Mohammed J.K. Bashir

Leachate characterization in semi-aerobic and anaerobic sanitary landfills: A comparative study

This study analyzes and compares the results of leachate composition at the semi-aerobic Pulau Burung Landfill Site (PBLS) (unaerated pond and intermittently aerated pond) and the anaerobic Kulim Sanitary Landfill in the northern region of Malaysia. The raw samples were collected and analyzed for twenty parameters. The average values of the parameters such as phenols (1.2, 6.7, and 2.6 mg/L), total nitrogen (448, 1200, and 300 mg/L N-TN), ammonia-N (542, 1568, and 538 mg/L NH(3)-N), nitrite (91, 49, and 52 mg/L NO(2)(-)-N), total phosphorus (21, 17, and 19 mg/L), BOD(5) (83, 243, and 326 mg/L), COD (935, 2345, and 1892 mg/L), BOD(5)/COD (0.096,0.1124,0.205%), pH (8.20, 8.28, and 7.76), turbidity (1546, 180, and 1936 Formazin attenuation units (FAU)), and color (3334, 3347, and 4041 Pt Co) for leachate at the semi-aerobic PBLS (unaerated and intermittently aerated) and the anaerobic Kulim Sanitary Landfill were recorded, respectively. The obtained results were compared with previously published data and data from the Malaysia Environmental Quality Act 1974. The results indicated that Pulau Burung leachate was more stabilized compared with Kulim leachate. Furthermore, the aeration process in PBLS has a considerable effect on reducing the concentration of several pollutants. The studied leachate requires treatment to minimize the pollutants to an acceptable level prior to discharge into water courses.

Landfill leachate treatment by electrochemical oxidation

This study investigated the electrochemical oxidation of stabilized leachate from Pulau Burung semi-aerobic sanitary landfill by conducting laboratory experiments with sodium sulfate Na(2)SO(4) (as electrolyte) and graphite carbon electrodes. The control parameters were influent COD, current density and reaction time, while the responses were BOD removal, COD removal, BOD:COD ratio, color and pH. Na(2)SO(4) concentration was 1 g/L. Experiments were conducted based on a three-level factorial design and response surface methodology (RSM) was used to analyze the results. The optimum conditions were obtained as 1414 mg/L influent COD concentration, 79.9 mA/cm(2) current density and 4 h reaction time. This resulted in 70% BOD removal, 68% COD removal, 84% color removal, 0.04 BOD/COD ratio and 9.1 pH. Electrochemical treatment using graphite carbon electrode was found to be effective in BOD, COD and color removal but was not effective in increasing the BOD/COD ratio or enhancing biodegradability of the leachate. The color intensity of the treated samples increased at low influent COD and high current density due to corrosion of electrode material.

Landfill leachate treatment using powdered activated carbon augmented sequencing batch reactor (SBR) process: Optimization by response surface methodology

In this study, landfill leachate was treated by using the sequencing batch reactor (SBR) process. Two types of the SBR, namely non-powdered activated carbon and powdered activated carbon (PAC-SBR) were used. The influence of aeration rate and contact time on SBR and PAC-SBR performances was investigated. Removal efficiencies of chemical oxygen demand (COD), colour, ammoniacal nitrogen (NH(3)-N), total dissolved salts (TDS), and sludge volume index (SVI) were monitored throughout the experiments. Response surface methodology (RSM) was applied for experimental design, analysis and optimization. Based on the results, the PAC-SBR displayed superior performance in term of removal efficiencies when compared to SBR. At the optimum conditions of aeration rate of 1L/min and contact time of 5.5h the PAC-SBR achieved 64.1%, 71.2%, 81.4%, and 1.33% removal of COD, colour, NH(3)-N, and TDS, respectively. The SVI value of PAC-SBR was 122.2 mL/g at optimum conditions.

Influence of Fenton reagent oxidation on mineralization and decolorization of municipal landfill leachate

This study evaluated the effectiveness of Fentons technique for the treatment of semi-aerobic landfill leachate collected from Pulau Burung Landfill Site (PBLS), Penang, Malaysia. The Fe2 + or Fe3 + as catalyst and H2O2 as oxidizing agent are commonly used for the classical Fentons reaction. In present study, the effect of operating conditions such as pH, reaction time, molar ratio, agitation rate, feeding mode and Fenton reagent concentrations which are important parameters that affect the removal efficiencies of Fenton method were investigated. Under the most favorable conditions, the highest removals of 58.1 and 78.3% were observed for COD and color, respectively. In general, the best operating conditions were pH = 3, Fe = 560 mg L−1, H2O2 = 1020 mg L−1, H2O2/Fe2 + molar ratio = 3, agitation rate = 400 rpm and reaction time = 120 minutes. The results highlighted that stepwise addition of Fentons reagent was more effective than adding the entire volume in a single step. Excessive hydrogen peroxide and iron have shown scavenging effects on hydroxyl radicals and reduced degradation of refractory organics in the landfill leachate.

Stabilized sanitary landfill leachate treatment using anionic resin: treatment optimization by response surface methodology.

