N. Niño-Martínez

Adherence inhibition of Streptococcus mutans on dental enamel surface using silver nanoparticles

The aim of this ex vivo study was to evaluate the adherence capacity of Streptococcus mutans after being exposed to three different sizes of silver nanoparticles on healthy human dental enamel. Three different sizes of silver nanoparticles (9.3, 21.3 and 98 nm) were prepared, characterized and an adherence testing was performed to evaluate their anti-adherence activity on a reference strain of S. mutans on healthy dental enamel surfaces. Colony-Forming Unit count was made for adherence test and light microscopy, atomic force microscopy and scanning electron microscopy were used to compare qualitative characteristics of S. mutans. 9.3 nm and 21.3 nm groups did not show differences between them but statistical differences were found when 9.3 nm and 21.3 nm groups were compared with 98 nm and negative control groups (p<0.05). Microscopy analysis shows a better inhibition of S. mutans adherence in 9.3 nm and 21.3 nm groups than the 98 nm group when compared with control group. Silver nanoparticles showed an adherence inhibition on S. mutans and the anti-adherence capacity was better when silver nanoparticles were smaller.

Antibacterial and antibiofilm activities of the photothermal therapy using gold nanorods against seven different bacterial strains

The objective of this work was to determine the bactericidal and antibiofilm activities of gold nanorods (AuNRs) using plasmonic photothermal therapy (PPTT) against oral microorganisms. AuNRs were synthesized by the seed and growth solution method and the gold nanoclusters were characterized with a size of 33.2 nm ± 2.23 length and 7.33 nm ± 1.60 width. The efficacy of PPTT related to its temperature was done reaching 67°C. Minimum inhibitory concentration (MIC) and minimum bactericide concentration (MBC) of AuNRs and AuNRs PPTT were determined against Enterococcus faecalis, Staphylococcus aureus, Streptococcus mutans, Streptococcus sobrinus, Streptococcus oralis, Streptococcus salivarius, and Escherichia coli growth. The antibiofilm activity of AuNRs was explored by fluorescence microscopy. After experimental analyses, AuNRs PPTT shows better results in MICs and MBCs, when it was compared with AuNRs alone. The laser employed to activate the AuNRs had no antibacterial effect against oral microbes. The MICs and MBCs values were higher for S. aureus and E. coli and lower against S. oralis. Surprisingly, the AuNRs alone presented a high antibiofilm activity, inhibiting the biofilm formation of S. mutans. Altogether, these results strongly suggest that AuNRs could be an interesting option to control oral biofilms.

Bovine serum albumin and chitosan coated silver nanoparticles and its antimicrobial activity against oral and nonoral bacteria

Antimicrobial agents have been developed for drug-resistance infections, which have been rapidly increasing; however, the control of involved microorganisms is still a challenge. In this work, SNP with bovine serum albumin (BSA) and chitosan (CS) coatings were prepared with an aqueous reduction method, characterized using dispersion light scattering, transmission electron microscopy, and thermal analysis. Antibacterial activity was tested on seven oral and nonoral bacteria by microdilution test and scanning electron microscopy. Six different sizes and shapes of coated SNP were prepared and used. Characterization revealed narrow size and good distribution of particles, spherical and pseudospherical shapes, and the presence of coatings on the SNP surfaces. All samples showed antimicrobial activity, although smaller sizes and CS samples had the best inhibition effects. The highest microbial resistance was shown by Gram-positive bacteria. Although coated SNP action depends on particular bacterium, BSA and CS coated SNP could be used for drug-resistance infections.

Facile Synthesis, Characterization, and Cytotoxic Activity of Europium-Doped Nanohydroxyapatite

The objective of this study was to synthetize europium-doped nanohydroxyapatite using a simple aqueous precipitation method and, thereafter, characterize and impregnate selected samples with 5-fluorouracil in order to explore the properties and the releasing capacity of this material. The nanohydroxyapatite was doped with 3, 5, 10, and 20 wt% of europium. The obtained samples were characterized after they were dried at 80°C and hydrothermal treated at 120°C by 2 hours. The samples were analyzed by transmission electron microscopy, X-ray diffraction analysis, Fourier transform infrared spectroscopy, and photoluminescence. Also, impregnation and release of 5-fluorouracil were assessed in PBS. The toxicity effects of all samples were studied using viability assays on human fibroblasts cells (HGF-1) in vitro. The sizes of the crystallites were about 10–70 nm with irregular morphology and present the phase corresponding to the JCPDS card 9–0432 for hydroxyapatite. The results of the toxicity experiments indicated that doped and undoped powders are biocompatible with fibroblasts cells. Hydroxyapatite samples doped with 5% of europium and loaded with 5-fluorouracil release almost 7 mg/L of the drug after 60 minutes in PBS and decrease the viability of HeLa cells after 24 hours.

