Mário Tanomaru-Filho

Effect of calcium hydroxide intracanal dressing on the bond strength of a resin-based endodontic sealer

The aim of this in vitro study was to evaluate the bond strength of Epiphany resin-based sealer to dentin walls after placement of calcium hydroxide [Ca(OH)2] dressings. Fifteen extracted single-rooted human teeth were instrumented using 2.5% NaOCl + EDTA as irrigants. The teeth were randomly assigned to 3 groups (n=5), according to the intracanal dressing: G1= Ca(OH)2 + saline; G2= Ca(OH)2 + 2% chlorhexidine gluconate (CHX) gel; and G3= saline (control). After 10 days of storage in 100% humidity at 37 degrees C, the dressings were removed and the root canals were filled with Epiphany sealer. After additional 48 h of storage, the specimens were sectioned transversally into 2-mm-thick discs. Push-out tests were performed (1 mm/min, Instron 4411) and the maximum loads at failure were recorded in MPa. One-way ANOVA and Newman-Keuls tests showed a statistically significant decrease in bond strength when a Ca(OH)2 dressing was used before root canal filling with Epiphany (G1= 10.18 +/- 1.99 and G2= 9.98 +/- 2.97) compared to the control group (13.82 +/- 3.9) (p< 0.05). It may be concluded that the use of Ca(OH)2 as an intracanal dressing material affected the adhesion of Epiphany to the root canal walls, but even though the values were within the acceptable range found in the literature.

Physicochemical properties of calcium silicate cements associated with microparticulate and nanoparticulate radiopacifiers

ObjectivesThe objective of this paper was to evaluate the physicochemical properties of calcium silicate cements with different chemical compositions, associated with radiopacifying agents.Materials and methodsMineral trioxide aggregate (MTA) Angelus, calcium silicate cement with additives (CSC), and resinous calcium silicate cement (CSCR) were evaluated, with the addition of the following radiopacifiers: microparticles (micro) or nanoparticles (nano) of zirconium oxide (ZrO2), niobium oxide (Nb2O5), bismuth oxide (Bi2O3), or calcium tungstate (CaWO4). Setting time was evaluated using Gilmore needles. Solubility was determined after immersion in water. The pH and calcium ion release were analyzed after 3, 12, and 24xa0h and 7, 14, and 21xa0days. The data obtained were submitted to analysis of variance and Tukey’s test, at a level of significance of 5xa0%.ResultsCSC + CaWO4 and CSCR + ZrO2 micro, Nb2O5 and CaWO4 presented results similar to MTA, with a shorter final setting time than the other associations. CSC and CSCR+ ZrO2 micro presented a higher degree of flow. All the cements evaluated presented low solubility. The materials presented alkaline pH and released calcium ions.ConclusionsZrO2 micro radiopacifier may be considered a potential substitute for Bi2O3 when associated with CSC or CSCR.Clinical relevanceThe proposed materials, especially when associated with ZrO2, are potential materials for use as alternatives to MTA.

pH and Antimicrobial Activity of Portland Cement Associated with Different Radiopacifying Agents

Objective. The aim of this study was to evaluate the antimicrobial activity and pH changes induced by Portland cement (PC) alone and in association with radiopacifiers. Methods. The materials tested were pure PC, PC + bismuth oxide, PC + zirconium oxide, PC + calcium tungstate, and zinc oxide and eugenol cement (ZOE). Antimicrobial activity was evaluated by agar diffusion test using the following strains: Micrococcus luteus, Streptococcus mutans, Enterococcus faecalis, Pseudomonas aeruginosa, and Candida albicans. After 24 hours of incubation at 37°C, inhibition of bacterial growth was observed and measured. For pH analysis, material samples (n = 10) were placed in polyethylene tubes and immersed in 10u2009mL of distilled water. After 12, 24, 48, and 72 hours, the pH of the solutions was determined using a pH meter. Results. All microbial species were inhibited by the cements evaluated. All materials composed of PC with radiopacifying agents promoted pH increase similar to pure Portland cement. ZOE had the lowest pH values throughout all experimental periods. Conclusions. All Portland cement-based materials with the addition of different radiopacifiers (bismuth oxide, calcium tungstate, and zirconium oxide) presented antimicrobial activity and pH similar to pure Portland cement.

