Michal E. Pawlowski

Chromatography paper as a low-cost medium for accurate spectrophotometric assessment of blood hemoglobin concentration

Anemia affects a quarter of the worlds population, and a lack of appropriate diagnostic tools often prevents treatment in low-resource settings. Though the HemoCue 201+ is an appropriate device for diagnosing anemia in low-resource settings, the high cost of disposables (

Miniature, minimally invasive, tunable endoscope for investigation of the middle ear.

0.99 per test in Malawi) limits its availability. We investigated using spectrophotometric measurement of blood spotted on chromatography paper as a low-cost (<

All-plastic, miniature, digital fluorescence microscope for three part white blood cell differential measurements at the point of care.

0.01 per test) alternative to HemoCue cuvettes. For this evaluation, donor blood was diluted with plasma to simulate anemia, a micropipette spotted blood on paper, and a bench-top spectrophotometer validated the approach before the development of a low-cost reader. We optimized impregnating paper with chemicals to lyse red blood cells, paper type, drying time, wavelengths measured, and sensitivity to variations in volume of blood, and we validated our approach using patient samples. Lysing the blood cells with sodium deoxycholate dried in Whatman Chr4 chromatography paper gave repeatable results, and the absorbance difference between 528 nm and 656 nm was stable over time in measurements taken up to 10 min after sample preparation. The method was insensitive to the amount of blood spotted on the paper over the range of 5 μL to 25 μL. We created a low-cost, handheld reader to measure the transmission of paper cuvettes at these optimal wavelengths. Training and validating our method with patient samples on both the spectrometer and the handheld reader showed that both devices are accurate to within 2 g dL(-1) of the HemoCue device for 98% and 95% of samples, respectively.

Kagome fiber based ultrafast laser microsurgery probe delivering micro-Joule pulse energies

We demonstrate a miniature, tunable, minimally invasive endoscope for diagnosis of the auditory system. The probe is designed to sharply image anatomical details of the middle ear without the need for physically adjusting the position of the distal end of the endoscope. This is achieved through the addition of an electrowetted, tunable, electronically-controlled lens to the optical train. Morphological imaging is enabled by scanning light emanating from an optical coherence tomography system. System performance was demonstrated by imaging part of the ossicular chain and wall of the middle ear cavity of a normal mouse. During the experiment, we electronically moved the plane of best focus from the incudo-stapedial joint to the stapedial artery. Repositioning the object plane allowed us to image anatomical details of the middle ear beyond the depth of field of a static optical system. We also demonstrated for the first time to our best knowledge, that an optical system with an electrowetted, tunable lens may be successfully employed to measure sound-induced vibrations within the auditory system by measuring the vibratory amplitude of the tympanic membrane in a normal mouse in response to pure tone stimuli.

Design and fabrication of a miniature objective consisting of high refractive index zinc sulfide lenses for laser surgery

Three-part differential white blood cell counts are used for disease diagnosis and monitoring at the point-of-care. A low-cost, miniature achromatic microscope was fabricated for identification of lymphocytes, monocytes, and granulocytes in samples of whole blood stained with acridine orange. The microscope was manufactured using rapid prototyping techniques of diamond turning and 3D printing and is intended for use at the point-of-care in low-resource settings. The custom-designed microscope requires no manual adjustment between samples and was successfully able to classify three white blood cell types (lymphocytes, granulocytes, and monocytes) using samples of peripheral whole blood stained with acridine orange.

All-plastic miniature fluorescence microscope for point-of-care readout of bead-based bioassays

We present the development of a 5 mm, piezo-actuated, ultrafast laser scalpel for fast tissue microsurgery. Delivery of micro-Joules level energies to the tissue was made possible by a large, 31 μm, air-cored inhibited-coupling Kagome fiber. We overcome the fibers low NA by using lenses made of high refractive index ZnS, which produced an optimal focusing condition with 0.23 NA objective. The optical design achieved a focused laser spot size of 4.5 μm diameter covering a 75 × 75 μm2 scan area in a miniaturized setting. The probe could deliver the maximum available laser power, achieving an average fluence of 7.8 J/cm2 on the tissue surface at 62% transmission efficiency. Such fluences could produce uninterrupted, 40 μm deep cuts at translational speeds of up to 5 mm/s along the tissue. We predicted that the best combination of speed and coverage exists at 8 mm/s for our conditions. The onset of nonlinear absorption in ZnS, however, limited the probes energy delivery capabilities to 1.4 μJ for linear operation at 1.5 picosecond pulse-widths of our fiber laser. Alternatives like broadband CaF2 crystals should mitigate such nonlinear limiting behavior. Improved opto-mechanical design and appropriate material selection should allow substantially higher fluence delivery and propel such Kagome fiber-based scalpels towards clinical translation.

Low-cost disposable cartridge for performing a white blood cell count and partial differential at the point-of-care

Abstract. A miniature laser ablation probe relying on an optical fiber to deliver light requires a high coupling efficiency objective with sufficient magnification in order to provide adequate power and field for surgery. A diffraction-limited optical design is presented that utilizes high refractive index zinc sulfide to meet specifications while reducing the miniature objective down to two lenses. The design has a hypercentric conjugate plane on the fiber side and is telecentric on the tissue end. Two versions of the objective were built on a diamond lathe—a traditional cylindrical design and a custom-tapered mount. Both received an antireflective coating. The objectives performed as designed in terms of observable resolution and field of view as measured by imaging a 1951 USAF resolution target. The slanted edge technique was used to find Strehl ratios of 0.75 and 0.78, respectively, indicating nearly diffraction-limited performance. Finally, preliminary ablation experiments indicated threshold fluence of gold film was comparable to similar reported probes.

Design and Fabrication of Miniature Objective Lens for Laser Ablation Surgery Probe

Abstract. A number of new platforms have been developed for multiplexed bioassays that rely on imaging targeted fluorescent beads labeled with different fluorescent dyes. We developed a compact, low-cost three-dimensional printed fluorescence microscope that can be used as a detector for mutiplexed, bead-based assays to support point-of-care applications. Images obtained with the microscope were analyzed to differentiate multiple analytes in a single sample with a comparable limit of detection to commercially available macroscopic assay platforms.

Design and Fabrication of Miniature Objective Lens for Three Part White Blood Cell Differential Measurements

Being able to perform a white blood cell (WBC) count and differential is a crucial laboratory test for basic diagnostic practices. In this paper, we demonstrate proof of concept results for a disposable cartridge that could be used to perform a WBC count and 3-part differential at the point-of-care. The cartridge is composed of a glass slide, a layer of transfer tape, and a glass cover slip and incorporates acridine orange for cell staining and sub-type differentiation; the stained blood is then imaged, and image analysis techniques return a WBC count and 3-part differential. The cartridge was tested on a laboratory microscope with 3 normal samples, and had promising results with 85.7% of images resulting in a WBC count with ±15% of the true value. Further, the 3-part differential concentrations determined using the disposable cartridge had strong correlations with the true concentrations (R2 values of 0.9986, 0.9421, and 0.6942 for granulocytes, lymphocytes, and monocytes, respectively). Preliminary designs for a low-cost, portable microscope have been created and are currently being prototyped.

Compact snapshot image mapping spectrometer (SNAP-IMS) for hyperspectral data cube acquisition using unmanned aerial vehicle (UAV) environmental imaging

A prototype miniature objective was designed and fabricated for use in a laser ablation probe utilizing a piezo scanned fiber to rapidly produce a large cutting region, improving functionality and speed for laser ablation surgery.