Muhammad Waqas

Sewage Sludge Biochar Influence upon Rice (Oryza sativa L) Yield, Metal Bioaccumulation and Greenhouse Gas Emissions from Acidic Paddy Soil

Biochar addition to soil has been proposed to improve plant growth by increasing soil fertility, minimizing bioaccumulation of toxic metal(liod)s and mitigating climate change. Sewage sludge (SS) is an attractive, though potentially problematic, feedstock of biochar. It is attractive because of its large abundance; however, it contains elevated concentrations of metal(loid)s and other contaminants. The pyrolysis of SS to biochar (SSBC) may be a way to reduce the availability of these contaminants to the soil and plants. Using rice plant pot experiments, we investigated the influence of SSBC upon biomass yield, bioaccumulation of nutrients, and metal(loid)s, and green housegas (GHG) emissions. SSBC amendments increased soil pH, total nitrogen, soil organic carbon and available nutrients and decreased bioavailable As, Cr, Co, Ni, and Pb (but not Cd, Cu, and Zn). Regarding rice plant properties, SSBC amendments significantly (P ≤ 0.01) increased shoot biomass (71.3-92.2%), grain yield (148.8-175.1%), and the bioaccumulation of phosphorus and sodium, though decreased the bioaccumulation of nitrogen (except in grain) and potassium. Amendments of SSBC significantly (P ≤ 0.05) reduced the bioaccumulation of As, Cr, Co, Cu, Ni, and Pb, but increased that of Cd and Zn, though not above limits set by Chinese regulations. Finally regarding GHG emissions, SSBC significantly (P < 0.01) reduced N2O emissions and stimulated the uptake/oxidation of CH4 enough to make both the cultivated and uncultivated paddy soil a CH4 sink. SSBC can be beneficial in rice paddy soil but the actual associated benefits will depend on site-specific conditions and source of SS; long-term effects remain a further unknown.

The influence of various biochars on the bioaccessibility and bioaccumulation of PAHs and potentially toxic elements to turnips (Brassica rapa L.)

The influence of amending a contaminated soil with different dry-pyrolyzed biochars on the bioaccessibility and biouptake of polycyclic aromatic hydrocarbons (PAH) and potentially toxic elements (PTE) in turnip (Brassica rapa L.,) was investigated. This is the first study to examine the influence of biochar amendments on turnips grown in a contaminated soil. The biochars came from different local feedstocks, including sewage sludge biochar (SSBC), soybean straw biochar (SBBC), rice straw biochar (RSBC) and peanut shell biochar (PNBC). The biochars were applied to soil at 2% and 5% amendments, and the resulting influence on various soil and porewater properties were quantified. The bioaccessible concentrations of PAHs in soil and their bioaccumulation in B. rapa L. significantly (P < 0.05) decreased in the biochar amended soils. Biochar additions significantly (P ≤ 0.05) reduced the bioaccumulation of PTEs (As, Cd, Cu, Pb and Zn) in B. rapa L, though not as much as for PAHs. The most effective biochar at reducing both PAHs and PTEs was PNBC (P ≤ 0.05). Amendments of 5% biochar were more effective at reducing contaminant bioaccessibility than amendments at 2% (P < 0.05). Crop yield, however, increased the most for the 2% biochar amendments, in particular for SSBC (with a 49% increase in crop yield compared to the non-amended soil). Therefore, which biochar would be the most advantageous in this system would require a cost-benefit analysis between increasing crop yield (best achieved with 2% SSBC amendments) and decreasing the PAH and PTE uptake (best achieved with 5% PNBC amendments).

The uptake and bioaccumulation of heavy metals by food plants, their effects on plants nutrients, and associated health risk: a review

Heavy metal contamination is a globally recognized environmental issue, threatening human life very seriously. Increasing population and high demand for food resulted in release of various contaminants into environment that finally contaminate the food chain. Edible plants are the major source of diet, and their contamination with toxic metals may result in catastrophic health hazards. Heavy metals affect the human health directly and/or indirectly; one of the indirect effects is the change in plant nutritional values. Previously, a number of review papers have been published on different aspects of heavy metal contamination. However, no related information is available about the effects of heavy metals on the nutritional status of food plants. This review paper is focused upon heavy metal sources, accumulation, transfer, health risk, and effects on protein, amino acids, carbohydrates, fats, and vitamins in plants. The literature about heavy metals in food plants shows that both leafy and nonleafy vegetables are good accumulators of heavy metals. In nonleafy vegetables, the bioaccumulation pattern was leaf > root ≈ stem > tuber. Heavy metals have strong influence on nutritional values; therefore, plants grown on metal-contaminated soil were nutrient deficient and consumption of such vegetables may lead to nutritional deficiency in the population particularly living in developing countries which are already facing the malnutrition problems.

