Marina Mariano

Light coupling into the Whispering Gallery Modes of a fiber array thin film solar cell for fixed partial Sun tracking

We propose the use of whispering gallery mode coupling in a novel configuration based on implementing a thin film cell on the backside of an array of parallel fibers. We performed numerical calculations using the parameters of a thin film organic cell which demonstrate that light coupling becomes more effective as the angle for the incident light relative to the fiber array normal increases up to an optimal angle close to 55 deg. At this angle the power conversion efficiency of the fiber array solar cell we propose becomes 30% times larger than the one from an equivalent planar cell configuration. We demonstrate that the micro fiber array solar cell we propose may perform an effective partial tracking of the sun movement for over 100 degrees without any mechanical help. In addition, in the event that such fiber array cell would be installed with the adequate orientation on a vertical façade, an optimal photon-to-charge conversion would be reached for sunlight incident at 55 deg with respect to the horizon line, very close to the yearly average position for the sun at Latitude of 40 deg.

Semi-transparent polymer solar cells

Abstract. Over the last three decades, progress in the organic photovoltaic field has resulted in some device features which make organic cells applicable in electricity generation configurations where the standard silicon-based technology is not suitable, for instance, when a semi-transparent photovoltaic panel is needed. When the thin film solar cell performance is evaluated in terms of the device’s visible transparency and power conversion efficiency, organic solar cells offer the most promising solution. During the last three years, research in the field has consolidated several approaches for the fabrication of high performance semi-transparent organic solar cells. We have grouped these approaches under three categories: devices where the absorber layer includes near-infrared absorption polymers, devices incorporating one-dimensional photonic crystals, and devices with a metal cavity light trapping configuration. We herein review these approaches.

Intermittent Chaos for Ergodic Light Trapping in a Photonic Fiber Plate

Extracting the light trapped in a waveguide, or the opposite effect of trapping light in a thin region and guiding it perpendicular to its incident propagation direction, is essential for optimal energetic performance in illumination, display or light harvesting devices. Here we demonstrate that the paradoxical goal of letting as much light in or out while maintaining the wave effectively trapped can be achieved with a periodic array of interpenetrated fibers forming a photonic fiber plate. Photons entering perpendicular to that plate may be trapped in an intermittent chaotic trajectory, leading to an optically ergodic system. We fabricated such a photonic fiber plate and showed that for a solar cell incorporated on one of the plate surfaces, light absorption is greatly enhanced. Confirming this, we found the unexpected result that a more chaotic photon trajectory reduces the production of photon scattering entropy.

Measurement of the dispersion of air and of refractive index anomalies by wavelength-dependent nonlinear interferometry

We carry out wavelength-dependent second harmonic interference experiments using thin films of an organic dye as nonlinear optical sources. While the measured difference of refractive index between the fundamental and second harmonic wavelengths follows the theoretical expectation for air in a wide spectral region, anomalous dispersion is observed when the second harmonic light lies in the absorption band of the dye. The sensitivity of the technique to small refractive index variations may prove useful for sensing applications as well as for testing models of light dispersion in weakly dispersing and absorbing media.

One-Dimensional Photonic Crystals for Light Management in Organic Solar Cells

An effective charge collection in the majority of organic solar cells is achieved when the photo-converting layer is just a few tens of nanometer in thickness. In such conditions light management is an essential ingredient to reach the best performance from such type of organic devices. This chapter introduces an inverse integration procedure to optically optimize the architecture of organic solar cells. The relevant role played by the electron and hole transporting layers in such optical optimization of the architecture is discussed. Next, inverse integration is considered to design disordered one-dimension photonic crystal type structures to enhance photocurrent generation in semi-transparent solar cells. It is shown that the light management provided by the photonic structure is essential to achieve a performance which optimizes the balance among device transparency and efficiency.