Michelle Dickinson

Skeletal phenotype of the leptin receptor-deficient db/db mouse.

Leptin, a major hormonal product of the adipocyte, regulates appetite and reproductive function through its hypothalamic receptors. The leptin receptor is present in osteoblasts and chondrocytes, and previously we have shown leptin to be an anabolic bone factor in vitro, stimulating osteoblast proliferation and inhibiting osteoclastogenesis. Leptin increases bone mass and reduces bone fragility when administered peripherally but also can indirectly reduce bone mass when administered into the central nervous system. However, data from animal models deficient in either leptin (ob/ob) or its receptor (db/db) remain contradictory. We compared the bone phenotype of leptin receptor–deficient (db/db) and wild‐type mice using micro–computed tomographic (µCT) analysis of the proximal tibias and vertebrae. In the tibia, db/db mice had reduced percent trabecular bone volume (13.0 ± 1.62% in wild‐type versus 6.01 ± 0.601% in db/db mice, p = .002) and cortical bone volume (411 ± 21.5 µm3 versus 316 ± 3.53 µm3, p = .0014), trabecular thickness (48.4 ± 001.07 µm versus 45.1 ± 0.929 µm, p = .041) and trabecular number (2.68 ± 0.319 mm−1 versus 1.34 ± 0.148 mm−1, p = .0034). In the fifth lumbar vertebral body, the trabecular thickness and cortical thickness were decreased in the db/db versus wild‐type mice (0.053 ± 0.0011 mm versus 0.047 ± 0.0013 mm, p = .0002 and 0.062 ± 0.00054 mm versus 0.056 ± 0.0009 mm, p = .0001), respectively, whereas the trabecular and cortical percent bone volume and trabecular number did not reach significance. The total (endosteal and periosteal) cortical perimeter (12.2 ± 0.19 mm versus 13.2 ± 0.30 mm, p = .01) was increased. The serum osteocalcin levels were reduced in the db/db mice, suggesting that bone formation rates are decreased. The material properties of db/db femurs were determined by three‐point bending and nanoindentation, showing decreased bone strength (13.3 ± 0.280 N versus 7.99 ± 0.984 N, p = .0074) and material stiffness (28.5 ± 0.280 GPa versus 25.8 ± 0.281 GPa, p < .0001). These results demonstrate that bone mass and strength are reduced in the absence of leptin signaling, indicating that leptin acts in vivo as an anabolic bone factor. This concurs with results of in vitro studies and of peripheral leptin administration in vivo and suggests that leptins direct effects on bone cells are likely to override its actions via the central nervous system.

Patterning and detailed study of human hNT astrocytes on parylene-C/silicon dioxide substrates to the single cell level

It is estimated that the adult human brain contains 100 billion neurons with 5-10 times as many astrocytes. Although it has been generally considered that the astrocyte is a simple supportive cell to the neuron, recent research has revealed new functionality of the astrocyte in the form of information transfer to neurons of the brain. In our previous work we developed a protocol to pattern the hNT neuron (derived from the human teratocarcinoma cell line (hNT)) on parylene-C/SiO(2) substrates. In this work, we report how we have managed to pattern hNT astrocytes, on parylene-C/SiO(2) substrates to single cell resolution. This article disseminates the nanofabrication and cell culturing steps necessary for the patterning of such cells. In addition, it reports the necessary strip lengths and strip width dimensions of parylene-C that encourage high degrees of cellular coverage and single cell isolation for this cell type. The significance in patterning the hNT astrocyte on silicon chip is that it will help enable single cell and network studies into the undiscovered functionality of this interesting cell, thus, contributing to closer pathological studies of the human brain.

Mechanical properties of porcine femoral cortical bone measured by nanoindentation

This study uses a nanoindentation technique to examine variations in the local mechanical properties of porcine femoral cortical bone under hydrated conditions. Bone specimens from three age groups (6, 12 and 42 months), representing developing bone, ranging from young to mature animals, were tested on the longitudinal and transverse cross-sectional surfaces. Elastic modulus and hardness of individual lamellae within bones microstructure: laminar bone, interstitial bone, and osteons, were measured. Both the elastic modulus and hardness increased with age. However, the magnitudes of these increases were different for each microstructural component. The longitudinal moduli were higher than the transverse moduli. Dehydrated samples were also tested to allow a comparison with hydrated samples and these resulted in higher moduli and hardness than the hydrated samples. Again, the degree of variation was different for each microstructural component. These results indicate that the developmental changes in bone have different rates of mechanical change within each microstructural component.

