Markus Vehniäinen

Development of a Recombinant Fab-Fragment Based Electrochemical Immunosensor for Deoxynivalenol Detection in Food Samples

A reliable and cost-effective electrochemical method for the detection of deoxynivalenol (DON) in cereals and cereal-based food samples based on the use of a novel anti-DON Fab fragment is presented. The analytical system employed, Enzyme-Linked-Immunomagnetic-Electrochemical (ELIME) assay, is based on the use of immunomagnetic beads (IMBs) coupled with eight magnetized screen-printed electrodes (8-mScPEs) as electrochemical transducers. Using standard solutions of DON, a working range between 100 and 4500 ng/ml was obtained with an EC(50) of 380 ng/ml. The ELIME assay was employed to evaluate the cross-reactivity of the Fab fragment towards different trichothecenes revealing a good selectivity towards DON over other trichothecenes with the exception of 3-Ac-DON. The sensor was then applied to cereals and cereal-based food samples (wheat, breakfast cereal and baby-food) and a wide range of sample treatment procedures was tested. Within-laboratory precision (9-24% repeatability for breakfast cereals and 10-33% for baby-food) and recovery data (82-110% for breakfast cereals and 97-108% for baby-food) were calculated by analyzing blank breakfast cereals and baby-foods fortified with DON, demonstrating that the proposed method has the capability for use as a screening assay for DON in such products.

Study on nonspecificity of an immuoassay using Eu-doped polystyrene nanoparticle labels.

Nanoparticle labels have been shown to improve the sensitivity of a sandwich immunoassay significantly. Further improvement in sensitivity is limited by nonspecific binding of the nanoparticle labels. Here, an experimental characterization of assay performance was carried out using clinically important analytes thyroid stimulating hormone and prostate-specific antigen. Particular attention was paid to characterization of nonspecific binding properties of nanoparticle labels. Therefore, different particle sizes and high affinity monoclonal antibodies (Mab) and their Fab and scFv recombinant antibody fragments were investigated. Combination of Fab fragment as a capture antibody and Mab as a detector antibody on a nanoparticle label resulted in high signal-to-background ratio consistently. Against the expectations no significant difference in nonspecific binding was found using fragmented antibodies compared to Mabs. The results also suggested that nonspecific binding was independent of the particle size. The particle size had a significant effect on the specific signal favouring the use of small particles giving a high specific signal. This study indicated that nonspecific binding is not readily affected by the physical size of the nanoparticle label or antibodies used in the assay.

Engineering of a broad-specificity antibody: Detection of eight fluoroquinolone antibiotics simultaneously

Recombinant sarafloxacin-recognizing antibody was engineered with the use of novel fluoroquinolone (FQ) derivatives. A monoclonal FQ antibody, 6H7, was targeted to random mutagenesis to broaden the specificity of the antibody in development of a generic assay for FQ antibiotics. Engineering involved the synthesis of different small-sized FQ molecules to immobilize and detect the mutant antibodies. Selections with labeled FQs resulted in several mutant antibodies with increased affinity or wider specificity toward different FQs. The best characterized mutant antibody was capable of recognizing seven of eight targeted FQs below maximum residue limits set by the European Union. The results are promising in regard to the development of a multiresidue immunoassay for FQs based on a single antibody.

Immunoreactivity of recombinant human glandular kallikrein using monoclonal antibodies raised against prostate‐specific antigen

The gene encoding human glandular kallikrein (KLK2) was expressed in Escherichia coli, and the corresponding protein (hK2) was produced by fermentation. The hK2 was characterized by Western blotting and epitope map using monoclonal antibodies (MAbs) specific for another protease, prostate‐specific antigen (PSA) with high structural identity (80%). MAbs that recognized three different epitopes were bound to hK2, representing 7 out of 23 MAbs tested. One epitope was localized to the sequence region around amino acid position 78, which is believed to be glycosylated in hK2. The affinities of MAbs recognizing hK2 were similar to those for PSA, suggesting that common epitopes seem to contain very conserved structures. The result may help in designing specific diagnostic assays for the assessment of prostate cancer. Prostate 31:84–90, 1997.

Two ScFv antibody libraries derived from identical VL–VH framework with different binding site designs display distinct binding profiles

In directed evolution experiments, a single randomization scheme of an antibody gene does not provide optimal diversity for recognition of all sizes of antigens. In this study, we have expanded the recognition potential of our universal library, termed ScFvP, with a second distinct diversification scheme. In the second library, termed ScFvM, diversity was designed closer to the center of the antigen binding site in the same antibody framework as earlier. Also, the CDR-H3 loop structures were redesigned to be shorter, 5-12 aa and mostly without the canonical salt bridge between Arg106H and Asp116H to increase the flexibility of the loop and to allow more space in the center of the paratope for binding smaller targets. Antibodies were selected from the two libraries against various antigens separately and as a mixture. The origin and characteristics of the retrieved antibodies indicate that complementary diversity results in complementary functionality widening the spectrum of targets amenable for selection.

Quantitative PCR detection and improved sample preparation of microcystin-producing Anabaena, Microcystis and Planktothrix.

Blooms of toxic cyanobacteria, associated with illness and mortality in humans and animals, are becoming increasingly common worldwide. The safe use of surface waters for drinking water production and recreation necessitates assessment of toxigenic cyanobacteria. We have developed simple and reliable sample preparation and qPCR methods to detect microcystin-producing strains of three major bloom-forming genera, Anabaena, Microcystis and Planktothrix. The mcyB second thiolation motif, previously not recognized as a potential target for qPCR, was used as a basis for primer and genus-specific probe design. Assay specificity and sensitivity was confirmed with cultured cyanobacterial strains and the effect of different sample preparation methods on quantification was investigated. Sample filtration and cell lysis reduced assay time and resulted in more efficient amplification compared to DNA extraction. Positive correlation (p<0.005) between mcyB copy numbers and microcystin concentrations was observed in environmental samples. The results encourage the use of qPCR in water risk management.

