Naotake Takaishi

A convenient synthesis of long-chain 1-O-Alkyl glyceryl ethers

A convenient and economical procedure for synthesis of long-chain 1-O-alkyl glyceryl ethers (V) is described. Alkyl glycidyl ethers (II) which were derived from the reaction of alcohols (I) with epichlorohydrin using a phase transfer catalyst were first converted into the corresponding dioxolanes (III) or 1-O-alkyl-2,3-di-O-acetylglycerols (IV). Subsequent hydrolysis of the resultant products provided 1-O-alkyl glyceryl ethers (V) in high yields.

Ether lipids based on the glyceryl ether skeleton: Present state, future potential

Lipids from natural sources consist mainly of saponifiable substances, such as glycerides, along with some unsaponifiable lipids, some of which are ether lipids. Typical ether lipids are monoalkyl ethers of glycerin, also called alkyl/alkenyl glyceryl ethers. Alkyl/alkenyl glyceryl ethers have also been reported in marine organisms and in human feces. Several chemical syntheses of such ether lipids have been reported. Typical examples are alkyl glyceryl ether formation by the addition reaction of alkyl glycidyl ether and the telomerization reaction of butadiene with glycerin and a transition metal catalyst. Characteristic chemical structures, such as terpene alkyl glyceryl ethers, archaebacterial macrocyclic ether lipids, and glyceryl ethers of condensed cyclic planar molecules, have been obtained as well. Over the past few decades, industry has shown much interest in the chemistry and application of highly branched fatty acids. For example, isostearyl glyceryl ether (GE-IS) with methyl branching in the middle chain was already known, but it is now prepared at an industrial scale by proprietary alkyl glycidyl ether methods. The characteristic behavior of GE-IS toward water, such as formation of water-in-oil emulsions containing large amounts of water and of liquid crystals, has made it applicable for use in hair and skin-care cosmetics. Based on these studies and considerations, glyceryl ether lipids, which are rarely investigated, may become one of the most important and useful lipids in the industry.

Hydrogenation of carboxylic acids by rhenium-osmium bimetallic catalyst

Hydrogenation of carboxylic acids to alcohols at low temperature and under low pressure was achieved by using a new catalyst system, a rhenium-osmium bimetallic catalyst. The most active catalyst was prepared by the reductionof the corresponding metal oxides with hydrogen in the presence of succinic acid. Decanoic acid was hydrogenated to decanol in high conversions at 25∼100 atm and 100∼120°C. Decane was formed as a by-product by overreduction of the alcohol. The selectivity of alcohol was improved by the addition of thiophene as a modifier of the catalyst.

Cholesterol as synthetic building blocks for artificial lipids with characteristic physical, chemical and biological properties

Cholesterol is one of the most widely distributed natural materials and has a unique chemical structure such as a steroid skeleton. Many types of chemical transformations of cholesterol functional groups have been developed. There is an interest in the derivatization of cholesterol and to introduce alkyl branched fatty acids into the molecule. These have found applications in the formulation of cosmetics and toiletries over the past few decades. An extraordinary interesting case is related to cholesteryl esters and their use in gene therapy delivery systems. These results can be attributed to their potential for forming cell-mimic membranes, because cholesterol is the most important building block of living cell membranes. In terms of organic synthesis, cholesterol is a strategically useful material. A typical case is remote functionalization by chemical reactions or by biocatalysis. In the future, cholesterol should be considered as a key compound, a building block for the construction of artificial lipid-like membranes by self-assembly. Also, as cholesterol is one of the members of the fat and oil family, fat and oil chemists should study and develop cholesterol chemistry even further.