Extended treatment with selective phosphatidylinositol 3-kinase and mTOR inhibitors has effects on metabolism, growth, behaviour and bone strength.

The class I phosphatidylinositol 3‐kinases (PtdIns3Ks) mediate the effects of many hormones and growth factors on a wide range of cellular processes, and activating mutations or gene amplifications of class I PtdIns3K isoforms are known to contribute to oncogenic processes in a range of tumours. Consequently, a number of small‐molecule PtdIns3K inhibitors are under development and in clinical trial. The central signalling role of PtdIns3K in many cellular processes suggests there will be on‐target side effects associated with the use of these agents. To gain insights into what these might be we investigated the effect of extended daily dosing of eight small‐molecule inhibitors of class Ia PtdIns3Ks. Animals were characterized in metabolic cages to analyse food intake, oxygen consumption and movement. Insulin tolerance and body composition were analysed at the end of the experiment, the latter using EchoMRI. Bone volume and strength was assessed by micro‐CT and three‐point bending, respectively. Surprisingly, after sustained dosing with pan‐PtdIns3K inhibitors and selective inhibitors of the p110α isoform there was a resolution of the impairments in insulin tolerance observed in drug‐naïve animals treated with the same drugs. However, pan‐PtdIns3K inhibitors and selective inhibitors of the p110α have deleterious effects on animal growth, animal behaviour and bone volume and strength. Together, these findings identify a range of on target effects of PtdIns3K inhibitors and suggest use of these drugs in humans may have important adverse effects on metabolism, body composition, behaviour and skeletal health.

Probing more than the surface

Nanoindentation is a powerful method for quantitative mechanical property determination ideally suited for measuring small scale and thin film materials. The unique and complimentary capabilities of atomic force microscopy (AFM) and nanoindentation in combination have enabled the development of nanomaterials research to be brought to the forefront in recent years. The more recent advancement of in-situ scanning probe microscopy (SPM) imaging, where the nanoindenter tip is simultaneously used as a 3D imaging device combined with nanoindentation has enabled a new wave of novel materials research to progress.

Reduced Bone Density and Cortical Bone Indices in Female Adiponectin-Knockout Mice.

A positive association between fat and bone mass is maintained through a network of signaling molecules. Clinical studies found that the circulating levels of adiponectin, a peptide secreted from adipocytes, are inversely related to visceral fat mass and bone mineral density, and it has been suggested that adiponectin contributes to the coupling between fat and bone. Our study tested the hypothesis that adiponectin affects bone tissue by comparing the bone phenotype of wild-type and adiponectin-knockout (APN-KO) female mice between the ages of 8-37 weeks. Using a longitudinal study design, we determined body composition and bone density using dual energy x-ray absorptiometry. In parallel, groups of animals were killed at different ages and bone properties were analyzed by microcomputed tomography, dynamic histomorphometry, 3-point bending test, nanoindentation, and computational modelling. APN-KO mice had reduced body fat and decreased whole-skeleton bone mineral density. Microcomputed tomography analysis identified reduced cortical area fraction and average cortical thickness in APN-KO mice in all the age groups and reduced trabecular bone volume fraction only in young APN-KO mice. There were no major differences in bone strength and material properties between the 2 groups. Taken together, our results demonstrate a positive effect of adiponectin on bone geometry and density in our mouse model. Assuming adiponectin has similar effects in humans, the low circulating levels of adiponectin associated with increased fat mass are unlikely to contribute to the parallel increase in bone mass. Therefore, adiponectin does not appear to play a role in the coupling between fat and bone tissue.

Face dependence of mechanical properties of a single ZnO nano/microrod

The mechanical properties of the single ZnO rod were studied using nanoindentation. The hardness and Young’s modulus of the polar (0001) and nonpolar (011¯0) faces were tested and the results demonstrate a face dependence variation in both properties. The mechanical behavior of the ZnO nano/microrod is discussed in conjunction with its morphology, structure, and defect effects.