Multiresidue detection of fluoroquinolones: specificity engineering of a recombinant antibody with oligonucleotide-directed mutagenesis.

Screening of a group of antibiotics from foodstuffs has traditionally relied on sophisticated chemical or physical analysis methods, such as liquid chromatography and mass spectrometric applications. The equipment for these techniques is expensive and not always applicable for high throughput screening. There is a need for an easy and cost efficient detection method for simultaneous screening of structurally similar compounds. Here we describe the engineering of a recombinant antibody which was subjected to oligonucleotide targeted random mutagenesis to emphasize the generic specificity of fluoroquinolone binding. Phage display together with small sized fluoroquinolone derivatives was used to find antibodies of high affinity and generic specificity. The most improved antibody was used to develop a time-resolved fluorescence immunoassay which was further optimized and applied for the detection of fluoroquinolone residues from spiked whole milk samples. The assay can be used to efficiently screen all European Agency for the Evaluation of Medicinal Products (EMEA) controlled fluoroquinolones from whole milk samples with detection levels ranging from 0.2 to 68 μg L(-1).

Use of high-capacity surface with oriented recombinant antibody fragments in a 5-min immunoassay for thyroid-stimulating hormone

High-capacity surfaces can enhance analyte-binding kinetics and be beneficial for rapid immunoassays. Site-specifically immobilized, oriented recombinant single-chain Fv (scFv) and Fab antibody fragments were compared with a conventional, nonoriented monoclonal antibody (Mab) to capture antigen from serum to solid surface in a one-step, two-site thyroid-stimulating hormone (TSH) immunoassay with a 5-min incubation time. The assay used a ready-to-use dry reagent-based concept and time-resolved fluorescent measurement. TSH binding capacities were 3.0-fold (Fab) and at least 4.1-fold (scFv) higher when recombinant antibodies were used instead of Mab. Recombinant antibody fragments also produced faster kinetics (5 vs. 45-min saturation level) than Mab: 21-25% (Mab) versus 72-83% (scFv and Fab). Analytical sensitivities of the 5-min assay were 0.09 mIU/L TSH (Fab), 0.16 mIU/L TSH (scFv), and 0.26 mIU/L TSH (Mab). Between-run variabilities were 4.2-7.9% (Fab), 4.6-17.7% (scFv), and 5.5-7.2% (Mab). The assays correlated well with the AutoDELFIA hTSH (human TSH) Ultra assay (r=0.99, n=109). Fab was good in all aspects of immunoassay--capacity, kinetics, sensitivity, and analytical performance. As a homogeneous, stable, and small-sized binding molecule with optimized surface-coating properties as well as reduced risk for interference by heterophilic antibodies, Fab fragment is a promising and realistic immunoreagent for the future.

Oligovalent Fab Display on M13 Phage Improved by Directed Evolution

Efficient display of antibody on filamentous phage M13 coat is crucial for successful biopanning selections. We applied a directed evolution strategy to improve the oligovalent display of a poorly behaving Fab fragment fused to phage gene-3 for minor coat protein (g3p). The Fab displaying clones were enriched from a randomly mutated Fab gene library with polyclonal anti-mouse IgG antibodies. Contribution of each mutation to the improved phenotype of one selected mutant was studied. It was found out that two point mutations had significant contribution to the display efficiency of Fab clones superinfected with hyperphage. The most dramatic effect was connected to a start codon mutation, from AUG to GUG, of the PelB signal sequence preceding the heavy chain. The clone carrying this mutation, FabMGUG, displayed Fab 19-fold better and yielded twofold higher phage titers than the original Fab.

Quantity of the dinoflagellate sxtA4 gene and cell density correlates with paralytic shellfish toxin production in Alexandrium ostenfeldii blooms

Many marine dinoflagellates, including several species of the genus Alexandrium, Gymnodinium catenatum, and Pyrodinium bahamense are known for their capability to produce paralytic shellfish toxins (PST), which can cause severe, most often food-related poisoning. The recent discovery of the first PST biosynthesis genes has laid the foundation for the development of molecular detection methods for monitoring and study of PST-producing dinoflagellates. In this study, a probe-based qPCR method for the detection and quantification of the sxtA4 gene present in Alexandrium spp. and Gymnodinium catenatum was designed. The focus was on Alexandrium ostenfeldii, a species which recurrently forms dense toxic blooms in areas within the Baltic Sea. A consistent, positive correlation between the presence of sxtA4 and PST biosynthesis was observed, and the species was found to maintain PST production with an average of 6 genomic copies of sxtA4. In August 2014, A. ostenfeldii populations were studied for cell densities, PST production, as well as sxtA4 and species-specific LSU copy numbers in Föglö, Åland, Finland, where an exceptionally dense bloom, consisting of 6.3×106cellsL-1, was observed. Cell concentrations, and copy numbers of both of the target genes were positively correlated with total STX, GTX2, and GTX3 concentrations in the environment, the cell density predicting toxin concentrations with the best accuracy (Spearmans ρ=0.93, p<0.01). The results indicated that all A. ostenfeldii cells in the blooms harbored the genetic capability of PST production, making the detection of sxtA4 a good indicator of toxicity.