N. Lanza

Soil Diversity and Hydration as Observed by ChemCam at Gale Crater, Mars

The ChemCam instrument, which provides insight into martian soil chemistry at the submillimeter scale, identified two principal soil types along the Curiosity rover traverse: a fine-grained mafic type and a locally derived, coarse-grained felsic type. The mafic soil component is representative of widespread martian soils and is similar in composition to the martian dust. It possesses a ubiquitous hydrogen signature in ChemCam spectra, corresponding to the hydration of the amorphous phases found in the soil by the CheMin instrument. This hydration likely accounts for an important fraction of the global hydration of the surface seen by previous orbital measurements. ChemCam analyses did not reveal any significant exchange of water vapor between the regolith and the atmosphere. These observations provide constraints on the nature of the amorphous phases and their hydration.

Trace element geochemistry (Li, Ba, Sr, and Rb) using Curiosity's ChemCam: Early results for Gale crater from Bradbury Landing Site to Rocknest

The ChemCam instrument package on the Mars rover, Curiosity, provides new capabilities to probe the abundances of certain trace elements in the rocks and soils on Mars using the laser-induced breakdown spectroscopy technique. We focus on detecting and quantifying Li, Ba, Rb, and Sr in targets analyzed during the first 100 sols, from Bradbury Landing Site to Rocknest. Univariate peak area models and multivariate partial least squares models are presented. Li, detected for the first time directly on Mars, is generally low ( 100 ppm and >1000 ppm, respectively. These analysis locations tend to have high Si and alkali abundances, consistent with a feldspar composition. Together, these trace element observations provide possible evidence of magma differentiation and aqueous alteration.

Chemistry of fracture‐filling raised ridges in Yellowknife Bay, Gale Crater: Window into past aqueous activity and habitability on Mars

The ChemCam instrument package on the Curiosity rover was used to characterize distinctive raised ridges in the Sheepbed mudstone, Yellowknife Bay formation, Gale Crater. The multilayered, fracture-filling ridges are more resistant to erosion than the Sheepbed mudstone rock in which they occur. The bulk average composition of the raised ridges is enriched in MgO by 1.2-1.7 times (average of 8.3-11.4 wt %; single-shot maximum of 17.0 wt %) over that of the mudstone. Al2O3 is anticorrelated with MgO, while Li is somewhat enriched where MgO is highest. Some ridges show a variation in composition with different layers on a submillimeter scale. In particular, the McGrath target shows similar high-MgO resistant outer layers and a low-MgO, less resistant inner layer. This is consistent with the interpretation that the raised ridges are isopachous fracture-filling cements with a stratigraphy that likely reveals changes in fluid composition or depositional conditions over time. Overall, the average composition of the raised ridges is close to that of a Mg- and Fe-rich smectite, or saponite, which may also be the main clay mineral constituent of the host mudstone. These analyses provide evidence of diagenesis and aqueous activity in the early postdepositional history of the Yellowknife Bay formation, consistent with a low salinity to brackish fluid at near-neutral or slightly alkaline pH. The fluids that circulated through the fractures likely interacted with the Sheepbed mudstone and (or) other stratigraphically adjacent rock units of basaltic composition and leached Mg from them preferentially.

First detection of fluorine on Mars: Implications for Gale Crater's geochemistry

Volatiles and especially halogens (F and Cl) have been recognized as important species in the genesis and melting of planetary magmas. Data from the Chemical Camera instrument on board the Mars Science Laboratory rover Curiosity now provide the first in situ analyses of fluorine at the surface of Mars. Two principal F-bearing mineral assemblages are identified. The first is associated with high aluminum and low calcium contents, in which the F-bearing phase is an aluminosilicate. It is found in conglomerates and may indicate petrologically evolved sources. This is the first time that such a petrologic environment is found on Mars. The second is represented by samples that have high calcium contents, in which the main F-bearing minerals are likely to be fluorapatites and/or fluorites. Fluorapatites are found in some sandstone and may be detrital, while fluorites are also found in the conglomerates, possibly indicating low-T alteration processes.

High manganese concentrations in rocks at Gale crater, Mars

The surface of Mars has long been considered a relatively oxidizing environment, an idea supported by the abundance of ferric iron phases observed there. However, compared to iron, manganese is sensitive only to high redox potential oxidants, and when concentrated in rocks, it provides a more specific redox indicator of aqueous environments. Observations from the ChemCam instrument on the Curiosity rover indicate abundances of manganese in and on some rock targets that are 1–2 orders of magnitude higher than previously observed on Mars, suggesting the presence of an as-yet unidentified manganese-rich phase. These results show that the Martian surface has at some point in time hosted much more highly oxidizing conditions than has previously been recognized.