Effectiveness of three solvents and two associations of solvents on gutta-percha and resilon

This study evaluated the effectiveness of 3 solvents (Citrol orange oil, Eucalyptol and Tetrachloroethylene) and 2 associations of solvents (Citrol orange oil+Tetrachloroethylene and Eucalyptol+Tetrachloroethylene) on 3 types of gutta-percha (conventional, thermoplastic and EndoREZ) and Resilon. Ten discs (10 mm diameter x 1 mm thick) from each material were prepared using standard metallic molds. Each specimen was weighed to determinate its initial mass. The specimens were immersed in the solvents for 10 min, followed by immersion in distilled water for 20 min, and were then reweighed to obtain the final mass. The mean weight loss determined the solvent capacity. Data were analyzed by ANOVA and Tukeys test at 5% significance level. Tetrachloroethylene was the most effective on conventional gutta-percha (p<0.05). Tetrachloroethylene was also the most effective on thermoplastic gutta-percha, but it was not significantly different (p>0.05) from Eucalyptol+Tetrachloroethylene, Citrol+Tetrachloroethylene, and Citrol. All solvents and associations presented little effectiveness on Resilon. The association Eucalyptol+Tetrachloroethylene was the most effective on EndoREZ, but it did not differ significantly (p>0.05) from Citrol+Tetrachloroethylene and Tetrachloroethylene. All evaluated substances presented solvent action. Tetrachloroethylene improved the effectiveness of both Citrol and Eucalyptol.

Compressive Strength and Setting Time of MTA and Portland Cement Associated with Different Radiopacifying Agents

Objective. The aim of this study was to evaluate the compressive strength and setting time of MTA and Portland cement (PC) associated with bismuth oxide (BO), zirconium oxide (ZO), calcium tungstate (CT), and strontium carbonate (SC). Methods. For the compressive strength test, specimens were evaluated in an EMIC DL 2000 apparatus at 0.5u2009mm/min speed. For evaluation of setting time, each material was analyzed using Gilmore-type needles. The statistical analysis was performed with ANOVA and the Tukey tests, at 5% significance. Results. After 24 hours, the highest values were found for PC and PC + ZO. At 21 days, PC + BO showed the lowest compressive strength among all the groups. The initial setting time was greater for PC. The final setting time was greater for PC and PC + CT, and MTA had the lowest among the evaluated materials (P < 0.05). Conclusion. The results showed that all radiopacifying agents tested may potentially be used in association with PC to replace BO.

Effectiveness of gutta-percha and Resilon in filling lateral root canals using the Obtura II system

The aim of this study was to evaluate the effectiveness of gutta-percha and Resilon in filling lateral root canals by using the Obtura II system. Root canals of artificial teeth were prepared using a standard protocol, and lateral canals were made in three thirds of the root canal. The root canals were filled with either Obtura gutta-percha (OB), Endo-points flow gutta-percha (ED), or Resilon (RE) by using the Obtura II system. The fillings were evaluated using digitized radiographs and analyzed by using Image Tool software. Outlines of the total areas of the lateral canals and the filled areas were used to determine the percentage of filling in each lateral canal. Data were analyzed with the Kruskal-Wallis and Dunn tests at a 5% significance level. RE and ED showed better results than OB did in the three thirds of the root canals. When the root canal thirds were compared, OB and RE were more effective in the cervical third than in the apical third (p < 0.05). In conclusion, Resilon and EndoFlow gutta-percha were effective in filling lateral canals by using the Obtura II system.

Photodynamic therapy in root canals contaminated with Enterococcus faecalis using curcumin as photosensitizer

The aim of the study was to evaluate the photodynamic therapy (PDT) effect on root canals contaminated with Enterococcus faecalis using a light emitting diode (LED) light and a curcumin solution (CUR) as photosensitizer (PS). Eighty root canals from uniradicular human teeth were prepared with Protaper Universal rotary system and contaminated with E. faecalis for 21xa0days. They were divided as: GIa-PDT (CUR, pre-irradiation for 5u2009+u20095xa0min of irradiation); GIb-PDT (CUR, pre-irradiation for 5u2009+u200910xa0min of irradiation); GIIa-(CUR, pre-irradiation for 5u2009+u20095xa0min without irradiation); GIIb-(CUR pre-irradiation for 5u2009+u200910xa0min of irradiation); GIIIa-(physiological solution and irradiation for 5xa0min); and GIIIb-(physiological solution and irradiation for 10xa0min); positive and negative control groups. Collections from root canals were made at time intervals of 21xa0days after contamination, immediately after treatment, and 7xa0days after treatment, and submitted to colony forming units per milliter (CFUxa0mL−1) counts. The data were submitted to ANOVA and Tukey multiple comparison tests, at a level of significance of 5xa0%. In the immediate post-treatment collection, group GIa showed greater bacterial reduction in comparison with GIIa, GIIb, GIIIa, GIIIb, and positive control (Pu2009<u20090.05). At 7xa0days post-treatment, GIa showed significant bacterial reduction only in comparison with GIIIa (Pu2009<u20090.05). Curcumin as sensitizer was effective by 5xa0min LED irradiation but not by 10xa0min irradiation PDT using LED light, and curcumin as PS was not effective in eliminating E. faecalis. No difference was observed for periods of irradiation.

