Milagros Mezcua

Removal of pharmaceuticals and kinetics of mineralization by O3/H2O2 in a biotreated municipal wastewater

The ozonation of an effluent from the secondary clarifier of two Municipal Wastewater Treatment Plants was performed by using alkaline ozone and a combination of ozone and hydrogen peroxide. Alkaline ozonation achieved only a moderate degree of mineralization, essentially concentrated during the first few minutes; but the addition of hydrogen peroxide eventually led to a complete mineralization. The evolution of total organic carbon (TOC) as a measure of the extent of mineralization and the concentration of dissolved ozone were analyzed and linked in a kinetic model whose parameter represented the product of the exposure to hydroxyl radicals and the kinetic constant of indirect ozonation. This rate parameter yielded the highest values during the first part of O(3)/H(2)O(2) runs. The kinetic constant for the decomposition of ozone at the end of the run was also measured and computed for the non-oxidizable water matrix and yielded essentially the same values regardless of whether or not hydrogen peroxide was used. A group of 33 organic compounds, mainly pharmaceuticals and some relevant metabolites present in the wastewater effluents, were evaluated before and after the ozonation process using a liquid chromatography-hybrid triple-quadrupole linear ion trap system (LC-QqLIT-MS). The results demonstrate that the ozonation degrades these compounds with efficiencies of over 99% in most cases, even under low mineralization conditions in alkaline ozonation.

Photodegradation study of three dipyrone metabolites in various water systems : Identification and toxicity of their photodegradation products

The photochemical behaviour of three relevant metabolites of the analgesic and antipyretic drug dipyrone, 4-methylaminoantipyrine (4-MAA), 4-formylaminoantipyrine (4-FAA) and 4-acetylaminoantipyrine (4-AAA), was evaluated under simulated solar irradiation (Suntest system). For 4-MAA, different aqueous solutions (synthetic seawater, freshwater and Milli-Q water) as well as different operational conditions were compared. According to the experimental results, 4-MAA resulted as being an easily degraded molecule by direct photolysis, with half-life times (t1/2) ranging from 0.12 to 0.58 h, depending on the irradiation conditions. Faster degradation was observed in synthetic waters, suggesting that the photolysis was influenced by the salt composition of the waters. However, no effect on the degradation rate was observed by the presence of natural photosensitizers (dissolved organic matter, nitrate ions). 4-FAA and 4-AAA showed slower photodegradation kinetics, with t1/2 of 24 and 28 h, respectively. A study of photoproduct identification was carried out by gas chromatography-mass spectrometry (GC-MS) and liquid chromatography-time-of-flight mass spectrometry (LC-TOF-MS) (ESI positive mode), which allowed us to propose a tentative photodegradation pathway for 4-MAA and the identification of persistent by-products in all the cases. Finally, the application of an acute toxicity test (Daphnia magna) showed an increase in toxicity during the photolytic process, a consequence of the formation of toxic photoproducts.

Simultaneous analysis of neutral and acidic pharmaceuticals as well as related compounds by gas chromatography-tandem mass spectrometry in wastewater.

This work presents a new multi-residue analytical method based on solid phase extraction (SPE) with Oasis HLB sorbent, followed by gas chromatography tandem mass spectrometry (GC-MS/MS) for the simultaneous determination of a group of 10 acidic and neutral pharmaceuticals and related compounds in wastewaters. The typical derivation step was avoided, allowing the determination of acidic and neutral pollutants in a single analysis as well as providing a fast and easy method suitable for routine monitoring. Target pollutants include: anti-inflammatory drugs (ibuprofen, acetaminophen and diclofenac); an antiepileptic agent (carbamazepine); stimulants (caffeine and nicotine); an antiseptic (triclosan); a plasticizer (bisphenol A) and two of their more relevant metabolites (2,8-dichlorodibenzo-p-dioxin and 1,7-dimethylxanthine). Recoveries between 66 and 112% were achieved for all the target compounds (except for 2,8-dichlorodibenzo-p-dioxin). Good linearity was observed within the studied ranges (R(2)>0.993). Acceptable intra and inter-day precision was obtained, with relative standard deviation between 2 and 18%. The application of the optimized MS/MS mode allowed method detection limits in the range of 0.2-16ng/L, with the exception of ibuprofen (120ng/L). Finally, the methodology was successfully applied to the analysis of hospital effluent samples. All target analytes were detected at concentrations between 1ng/L and 83215mug/L. Even in the absence of derivatization, all the analytes showed good peak shape, except acetaminophen, which exhibited peak tailing. However, the method proved to be repetitive and reproducible, and the peak shape did not represent a problem for the reliable quantification of this compound. For most of the analytes studied, the detection limits achieved compare well against values reported in previously published methods.

