Michelle Maclean

Inactivation of Bacterial Pathogens following Exposure to Light from a 405-Nanometer Light-Emitting Diode Array

ABSTRACT This study demonstrates the susceptibility of a variety of medically important bacteria to inactivation by 405-nm light from an array of light-emitting diodes (LEDs), without the application of exogenous photosensitizer molecules. Selected bacterial pathogens, all commonly associated with hospital-acquired infections, were exposed to the 405-nm LED array, and the results show that both gram-positive and gram-negative species were successfully inactivated, with the general trend showing gram-positive species to be more susceptible than gram-negative bacteria. Detailed investigation of the bactericidal effect of the blue-light treatment on Staphylococcus aureus suspensions, for a range of different population densities, demonstrated that 405-nm LED array illumination can cause complete inactivation at high population densities: inactivation levels corresponding to a 9-log10 reduction were achieved. The results, which show the inactivation of a wide range of medically important bacteria including methicillin-resistant Staphylococcus aureus, demonstrate that, with further development, narrow-spectrum 405-nm visible-light illumination from an LED source has the potential to provide a novel decontamination method with a wide range of potential applications.

The role of oxygen in the visible-light inactivation of Staphylococcus aureus

Exposure to visible-light causes the photoinactivation of certain bacteria by a process that is believed to involve the photo-stimulation of endogenous intracellular porphyrins. Studies with some bacterial species have reported that this process is oxygen-dependent. This study examines the role of oxygen in the visible-light inactivation of Staphylococcus aureus. Suspensions of S. aureus were exposed to broadband visible-light under both oxygen depletion and oxygen enhancement conditions to determine whether these environmental modifications had any effect on the staphylococcal inactivation rate. Oxygen enhancement was achieved by flowing oxygen over the surface of the bacterial sample during light inactivation and results demonstrated an increased rate of staphylococcal inactivation, with approximately 3.5 times less specific dose being required for inactivation compared to that for a non-enhanced control. Oxygen depletion, achieved through the addition of oxygen scavengers to the S. aureus suspension, further demonstrated the essential role of oxygen in the light inactivation process, with significantly reduced staphylococcal inactivation being observed in the presence of oxygen scavengers. The results of the present study demonstrate that the presence of oxygen is important for the visible-light inactivation of S. aureus, thus providing supporting evidence that the nature of the mechanism occurring within the visible-light-exposed staphylococci is photodynamic inactivation through the photo-excitation of intracellular porphyrins.

High-intensity narrow-spectrum light inactivation and wavelength sensitivity of Staphylococcus aureus

This study was conducted to investigate the bactericidal effects of visible light on methicillin-sensitive and methicillin-resistant Staphylococcus aureus (MRSA), and subsequently identify the wavelength sensitivity of S. aureus, in order to establish the wavelengths inducing maximum inactivation. Staphylococcus aureus, including MRSA strains, were shown to be inactivated by exposure to high-intensity visible light, and, more specifically, through a series of studies using a xenon broadband white-light source in conjunction with a selection of optical filters, it was found that inactivation of S. aureus occurs upon exposure to blue light of wavelengths between 400 and 420 nm, with maximum inactivation occurring at 405+/-5 nm. This visible-light inactivation was achieved without the addition of exogenous photosensitisers. The significant safety benefit of these blue-light wavelengths over UV light, in addition to their ability to inactivate medically important microorganisms such as MRSA, emphasises the potential of exploiting these non-UV wavelengths for disinfection applications.

Bactericidal Effects of 405 nm Light Exposure Demonstrated by Inactivation of Escherichia, Salmonella, Shigella, Listeria, and Mycobacterium Species in Liquid Suspensions and on Exposed Surfaces

The bactericidal effect of 405 nm light was investigated on taxonomically diverse bacterial pathogens from the genera Salmonella, Shigella, Escherichia, Listeria, and Mycobacterium. High-intensity 405 nm light, generated from an array of 405-nm light-emitting diodes (LEDs), was used to inactivate bacteria in liquid suspension and on exposed surfaces. L. monocytogenes was most readily inactivated in suspension, whereas S. enterica was most resistant. In surface exposure tests, L. monocytogenes was more susceptible than Gram-negative enteric bacteria to 405 nm light when exposed on an agar surface but interestingly less susceptible than S. enterica after drying onto PVC and acrylic surfaces. The study findings, that 405 nm light inactivates diverse types of bacteria in liquids and on surfaces, in addition to the safety advantages of this visible (non-UV wavelength) light, indicate the potential of this technology for a range of decontamination applications.