Chemistry and texture of the rocks at Rocknest, Gale Crater: Evidence for sedimentary origin and diagenetic alteration

A suite of eight rocks analyzed by the Curiosity Rover while it was stopped at the Rocknest sand ripple shows the greatest chemical divergence of any potentially sedimentary rocks analyzed in the early part of the mission. Relative to average Martian soil and to the stratigraphically lower units encountered as part of the Yellowknife Bay formation, these rocks are significantly depleted in MgO, with a mean of 1.3 wt %, and high in Fe, averaging over 20 wt % FeO_T, with values between 15 and 26 wt % FeO_T. The variable iron and low magnesium and rock texture make it unlikely that these are igneous rocks. Rock surface textures range from rough to smooth, can be pitted or grooved, and show various degrees of wind erosion. Some rocks display poorly defined layering while others seem to show possible fractures. Narrow vertical voids are present in Rocknest 3, one of the rocks showing the strongest layering. Rocks in the vicinity of Rocknest may have undergone some diagenesis similar to other rocks in the Yellowknife Bay Formation as indicated by the presence of soluble calcium phases. The most reasonable scenario is that fine-grained sediments, potentially a mixture of feldspar-rich rocks from Bradbury Rise and normal Martian soil, were lithified together by an iron-rich cement.

The potassic sedimentary rocks in Gale Crater, Mars, as seen by ChemCam on board Curiosity

Key Points: • Mean K2O abundance in sedimentary rocks >5 times higher than that of the average Martian crust • Presence of alkali feldspars and K-phyllosilicates in basaltic sedimentary rocks along the traverse • The K-bearing minerals likely have a detrital origin

Chemical variations in Yellowknife Bay formation sedimentary rocks analyzed by ChemCam on board the Curiosity rover on Mars

The Yellowknife Bay formation represents a similar to 5m thick stratigraphic section of lithified fluvial and lacustrine sediments analyzed by the Curiosity rover in Gale crater, Mars. Previous works have mainly focused on the mudstones that were drilled by the rover at two locations. The present study focuses on the sedimentary rocks stratigraphically above the mudstones by studying their chemical variations in parallel with rock textures. Results show that differences in composition correlate with textures and both manifest subtle but significant variations through the stratigraphic column. Though the chemistry of the sediments does not vary much in the lower part of the stratigraphy, the variations in alkali elements indicate variations in the source material and/or physical sorting, as shown by the identification of alkali feldspars. The sandstones contain similar relative proportions of hydrogen to the mudstones below, suggesting the presence of hydrous minerals that may have contributed to their cementation. Slight variations in magnesium correlate with changes in textures suggesting that diagenesis through cementation and dissolution modified the initial rock composition and texture simultaneously. The upper part of the stratigraphy (similar to 1m thick) displays rocks with different compositions suggesting a strong change in the depositional system. The presence of float rocks with similar compositions found along the rover traverse suggests that some of these outcrops extend further away in the nearby hummocky plains.

The rock abrasion record at Gale Crater: Mars Science Laboratory results from Bradbury Landing to Rocknest

Ventifacts, rocks abraded by wind-borne particles, are found in Gale Crater, Mars. In the eastward drive from “Bradbury Landing” to “Rocknest,” they account for about half of the float and outcrop seen by Curiositys cameras. Many are faceted and exhibit abrasion textures found at a range of scales, from submillimeter lineations to centimeter-scale facets, scallops, flutes, and grooves. The drive path geometry in the first 100 sols of the mission emphasized the identification of abrasion facets and textures formed by westerly flow. This upwind direction is inconsistent with predictions based on models and the orientation of regional dunes, suggesting that these ventifact features formed from very rare high-speed winds. The absence of active sand and evidence for deflation in the area indicates that most of the ventifacts are fossil features experiencing little abrasion today.

Terrain Physical Properties Derived From Orbital Data and the First 360 Sols of Mars Science Laboratory Curiosity Rover Observations in Gale Crater

Physical properties of terrains encountered by the Curiosity rover during the first 360 sols of operations have been inferred from analysis of the scour zones produced by Sky Crane Landing System engine plumes, wheel touch down dynamics, pits produced by Chemical Camera (ChemCam) laser shots, rover wheel traverses over rocks, the extent of sinkage into soils, and the magnitude and sign of rover-based slippage during drives. Results have been integrated with morphologic, mineralogic, and thermophysical properties derived from orbital data, and Curiosity-based measurements, to understand the nature and origin of physical properties of traversed terrains. The hummocky plains (HP) landing site and traverse locations consist of moderately to well-consolidated bedrock of alluvial origin variably covered by slightly cohesive, hard-packed basaltic sand and dust, with both embedded and surface-strewn rock clasts. Rock clasts have been added through local bedrock weathering and impact ejecta emplacement and form a pavement-like surface in which only small clasts (<5 to 10 cm wide) have been pressed into the soil during wheel passages. The bedded fractured (BF) unit, site of Curiositys first drilling activity, exposes several alluvial-lacustrine bedrock units with little to no soil cover and varying degrees of lithification. Small wheel sinkage values (<1 cm) for both HP and BF surfaces demonstrate that compaction resistance countering driven-wheel thrust has been minimal and that rover slippage while traversing across horizontal surfaces or going uphill, and skid going downhill, have been dominated by terrain tilts and wheel-surface material shear modulus values.