Toxicity of Single and Mixed Contaminants in Seawater Measured with Acute Toxicity Bioassays

Different types of organic pollutants commonly detected in seawater have been evaluated by acute toxicity bioassays. Vibrio fischeri, Daphnia magna, and Selenastrum capricornotum were selected to test toxic effects of individual compounds and mixtures of these compounds, obtaining EC50 values in the range of 0.001 to 28.9 mg/l. In the case of mixtures, synergistic toxic responses were seen for a clear majority of the cases (>60%). Mixtures containing methyl-tertiary-butyl ether (MTBE) exhibit accelerated processes that result in a change in concentration required to produce a toxic effect; for example, in the case of mixtures containing MTBE and Diuron and Dichlofluanid.

Determination of PASHs by various analytical techniques based on gas chromatography-mass spectrometry Application to a biodesulfurization process

Polycyclic aromatic sulphur heterocyclic (PASH) compounds, such as dibenzothiophene (DBT) and alkylated derivatives are used as model compounds in biodesulfurization processes. The development of these processes is focused on the reduction of the concentration of sulphur in gasoline and gas-oil [D.J. Monticello, Curr. Opin. Biotechnol. 11 (2000) 540], in order to meet European Union and United States directives. The evaluation of biodesulfurization processes requires the development of adequate analytical techniques, allowing the identification of any transformation products generated. The identification of intermediates and final products permits the evaluation of the degradation process. In this work, seven sulfurated compounds and one non-sulfurated compound have been selected to develop an extraction method and to compare the sensitivity and identification capabilities of three different gas chromatography ionization modes. The selected compounds are: dibenzothiophene (DBT), 4-methyl-dibenzothiophene (4-m-DBT), 4,6-dimethyl-dibenzothiophene (4,6-dm-DBT) and 4,6 diethyl-dibenzothiophene (4,6 de-DBT), all of which can be used as model compounds in biodesulfurization processes; as well as dibenzothiophene sulfoxide (DBTO(2)), dibenzothiophene sulfone (DBTO) and 2-(2-hydroxybiphenyl)-benzenesulfinate (HBPS), which are intermediate products in biodesulfurization processes of DBT [ A. Alcon, V.E. Santos, A.B. Martín, P. Yustos, F. García-Ochoa, Biochem. Eng. J. 26 (2005) 168]. Furthermore, a non-sulfurated compound, 2-hydroxybiphenyl (2-HBP), has also been selected as it is the final product in the biodesulfurization process of DBT [A. Alcon, V.E. Santos, A.B. Martín, P. Yustos, F. García-Ochoa. Biochem. Eng. J. 26 (2005) 168]. Since, typically, biodesulfurization reactions take place in a biphasic medium, two extraction methods have been developed: a liquid-liquid extraction method for the watery phase and a solid phase extraction method for the organic phase. Recoveries of the selected compound in both media were studied. They were in the range of 80-100% for the watery and in the range of 40-60% for the organic phase, respectively. Gas chromatography coupled to mass spectrometry (GC-MS) has been employed for the identification of these selected compounds. Three different ionization modes were applied: conventional electron impact (EI); positive chemical ionization (PCI), using methane as the reagent gas; and a recently developed ionization mode known as hybrid chemical ionization (HCI), using perfluorotri-n-butylamine as the reagent gas. Limits of detection and identification capabilities have been compared between the three analytical techniques. The sensitivity of the three analytical techniques was studied and LOD between 0.05 and 1, between 0.09 and 2 and between 0.001 and 0.043 were achieved for PCI, EI and HCI, respectively. The developed method was applied in samples from a biodesulfurization process. The biodesulfurization reactions were conducted in resting cell operation mode, using Erlenmeyer flasks or an agitated tank bioreactor. The microorganism employed was Pseudomonas putida CECT 5279. The reaction was performed under controlled air flow, stirring and temperature conditions.

Chromatographic methods applied in the monitoring of biodesulfurization processes – State of the art

Analytical methodologies employed in biodesulfurization processes have been reviewed; attention is primarily focused on the use of analytical techniques in the identification of degradation products and on the monitoring of degradation processes in which microbial sulphur-specific transformations take place. This is the first review of analytical techniques applied to biodesulfurization processes. Methodologies based on gas chromatography (GC) are the most frequently employed, in tandem with various detectors, mainly with the mass spectrometry (MS) detector, and the flame ionization detector (FID). High performance liquid chromatography (HPLC) coupled with ultra violet (UV) detection has also been widely employed. Different sulphurated compounds are used as model in biodesulphurization processes, naphtothiophene (NTH), benzothiophene (BTH), alkylated BTH, dibenzothiophene (DBT), alkylated DBT and their transformation products has been reviewed. DBT is the most frequently employed.

Application of Gas Chromatography to Multiresidue Methods for Pesticides and Related Compounds in Food

This article provide an overview of the major uses of gas chromatography in pesticide residue analysis in foods, best practices, problems associated with injection techniques, and data interpretation. Sample preparation is not specifically covered in this article except as it applies to problems in separating the target analytes.