N. Sreenivas

Trace Level Determination of Mesityl Oxide and Diacetone Alcohol in Atazanavir Sulfate Drug Substance by a Gas Chromatography Method.

A capillary gas chromatography method with a short run time, using a flame ionization detector, has been developed for the quantitative determination of trace level analysis of mesityl oxide and diacetone alcohol in the atazanavir sulfate drug substance. The chromatographic method was achieved on a fused silica capillary column coated with 5% diphenyl and 95% dimethyl polysiloxane stationary phase (Rtx-5, 30 m x 0.53 mm x 5.0 µm). The run time was 20 min employing programmed temperature with a split mode (1:5) and was validated for specificity, sensitivity, precision, linearity, and accuracy. The detection and quantitation limits obtained for mesityl oxide and diacetone alcohol were 5 µg/g and 10 µg/g, respectively, for both of the analytes. The method was found to be linear in the range between 10 µg/g and 150 µg/g with a correlation coefficient greater than 0.999, and the average recoveries obtained in atazanavir sulfate were between 102.0% and 103.7%, respectively, for mesityl oxide and diacetone alcohol. The developed method was found to be robust and rugged. The detailed experimental results are discussed in this research paper.

A Simple and Sensitive RP-UPLC Method for the Simultaneous Determination of N-Hydroxybenzotriazole, Cinchonidine and 1,3-Dicyclohexyl Urea Contents in Fosinopril Sodium Drug Substance

A simple and sensitive reverse phase ultra performance liquid chromatography (RP-UPLC) method has been developed, optimized and validated for the simultaneous determination of N-Hydroxybenzotriazole (HOBt), Cinchonidine and 1,3-Dicyclohexyl urea (DCU) contents at low levels in fosinopril sodium drug substance. Efficient chromatographic separation was achieved on Acquity UPLC HSS C18 column, 100 mm long with 2.1 mm i.d., 1.8 µm particle diameter, thermo stated at 30°C. Gradient elution involving binary mixture of potassium dihydrogen orthophosphate (0.01M, pH:3.0±0.05 with ortho-phosphoric acid) and acetonitrile at a flow rate of 0.10 mL min-1 has been used. The analytes were monitored by photodiode array (PDA) detector set at 205 nm. The drug substance was subjected to stress conditions of hydrolysis, oxidation, photolysis, thermal and humidity degradation. The method was validated for specificity, sensitivity, linearity, precision, accuracy and solution stability. The limit of detection (LOD) and limit of quantification (LOQ) for HOBt, Cinchonidine and DCU were in the range of 0.85-3.52 ppm and 2.57-10.67 ppm, respectively. The average recoveries for HOBt, Cinchonidine and DCU are in the range of 98.1% to 102.6%. The method can be used for the routine quality control analysis of fosinopril sodium drug substance.