Sporicidal effects of high-intensity 405 nm visible light on endospore-forming bacteria.

Resistance of bacterial endospores to treatments, including biocides, heat and radiation is a persistent problem. This study investigates the susceptibility of Bacillus and Clostridium endospores to 405 nm visible light, wavelengths which have been shown to induce inactivation of vegetative bacterial cells. Suspensions of B. cereus endospores were exposed to high‐intensity 405 nm light generated from a light‐emitting diode array and results demonstrate the induction of a sporicidal effect. Up to a 4‐log10 CFU mL−1 reduction in spore population was achieved after exposure to a dose of 1.73 kJ cm−2. Similar inactivation kinetics were demonstrated with B. subtilis, B. megaterium and C. difficile endospores. The doses required for inactivation of endospores were significantly higher than those required for inactivation of B. cereus and C. difficile vegetative cells, where ca 4‐log10 CFU mL−1 reductions were achieved after exposure to doses of 108 and 48 J cm−2, respectively. The significant increase in dose required for inactivation of endospores compared with vegetative cells is unsurprising due to the notorious resilience of these microbial structures. However, the demonstration that visible light of 405 nm can induce a bactericidal effect against endospores is significant, and could have potential for incorporation into decontamination methods for the removal of bacterial contamination including endospores.

405 nm light technology for the inactivation of pathogens and its potential role for environmental disinfection and infection control

BACKGROUND Although the germicidal properties of ultraviolet (UV) light have long been known, it is only comparatively recently that the antimicrobial properties of visible violet-blue 405 nm light have been discovered and used for environmental disinfection and infection control applications. AIM To review the antimicrobial properties of 405 nm light and to describe its application as an environmental decontamination technology with particular reference to disinfection of the hospital environment. METHODS Extensive literature searches for relevant scientific papers and reports. FINDINGS A large body of scientific evidence is now available that provides underpinning knowledge of the 405 nm light-induced photodynamic inactivation process involved in the destruction of a wide range of prokaryotic and eukaryotic microbial species, including resistant forms such as bacterial and fungal spores. For practical application, a high-intensity narrow-spectrum light environmental disinfection system (HINS-light EDS) has been developed and tested in hospital isolation rooms. The trial results have demonstrated that this 405 nm light system can provide continuous disinfection of air and exposed surfaces in occupied areas of the hospital, thereby substantially enhancing standard cleaning and infection control procedures. CONCLUSION Violet-blue light, particularly 405 nm light, has significant antimicrobial properties against a wide range of bacterial and fungal pathogens and, although germicidal efficacy is lower than UV light, this limitation is offset by its facility for safe, continuous use in occupied environments. Promising results on disinfection efficacy have been obtained in hospital trials but the full impact of this technology on reduction of healthcare-associated infection has yet to be determined.

High‐Intensity 405 nm Light Inactivation of Listeria monocytogenes

The antimicrobial properties of light is an area of increasing interest. This study investigates the sensitivity of the significant foodborne pathogen Listeria monocytogenes to selected wavelengths of visible light. Results demonstrate that exposure to wavelength region 400–450 nm, at sufficiently high dose levels (750 J cm−2), induced complete inactivation of a 5 log10 population. Exposure to wavelengths longer than 450 nm did not cause significant inactivation. Analysis of 10 nm bandwidths between 400 and 450 nm confirmed 405(±5) nm light to be most effective for the inactivation of L. monocytogenes, with a lesser bactericidal effect also evident at other wavelengths between 400 and 440 nm. Identification of the optimum bactericidal wavelength enabled the comparison of inactivation using 405(±5) nm filtered light and a 405 nm light‐emitting diode (LED) array (14 nm FWHM). Results demonstrate similar inactivation kinetics, indicating that the applied dose of 405 nm light is the important factor. Use of the 405 nm LED array for the inactivation of L. monocytogenes and other Listeria species resulted in similar kinetics, with up to 5 log10 reductions with a dose of 185 J cm−2. Comparative data for the 405 nm light inactivation of L. monocytogenes and other important foodborne pathogens, Escherichia coli, Salmonella enteritidis and Shigella sonnei, are also presented, with L. monocytogenes showing higher susceptibility to inactivation through 405 nm light exposure.