The effects of sewage sludge and sewage sludge biochar on PAHs and potentially toxic element bioaccumulation in Cucumis sativa L.

The presence of contaminants such as polycyclic aromatic hydrocarbons (PAHs) and potentially toxic elements (PTEs), including As, Cd, Cu, Pb and Zn, restricts the application of sewage sludge (SS) to agricultural land. This research established that the conversion of SS to SS biochar (SSBC) significantly (p ≤ 0.01) decreased PAH and available PTE concentrations. Once added to soil both SS and SSBC significantly (p ≤ 0.05) decrease PAH availability. Bioaccumulation of PAHs into Cucumis sativa L. was reduced by both SSBC (44-57%) and (to a lesser extent 20-36%) by SS. Following addition to soil SSBC significantly (p ≤ 0.05) reduced available PTEs (except Cd), while SS significantly (p ≤ 0.05) increased PTE availability. As a consequence SSBC significantly (p ≤ 0.05) reduced PTE bioaccumulation (except Cd and Zn), while SS increased PTE bioaccumulation. These results suggest SSBC to be a candidate for soil amendment that offers advantages over SS in terms of PAH/PTE bioaccumulation mitigation.

Heavy metals in agricultural soils and crops and their health risks in Swat District, northern Pakistan.

This study assessed the concentrations of heavy metals such as cadmium (Cd), chromium (Cr), copper (Cu), manganese (Mn), nickel (Ni) and zinc (Zn) in agricultural soils and crops (fruits, grains and vegetable) and their possible human health risk in Swat District, northern Pakistan. Cd concentration was found higher than the limit (0.05 mg/kg) set by world health organization in 95% fruit and 100% vegetable samples. Moreover, the concentrations of Cr, Cu, Mn, Ni and Zn in the soils were shown significant correlations with those in the crops. The metal transfer factor (MTF) was found highest for Cd followed by Cr>Ni>Zn>Cu>Mn, while the health risk assessment revealed that there was no health risk for most of the heavy metals except Cd, which showed a high level of health risk index (HRI⩾10E-1) that would pose a potential health risk to the consumers.

Application of sewage sludge and sewage sludge biochar to reduce polycyclic aromatic hydrocarbons (PAH) and potentially toxic elements (PTE) accumulation in tomato

The effects of sewage sludge (SS) and its derived biochar (SSBC) on the availability and uptake of polycyclic aromatic hydrocarbons (PAHs) and potential toxic elements (PTEs) by Solanum lycopersicum (tomato) fruits grown in contaminated urban soil were investigated. Increasing application rates of SS and SSBC (2, 5, and 10xa0%) decreased PAH availability and, correspondingly, PAH accumulation (22–39 and 48–62xa0%, respectively) into tomato. SSBC was more effective in this regard. The available concentrations of PAHs (Σ16PAH) in the SSBC treatments were significantly reduced (from 30.0–47.3xa0%) as compared to the control treatment. The availability of high-molecular-weight PAHs (containing four to six benzene rings) was greatly affected, while low-molecular-weight PAHs (containing two to three benzene rings) was less affected by SSBC amendments. The addition of SSBC showed the least effect on bioaccumulation of naphthalene (two-ring PAH; 24.5–32.6xa0%), while the highest effect was observed for benzo(b)fluoranthene (five-ring PAH; 3.1–86.8xa0%) and benzo(g,h,i)perylene (six-ring PAH; 51.8–84.2xa0%). In contrast, increasing application rates of SS successively increased PTE (As, Cd, Cu, Pb, and Zn) availability and accumulation (15–139xa0%) into tomato while SSBC successively decreased PTE availability and accumulation (17–91xa0%). Changes in accumulation varied with PTE and the extent to which PTE concentrations in soil was elevated.