Use of versican variant V3 and versican antisense expression to engineer cultured human skin containing increased content of insoluble elastin

Skin substitutes for repair of dermal wounds are deficient in functional elastic fibres. We report that the content of insoluble elastin in the dermis of cultured human skin can be increased though the use of two approaches that enhance elastogenesis by dermal fibroblasts, forced expression of versican variant V3, which lacks glycosaminoglycan (GAG) chains, and forced expression of versican antisense to decrease levels of versican variant V1 with GAG chains. Human dermal fibroblasts transduced with V3 or anti‐versican were cultured under standard conditions over a period of 4 weeks to produce dermal sheets, with growth enhanced though multiple seedings for the first 3 weeks. Human keratinocytes, cultured in supplemented media, were added to the 4‐week dermal sheets and the skin layer cultured for a further week. At 5 weeks, keratinocytes were multilayered and differentiated, with desmosome junctions thoughout and keratin deposits in the upper squamous layers. The dermal layer was composed of layered fibroblasts surrounded by extracellular matrix of collagen bundles and, in control cultures, small scattered elastin deposits. Forced expression of V3 and versican antisense slowed growth, decreased versican V1 expression, increased tropoelastin expression and/or the deposition of large aggregates of insoluble elastin in the dermal layer, and increased tissue stiffness, as measured by nano‐indentation. Skin sheets were also cultured on Endoform Dermal Template™, the biodegradable wound dressing made from the lamina propria of sheep foregut. Skin structure and the enhanced deposition of elastin by forced expression of V3 and anti‐versican were preserved on this supportive substrate. Copyright

Computer modelling integrated with micro-CT and material testing provides additional insight to evaluate bone treatments

The primary aim of this study was to evaluate the influence of a whey protein diet on computationally predicted mechanical strength of murine bones in both trabecular and cortical regions of the femur. There was no significant influence on mechanical strength in cortical bone observed with increasing whey protein treatment, consistent with cortical tissue mineral density (TMD) and bone volume changes observed. Trabecular bone showed a significant decline in strength with increasing whey protein treatment when nanoindentation derived Young׳s moduli were used in the model. When microindentation, micro-CT phantom density or normalised Young׳s moduli were included in the model a non-significant decline in strength was exhibited. These results for trabecular bone were consistent with both trabecular bone mineral density (BMD) and micro-CT indices obtained independently. The secondary aim of this study was to characterise the influence of different sources of Young׳s moduli on computational prediction. This study aimed to quantify the predicted mechanical strength in 3D from these sources and evaluate if trends and conclusions remained consistent. For cortical bone, predicted mechanical strength behaviour was consistent across all sources of Young׳s moduli. There was no difference in treatment trend observed when Young׳s moduli were normalised. In contrast, trabecular strength due to whey protein treatment significantly reduced when material properties from nanoindentation were introduced. Other material property sources were not significant but emphasised the strength trend over normalised material properties. This shows strength at the trabecular level was attributed to both changes in bone architecture and material properties.

CHARACTERIZATION OF E. CHLOROTICUS SEA URCHIN TOOTH USING NANOINDENTATION AND SEM

The teeth of Evenchinus chloroticus are not only vital tools for their survival but also have fascinating structures in the world of science and engineering. Despite being compositionally similar to rocks, these teeth are still able to scrape along the hard surfaces of rocks for food, while having the unique ability to self-sharpen. Yet these abilities arise from the properties of the teeth, which are in turn dependent on their design and composition. Nanoindentation was used in this study to characterise the hardness across the sea urchin tooth in detail. It focuses on the chewing tip since the main grinding function is performed by this region. In addition, SEM and EDS were used to explore any correlations between the mechanical properties of the tooth and its composition. It was found that there were two main relatively hard regions (stone part in the centre of the top flange part and another similar region in the centre of the bottom keel zone). These regions are similar in structure, consisting of thin needles and matrix and have a higher magnesium content compared to other areas of the tooth, which is attributed to the greater proportion of matrix present. Furthermore, the regions below the stone part and at the start of the keel zone appear to be weaker, which might be due to the significant amount of pores in these areas. The sharp tip is maintained by shedding of the primary plates surrounding the stone part and the keel fibres, leaving only the stone part at the chewing tip.