Effect of Zirconium Oxide and Zinc Oxide Nanoparticles on Physicochemical Properties and Antibiofilm Activity of a Calcium Silicate-Based Material

The aim of the present study was to evaluate the antibiofilm activity against Enterococcus faecalis, compressive strength. and radiopacity of Portland cement (PC) added to zirconium oxide (ZrO2), as radiopacifier, with or without nanoparticulated zinc oxide (ZnO). The following experimental materials were evaluated: PC, PC + ZrO2, PC + ZrO2 + ZnO (5%), and PC + ZrO2 + ZnO (10%). Antibiofilm activity was analyzed by using direct contact test (DCT) on Enterococcus faecalis biofilm, for 5u2009h or 15u2009h. The analysis was conducted by using the number of colony-forming units (CFU/mL). The compressive strength was performed in a mechanical testing machine. For the radiopacity tests, the specimens were radiographed together with an aluminium stepwedge. The results were submitted to ANOVA and Tukey tests, with level of significance at 5%. The results showed that all materials presented similar antibiofilm activity (P > 0.05). The addition of nanoparticulated ZnO decreased the compressive strength of PC. All materials presented higher radiopacity than pure PC. It can be concluded that the addition of ZrO2 and ZnO does not interfere with the antibiofilm activity and provides radiopacity to Portland cement. However, the presence of ZnO (5% or 10%) significantly decreased the compressive strength of the materials.

Radiopacity and cytotoxicity of Portland cement associated with niobium oxide micro and nanoparticles

Objective Mineral Trioxide Aggregate (MTA) is composed of Portland Cement (PC) and bismuth oxide (BO). Replacing BO for niobium oxide (NbO) microparticles (Nbµ) or nanoparticles (Nbη) may improve radiopacity and bioactivity. The aim of this study was to evaluate the radiopacity and cytotoxicity of the materials: 1) PC; 2) White MTA; 3) PC+30% Nbµ; 4) PC+30% Nbη. Material and Methods For the radiopacity test, specimens of the different materials were radiographed along an aluminum step-wedge. For cell culture assays, Saos-2 osteoblastic-cells (ATCC HTB-85) were used. Cell viability was evaluated through MTT assay, and bioactivity was assessed by alkaline phosphatase activity assay. Results The results demonstrated higher radiopacity for MTA, followed by Nbµ and Nbη, which had similar values. Cell culture analysis showed that PC and PC+NbO associations promoted greater cell viability than MTA. Conclusions It was concluded that the combination of PC+NbO is a potential alternative for composition of MTA.

Biocompatibility of intracanal medications based on calcium hydroxide.

Objective. The aim of this study was to evaluate the rat subcutaneous tissue reaction to calcium hydroxide-based intracanal medicaments, UltraCal XS (calcium hydroxide, barium sulphate, aqueous matrix), Hydropast (calcium hydroxide, barium sulphate, and propyleneglycol), and Calen (Calcium hydroxide, zinc oxide, colophony, and polyethyleneglycol), used as a control. Methods. Forty-eight rats (Rattus Norvegicus Holtzman) were distributed in three groups: Calen, UltraCal XS, and Hydropast. Polyethylene tubes filled with one of the medicaments were implanted in the dorsal subcutaneous. After 7 and 30 days, the implants were removed and the specimens were fixed and embedded in paraffin. Morphological and quantitative analyses were carried out in the HE-stained sections. The numerical density of inflammatory cells in the capsule was evaluated and statistical analyses were performed (P ≤ 0.05). Results. At 7 days, all materials induced an inflammatory reaction in the subcutaneous tissue adjacent to the implants. In all groups, a significant reduction in the number of inflammatory cells and giant cells was verified in the period of 30 days. Conclusion. These results indicate that the calcium hydroxide-based medicaments evaluated present biocompatibility similar to Calen.