, and acridine) over a range from 0.05 to 2.0 mg/L, and limits of detection and quantification of <0.06 and 0.16 mg/L, respectively, for all nitrogen compounds studied.

Bio-Oil Production by Thermal Cracking in the Presence of Hydrogen

This paper describes the bio-oil production process of a mixture of agricultural wastes: discarded soybean frying oil, coffee and sawdust, by pyrolysis and thermal cracking in the presence of hydrogen. The fractions obtained in the pyrolysis and/or cracking processes were divided into a light fraction and a heavy one. All the fractions were analyzed by comprehensive two-dimensional gas chromatography with time-of-flight mass spectrometry detection (GC×GC/ TOFMS). The characteristics of the fractions obtained in resulting from the cracking process in the presence of hydrogen were have characteristics similar to those of petroleum-based naphtha, while the fractions obtained by from the pyrolysis contained process produced significant quantities of compounds such as furanmethanol, hexanol, and benzofuran, whose commercial value is high.

GC×GC-TOF/MS Analysis of Bio-Oils Obtained from Pyrolysis of Acuri and Baru Residues

Bark of acuri and endocarp of baru are residues generated during the processing of these fruits. One alternative to consider is the pyrolysis of these materials to generate bio-oils, opening the perspective for the production of environment-friendly, added value products. Samples of acuri and baru were subjected to laboratorial scale pyrolysis. At the optimized pyrolysis conditions, the bio-oils yields (m/m) were 30% for bark of acuri and 29% for endocarp of baru. Next, the obtained bio-oil was submitted to proximate analysis and GC×GC-TOF/MS (two-dimensional gas chromatography with time-of-flight mass spectrometric detection). The bio-oil generated from the bark of acuri proved to be of the highest complexity with 113 identified compounds, while the bio-oil generated from the endocarp of baru sample led to 71 identified compounds. A total of 29 compounds were confirmed using standards in the acuri bark bio-oil, while 23 compounds were confirmed for endocarp of baru bio-oil. There was a predominance of phenols and ketones for the bio-oil generated from acuri bark, and hydrocarbons and phenols for the bio-oil from baru endocarp.