Inactivation of Campylobacter jejuni by Exposure to High-Intensity 405-nm Visible Light

Although considerable research has been carried out on a range of environmental factors that impact on the survival of Campylobacter jejuni, there is limited information on the effects of violet/blue light on this pathogen. This investigation was carried out to determine the effects of high-intensity 405-nm light on C. jejuni and to compare this with the effects on two other important Gram-negative enteric pathogens, Salmonella enteritidis and Escherichia coli O157:H7. High-intensity 405-nm light generated from an array of 405-nm light-emitting diodes was used to inactivate the test bacteria. The results demonstrated that while all three tested species were susceptible to 405-nm light inactivation, C. jejuni was by far the most sensitive organism, requiring a total dose of 18 J cm⁻² of 405-nm light to achieve a 5-log₁₀ reduction. This study has established that C. jejuni is particularly susceptible to violet/blue light at a wavelength of 405 nm. This finding, coupled with the safety-in-use advantages of this visible (non-ultraviolet wavelength) light, suggests that high-intensity 405-nm light may have applications for control of C. jejuni contamination levels in situations where this type of illumination can be effectively applied.

Clinical studies of the High-Intensity Narrow-Spectrum light Environmental Decontamination System (HINS-light EDS), for continuous disinfection in the burn unit inpatient and outpatient settings §

Infections are the leading cause of morbidity and mortality in burn patients and prevention of contamination from exogenous sources including the hospital environment is becoming increasingly emphasised. The High-Intensity Narrow-Spectrum light Environmental Decontamination System (HINS-light EDS) is bactericidal yet safe for humans, allowing continuous disinfection of the environment surrounding burn patients. Environmental samples were collected from inpatient isolation rooms and the outpatient clinic in the burn unit, and comparisons were then made between the bacterial contamination levels observed with and without use of the HINS-light EDS. Over 1000 samples were taken. Inpatient studies, with sampling carried out at 0800 h, demonstrated a significant reduction in the average number of bacterial colonies following HINS-light EDS use of between 27% and 75%, (p<0.05). There was more variation when samples were taken at times of increased activity in the room. Outpatient studies during clinics demonstrated a 61% efficacy in the reduction of bacterial contamination on surfaces throughout the room during the course of a clinic (p=0.02). The results demonstrate that use of the HINS-light EDS allows efficacious bacterial reductions over and above that achieved by standard cleaning and infection control measures in both inpatient and outpatient settings in the burn unit.

Photoinactivation of Bacteria Attached to Glass and Acrylic Surfaces by 405 nm Light: Potential Application for Biofilm Decontamination

Attachment of bacteria to surfaces and subsequent biofilm formation remains a major cause of cross‐contamination capable of inducing both food‐related illness and nosocomial infections. Resistance to many current disinfection technologies means facilitating their removal is often difficult. The aim of this study was to investigate the efficacy of 405 nm light for inactivation of bacterial attached as biofilms to glass and acrylic. Escherichia coli biofilms (103–108 CFU mL−1) were generated on glass and acrylic surfaces and exposed for increasing times to 405 nm light (5–60 min) at ca 140 mW cm−2. Successful inactivation of biofilms has been demonstrated, with results highlighting complete/near‐complete inactivation (up to 5 log10 reduction on acrylic and 7 log10 on glass). Results also highlight that inactivation of bacterial biofilms could be achieved whether the biofilm was on the upper “directly exposed” surface or “indirectly exposed” underside surface. Statistically significant inactivation was also shown with a range of other microorganisms associated with biofilm formation (Staphylococcus aureus, Pseudomonas aeruginosa and Listeria monocytogenes). Results from this study have demonstrated significant inactivation of bacteria ranging from monolayers to densely populated biofilms using 405 nm light, highlighting that with further development this technology may have potential applications for biofilm decontamination in food and clinical settings.