The treatability of stabilized sanitary landfill leachate via synthetic anion exchange resin (INDION FFIP MB) was investigated. An ideal experimental design was conducted based on central composite design using a response surface methodology to assess individual and interactive effects of critical operational variables (i.e., anionic dosage; contact time; shaking speed) and pH on treatment performance in terms of color, chemical oxygen demand (COD), suspended solid (SS), and turbidity removal efficiencies. Optimum operational conditions were established as 30.9 cm(3) anionic dosage, 90 min contact time, 150 rpm shaking speed, and pH 3.1. Under these conditions, the color, COD, SS, and turbidity removal efficiencies of 91.5, 70.3, 93.1, and 92.4% were experimentally attained and were found to fit well with the prediction model. According to these results, stabilized leachate treatment using INDION FFIP MB could be an effective alternative in the administration of color, COD, SS, and turbidity problems of landfill leachates.

Optimization of membrane bioreactors by the addition of powdered activated carbon.

It was found that with replenishment, powdered activated carbon (PAC) in the membrane bioreactor (MBR) would develop biologically activated carbon (BAC) which could enhance filtration performance of a conventional MBR. This paper addresses two issues (i) effect of PAC size on MBR (BAC) performance; and (ii) effect of sludge retention time (SRT) on the MBR performance with and without PAC. To interpret the trends, particle/floc size, concentration of mixed liquor suspended solid (MLSS), total organic carbon (TOC), short-term filtration properties and transmembrane pressure (TMP) versus time are measured. The results showed improved fouling control with fine, rather than coarse, PAC provided the flux did not exceed the deposition flux for the fine PAC. Without PAC, the longer SRT operation gave lower fouling at modest fluxes. With PAC addition, the shorter SRT gave better fouling control, possibly due to greater replenishment of the fresh PAC.

New sequential treatment for mature landfill leachate by cationic/anionic and anionic/cationic processes: optimization and comparative study.

Two new applications for sequence treatment of mature (stabilized) landfill leachate, that is, cationic resin followed by anionic resin (cationic/anionic) and anionic resin followed by cationic resin (anionic/cationic), are employed and documented for the first time in the literature. Response surface methodology (RSM) concerning central composite design (CCD) is used to optimize each treatment process, as well as evaluate the individual and interactive effects of operational cationic resin dosage and anionic resin dosage on the effectiveness of each application in terms of color, chemical oxygen demand (COD), and NH(3)-N removal efficiency. A statistically significant model for color, COD, and NH(3)-N removal was obtained with high coefficient of determination values (R(2)>0.8). Under optimum operational conditions, the removal efficiency levels for color, COD, and NH(3)-N are 96.8%, 87.9%, and 93.8% via cationic/anionic sequence, and 91.6%, 72.3%, and 92.5% via anionic/cationic sequence, respectively. The experimental results and the model predictions agree well with each other.

An overview of electro-oxidation processes performance in stabilized landfill leachate treatment

Abstract Among numerous techniques, electro-oxidation occupies a noticeable place in landfill leachate treatment. In recent years, electro-oxidation processes have been shown to be effective alternative for the removal of refractory organic compounds from stabilized landfill leachate. This paper aims to provide an overview about the effectiveness and mechanism of electro-oxidation processes employed for stabilized landfill leachate treatment. A review of the recent literature published on the electro-oxidation processes (i.e. electrochemical, electro-Fenton, photoelectro-Fenton, photoelectrochemical, and electrochemical peroxidation) performance and efficiency in stabilized leachate treatment are summarized and presented in this study. This study concluded that, although the high treatment cost caused by the energy consumption may limit electro-oxidation techniques, electro-oxidation processes are still a promising and effectual technology for the reduction of pollutants in stabilized landfill leachate.

Application of psyllium husk as coagulant and coagulant aid in semi-aerobic landfill leachate treatment

Landfill leachate is a heavily polluted and a likely hazardous liquid that is produced as a result of water infiltration through solid wastes generated industrially and domestically. This study investigates the potential of using psyllium husk as coagulant and coagulant aid for the treatment of landfill leachate. Psyllium husk has been tested as primary coagulant and as coagulant aid with poly-aluminum chloride (PACl) and aluminum sulfate (alum). As primary coagulant, the optimum dosage and pH for PACl were 7.2 and 7.5 g/L, respectively, with removal efficiencies of 55, 80 and 95% for COD, color and TSS, respectively. For alum, the optimum conditions were 11 g/L alum dosage and pH 6.5 with removal efficiencies of 58, 79 and 78% for COD, color and TSS, respectively. The maximum removal efficiencies of COD, color and TSS were 64, 90 and 96%, respectively, when psyllium husk was used as coagulant aid with PACl. Based on the results, psyllium husk was found to be more effective as coagulant aid with PACl in the removal of COD, color and TSS as compared to alum. Zeta potential test was carried out for leachate, PACl, alum and psyllium husk before and after running the jar test to enhance the results of the jar test experiments.

The competency of various applied strategies in treating tropical municipal landfill leachate

AbstractLeachate is a major pollution source associated with municipal solid waste landfill. This study was carried out to evaluate the effectiveness of various techniques in treating mature landfill leachate generated from landfill in Malaysia, a tropical country. Treatment processes such as biological, ion exchange, coagulation–flocculation, adsorption, advanced oxidation processes (AOPs), and flotation were analyzed. The efficiency of each process was analyzed based on chemical oxygen demand (COD), color, and NH3-N percentage removals. Ion exchange treatment via cationic/anionic sequence achieved the best removal of color (96.8%), COD (87.9%), and NH3-N (93.8%) from leachate as compared with other treatment methods. Coagulation–flocculation and AOPs were successful for COD and color removals from leachate. However, both could not treat NH3-N effectively. Biological treatment could remove NH3-N (71%) effectively, but it was poor in terms of COD (29%) and color (22%) removals. Adsorption via a new carbon...