Na Qin

MIL-53(Fe) as a highly efficient bifunctional photocatalyst for the simultaneous reduction of Cr(VI) and oxidation of dyes

A bifunctional photocatalyst-Fe-benzenedicarboxylate (MIL-53(Fe)) has been synthesized successfully via a facile solvothermal method. The resulting MIL-53(Fe) photocatalyst exhibited an excellent visible light (λ≥ 420nm) photocatalytic activity for the reduction of Cr(VI), the reduction rate have reached about 100% after 40min of visible light irradiation, which has been more efficient than that of N-doped TiO2 (85%) under identical experimental conditions. Further experimental results have revealed that the photocatalytic activity of MIL-53(Fe) for the reduction of Cr(VI) can be drastically affected by the pH value of the reaction solution, the hole scavenger and atmosphere. Moreover, MIL-53(Fe) has exhibited considerable photocatalytic activity in the mixed systems (Cr(VI)/dyes). After 6h of visible light illumination, the reduction ratio of Cr(VI) and the degradation ratio of dyes have been exceed 60% and 80%, respectively. More significantly, the synergistic effect can also be found during the process of photocatalytic treatment of Cr(VI) contained wastewater under the same photocatalytic reaction conditions, which makes it a potential candidate for environmental restoration. Finally, a possible reaction mechanism has also been investigated in detail.

One-Dimensional CdS/TiO2 Nanofiber Composites as Efficient Visible-Light-Driven Photocatalysts for Selective Organic Transformation: Synthesis, Characterization, and Performance

CdS/TiO2 heterojunction nanofibers have been successfully synthesized through the photodeposition of CdS on 1D TiO2 nanofibers that were prepared via a facile electrospinning method. The as-synthesized samples showed high photocatalytic activities upon selectively oxidizing a series of alcohols into corresponding aldehydes under visible light irradiation. TEM observations revealed that CdS was closely grown on the TiO2 nanofibers. Moreover, it was found that the CdS/TiO2 nanofibers that were photodeposited for 4 h exhibited the highest catalytic activity, with a conversion of 22% and a selectivity of 99%, which were much higher than those of commercial CdS. In addition, we also discuss the photoabsorption performance and the reaction mechanism of the photocatalytic oxidation of alcohols.

Preparation of MIL-53(Fe)-Reduced Graphene Oxide Nanocomposites by a Simple Self-Assembly Strategy for Increasing Interfacial Contact: Efficient Visible-Light Photocatalysts

In this work, MIL-53(Fe)-reduced graphene oxide (M53-RGO) nanocomposites have been successfully fabricated by a facile and efficient electrostatic self-assembly strategy for improving the interfacial contact between RGO and the MIL-53(Fe). Compared with D-M53-RGO (direct synthesis of MIL-53(Fe)-reduced graphene oxide nanocomposites via one-pot solvothermal approach), M53-RGO nanocomposites exhibit improved photocatalytic activity compared with the D-M53-RGO under identical experimental conditions. After 80 min of visible light illumination (λ ≥ 420 nm), the reduction ratio of Cr(VI) is rapidly increased to 100%, which is also higher than that of reference sample (N-doped TiO2). More significantly, the M53-RGO nanocomposites are proven to perform as bifunctional photocatalysts with considerable activity in the mixed systems (Cr(VI)/dyes) under visible light, which made it a potential candidate for industrial wastewater treatment. Combining with photoelectrochemical analyses, it could be revealed that the introduction of RGO would minimize the recombination of photogenerated electron-hole pairs. Additionally, the effective interfacial contact between MIL-53(Fe) and RGO surface would further accelerate the transfer of photogenerated electrons, leading to the enhancement of photocatalytic activity of M53-RGO toward photocatalytic reactions. Finally, a possible photocatalytic reaction mechanism is also investigated in detail.

Electrostatically derived self-assembly of NH2-mediated zirconium MOFs with graphene for photocatalytic reduction of Cr(VI)

Novel photocatalysts RGO-UiO-66(NH2) were synthesized via an electrostatically derived self-assembly of UiO-66(NH2) with graphene, followed by hydrothermal reduction. Such nanocomposites exhibit enhanced photocatalytic activity for the reduction of Cr(VI) compared with the pristine UiO-66(NH2).

M@MIL-100(Fe) (M = Au, Pd, Pt) nanocomposites fabricated by a facile photodeposition process: Efficient visible-light photocatalysts for redox reactions in water

Proper design and preparation of high-performance and stable dual functional photocatalytic materials remains a significant objective of research. In this work, highly dispersed noble-metal nanoparticles (Au, Pd, Pt) were immobilized on MIL-100(Fe) (denoted M@MIL-100(Fe)) using a facile room-temperature photodeposition technique. The resulting M@MIL-100(Fe) (M = Au, Pd, and Pt) nanocomposites exhibited enhanced photoactivities toward photocatalytic degradation of methyl orange (MO) and reduction of heavy-metal Cr(VI) ions under visible-light irradiation (λ ≥ 420 nm) compared with blank-MIL-100(Fe). Combining these results with photoelectrochemical analyses revealed that noble-metal deposition can effectively improve the charge-separation efficiency of MIL-100(Fe) under visible-light irradiation. This phenomenon in turn leads to the enhancement of visible-light-driven photoactivity of M@MIL-100(Fe) toward photocatalytic redox reactions. In particular, the Pt@MIL-100(Fe) with an average Pt particle size of 2 nm exhibited remarkably enhanced photoactivities compared with those of M@MIL-100(Fe) (M = Au and Pd), which can be attributed to the integrative effect of the enhanced light absorption intensity and more efficient separation of the photogenerated charge carrier. In addition, possible photocatalytic reaction mechanisms are also proposed.