Quantification of PAHs and health risk via ingestion of vegetable in Khyber Pakhtunkhwa Province, Pakistan

This study was conducted to evaluate the concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) in the soil and vegetable irrigated with wastewater in 11 districts of Khyber Pakhtunkhwa (KPK) Province (Pakistan). The ∑16PAH ranged from 223 to 929 μg/kg in the soils with highest concentration in the soil of high urbanized district (Peshawar), while the lowest concentration in the soil of less urbanized district (Lakki Marwat). PAH concentrations in vegetable ranged from 51.6 to 402 μg/kg on dry weight bases (d.w). Naphthaene, phenanthrene, fluoranthene and pyrene were frequently observed in vegetable. The concentrations of higher molecular weight PAHs were lower in vegetable as compared to low molecular weight PAHs. The highest PAH concentrations were observed in leafy vegetable (lettuce>spinach). The highest TEQ value (7.2) was observed for pyrene following by naphthalene (4.9) for the samples collected from Mardan, while the lowest mean TEQ value (0.12) was found for acenaphthylene followed by benzo[k]fluoranthene (0.26) in Peshawar. The highest TEQ value was 4.1 for flouranthene followed by 3.8 for naphthalene in the KPK province. The uniqueness of this study is the quantification of PAHs in the soil and vegetable collected from a large area of KPK Province which are rapidly urbanizing.

Multi-shelled TiO2/Fe2TiO5 heterostructured hollow microspheres for enhanced solar water oxidation

There remains a pressing challenge in the fabrication of superior photocatalysts for light-driven water oxidation. Here, we designed and fabricated heterostructured TiO2/Fe2TiO5 hollow microspheres with single-, double-, closed-double-, triple-, and core–shell structures and different Fe/Ti molar ratios using a facile sequential templating approach. The closed-double-shelled TiO2/Fe2TiO5 hollow microspheres with 35% Fe exhibited the highest oxygen evolution reaction rate up to 375 μmol·g−1·h−1 and good stability for 5 h. The high performance can be attributed to the closed-double shell, which had more reactive sites and greater light-harvesting ability, self-supported thin shells with short charge-transfer paths, and a favorable staggered band alignment between the TiO2 and Fe2TiO5.

Electrochemical performance of 2D polyaniline anchored CuS/Graphene nano-active composite as anode material for lithium-ion battery

Lithium-ion battery (LIB) is a revolutionary step in the electric energy storage technology for making green environment. In the present communication, a LIB anode material was constructed by using graphene/polyaniline/CuS nanocomposite (GR/PANI/CuS NC) as a high-performance electrode. Initially, pure covellite CuS nanoplates (NPs) of the hexagonal structure were synthesized by hydrothermal route and then GR/PANI/CuS NC was fabricated by in-situ polymerization of aniline in the presence of CuS NPs and graphene nanosheets (GR NSs) as host matrix. GR/PANI/CuS NC-based LIB has shown the superior reversible current capacity of 1255mAhg-1, a high cycling stability with more than 99% coulombic efficiency over 250 cycles even at a high current density of 5Ag-1, low volume expansion, and excellent power capabilities. Galvanostatic charge/discharge tests and cyclic voltammetry analysis were used to investigate electrochemical properties. The electrochemical test proves that GR/PANI/CuS NC is promising anode material for LIB. The crystal phases and purity of the GR/PANI/CuS NC were confirmed by X-ray diffraction (XRD). Scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy dispersive X-ray (EDX) and X-ray photoelectron spectroscopy (XPS) were employed to examine the morphology, size, chemical composition, and phase structure of the synthesized GR/PANI/CuS NC.

Removal and bioaccumulation of heavy metals from aqueous solutions using freshwater algae.

Four freshwater algae, including Cladophora glomerata, Oedogonium westii, Vaucheria debaryana and Zygnema insigne, were tested for their bioaccumulation capacity for cadmium (Cd), chromium (Cr) and lead (Pb) in a controlled environment with an average temperature of 18 °C, and light/dark duration of 12:12 h. Experiments were performed in aqueous solutions containing selected heavy metals (HM) (ranging from 0.05 to 1.5 mg L(-1)) with 0.5 g of living algae at 18 °C and pH 6.8. The results indicated that C. glomerata was observed to be the most competent species for the removal of Cr, Cd and Pb from aqueous solutions. HM removal trends were in the order of Cd>Cr>Pb while the removal efficiency of selected algae species was in the order of C. glomerata, O. westii, V. debaryana and Z. insigne. The bioaccumulation capacity of C. glomerata, V. debaryana and Z. insigne was observed for different HM. Removal of HM was higher with low levels of HM in aqueous solutions. The results indicated that C. glomerata, O. westii, V. debaryana and Z. insigne had significant (P≤0.01) diverse bioaccumulation capacity for Cr, Cd and Pb.