FUNCTIONS OF LIPIDS ON HUMAN SKIN

Abstract In order to clarify the roles of lipids in the water-holding property of stratum corneum, the forearm skin of healthy male volunteers was treated with acetone/ether (1/1) or sodium dodecyl sulfate (5%) for 1-30 min. A prolonged treatment period of 5-30 min produced a chapped and scaly appearance of the stratum corneum without any inflammatory reactions. Under these conditions, there was a marked decrease in the water-holding capacity of the stratum corneum accompanied by a selective loss of stratum corneum lipids such as cholesterol, cholesterol esters, and sphingolipids. Two daily applications of the isolated stratum corneum lipids to experimentally induced dry skins caused a significant increase of conductance, accompanied by a marked improvement in the level of scaling. Meanwhile, the isolated sebaceous lipids exhibited no significant recovery in both the conductance value and the scaling. Out of chroma-tographically separated fractions of the stratum corneum lipids, topical applications of ce...

Novel fluoride transfer in the reaction of tricyclic epoxides with boron trifluoride

Abstract Reaction of the tricyclic epoxides ( 1a ) and ( 1b ) with boron trifluoride etherate leads to fluorohydrins ( 2a ) and ( 2b ) derived in the novel fluoride transfer, whereas ( 1c ) undergoes isomerization to spiro ketone ( 3 ).

The Alkyl Glycidyl Ether as Synthetic Building Blocks

Alkyl glycidyl ether is one of the most useful key materials for industrial applications because the addition reaction of various kinds of nucleophilic reagents to the reactive epoxy bond of the glycidyl ethers has led to glyceryl ether derivatives. Glyceryl ether exhibits many interesting physical and pharmacological properties. The alkyl glycidyl ether can presently be produced at an industrial scale under the phase-transfer catalytic Williamson ether synthesis. We have reviwwed some addition reactions of the alkyl glycidyl ether and possibilities for use as the building blocks for the syntheses of surfactants, pharmaceuticals, etc. that contain glyceryl ether skeletons. Typical examples of alkyl glyceryl ether derivatives include: amino ether as cosmetic material, and isodiglycerin mono- and dialkyl ethers and triglycerin monoalkyl ether as a cosmetic or a pharmacologically useful material, respectively. Another interesting reaction is the rearrangement of the epoxy bond of the alkyl glycidyl ether, which gives alkoxy ketone in a one-pot synthesis.

Applications of phase-transfer catalytic reactions to fatty acids and their derivatives: Present state and future potential

Phase-transfer catalysts (PTC), which accelerate reactions between liquid(organic)-liquid(water) and liquidsolid heterogeneous states, have been investigated and developed. Several processes with PTC have succeeded in industrial processes involving fatty acids and their derivatives. For example, preparation of fatty alkyl glycidyl ethers, from which fatty alkyl glyceryl ethers and their derivatives can be obtained, has been carried out with PTC. However, some problems remain to be solved. For example, preparation of the fatty alkyl glycidyl ether by a PTC reaction was considered, but typical problems to be solved included: (i) how to reuse or recover the catalysts; (ii) how to control the heterogeneous reaction without obstacles to produce useful chemical materials; (iii) how to satisfy the environmental requirements for the catalysts; and (iv) are there more effective catalysts? We address these problems based on our own experiences with phase-transfer catalytic Williamson ether syntheses of fatty alkyl glycidyl ethers. Moreover, we describe recent developments in phase-transfer catalytic reactions related to oleochemistry, such as transition metal-catalyzed reactions of long-chain olefins in liquid(organic)-liquid(water) or liquid-solid heterogeneous states. Based on these results, we have considered the potential of PTC as a synthetic tool in oleochemistry.

Palladium-catalyzed acylation of activated alkenes with bridgehead acid chlorides

Abstract Bridgehead acid chlorides 1a and 1b react with activated alkenes 2 in the presence of a catalytic amount of palladium and 1 equiv of a tertiary amine. The reaction proceeds regio- and stereoselectively at the terminal carbon atoms to yield acylated alkenes 3 with E-configuration.

Palladium-catalyzed decarbonylation of tricyclic bridgehead acid chlorides

Abstract Decarbonylation of tricyclic bridgehead acid chlorides 1 and 4 with palladium catalyst in the presence of tri- n -butylamine proceeded at 130 °C to give exclusively stable disubstituted olefins 3 and 6 , with probable intermediacy of the bridgehead olefins 2 and 5 , respectively.