Effects of silver nanoparticles on the bonding of three adhesive systems to fluorotic enamel

The objective was to evaluate the effect of adding silver nanoparticles into three commercial adhesive systems (Excite™, Adper Prompt L-Pop™ and AdheSE™). Nanoparticles were prepared by a chemical method then mixed with the commercial adhesive systems. This was later applied to the fluorotic enamel, and then micro-tensile bond strength, contact angle measurements and scanning electron microscopy observations were conducted. The commercial adhesive systems achieved the lowest micro-tensile bond strength (Excite™: 11.0±2.1, Adper Prompt L-Pop™: 14.0±5.4 and AdheSE™: 16.0±3.0 MPa) with the highest adhesive failure mode related with the highest contact angle (46.0±0.6º, 30.0±0.5º and 28.0±0.4º respectively). The bond strength achieved in all the experimental adhesive systems (19.0±5.4, 20.0±4.0 and 19.0±3.5 MPa respectively) was statistically higher (p<0.05) than the control and showed the highest cohesive failures related to the lowest contact angle. Adding silver nanoparticles in order to decrease the contact angle improve the adhesive system wetting and its bond strength.

Green Synthesis of Silver Nanoparticles and Their Bactericidal and Antimycotic Activities against Oral Microbes

Nanotechnology is a new discipline with huge applications including medicine and pharmacology industries. Although several methods and reducing agents have been employed to synthesize silver nanoparticles, reactive chemicals promote toxicity and nondesired effects on the human and biological systems. The objective of this work was to synthesize silver nanoparticles from Glycyrrhiza glabra and Amphipterygium adstringens extracts and determine their bactericidal and antimycotic activities against Enterococcus faecalis and Candida albicans growth, respectively. 1 and 10 mM silver nitrate were mixed with an extract of Glycyrrhiza glabra and Amphipterygium adstringens. Green silver nanoparticles (AgNPs) were characterized by TEM, Vis-NIR, FTIR, fluorescence, DLS, TGA, and X-ray diffraction (XRD) analysis. Bactericidal and antimycotic activities of AgNPs were determined by Kirby and Bauer method and cell viability MTT assays. AgNPs showed a spherical shape and average size of 9 nm if prepared with Glycyrrhiza glabra extract and 3 nm if prepared with Amphipterygium adstringens extract. AgNPs inhibited the bacterial and fungal growth as was expected, without a significant cytotoxic effect on human epithelial cells. Altogether, these results strongly suggest that AgNPs could be an interesting option to control oral biofilms.

Cytotoxic and Bactericidal Effect of Silver Nanoparticles Obtained by Green Synthesis Method Using Annona muricata Aqueous Extract and Functionalized with 5-Fluorouracil

Nanomaterials obtained by green synthesis technologies have been widely studied in recent years owing to constitute cost-effective and environmental-friendly methods. In addition, there are several works that report the simultaneous performance of the reducer agent as a functionalizing agent, modifying the properties of the nanomaterial. As a simple and economical synthesis methodology, this work presents a method to synthesize silver nanoparticles (AgNPs) using Annona muricata aqueous extract and functionalized with 5-fluorouracil (5-FU). The processes of reduction, nucleation, and functionalization of the nanoparticles were analyzed by UV-Vis absorption spectroscopy, and it was found that they are the function of the contact time of the metal ions with the extract. The structural characterization was carried out by transmission electron microscopy (TEM) and X-ray diffraction patterns (XRD). The antibacterial properties of the synthetized nanomaterials were tested using minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) against Enterococcus faecalis, Staphylococcus aureus, and Escherichia coli growth.