Nicola Macchioni

Quantitative evaluation by attenuated total reflectance infrared (ATR-FTIR) spectroscopy of the chemical composition of decayed wood preserved in waterlogged conditions.

This paper reports on the assessment of lignin and holocellulose by means of ATR-FTIR analysis and multivariate PLS regression. The analysis was conducted on 59 samples coming from different excavations where wood had been preserved in waterlogged conditions. A range of results from different wood species (Alnus sp.p., Cupressus sempervirens, Larix decidua, Picea abies, Pinus sp.p., Quercus sp.p., Ulmus sp.p.), states of preservation, waterlogged environments, and burial times are presented. A calibration model was selected after comparing different reference data (samples extracted and not-extracted, and ash-rich and ash-free bases of calculation for the calibration values), and two different post-acquisition spectroscopic manipulations (both in terms of normalisation procedures and of spectral ranges used for the calibration). Results showed that the best models were different depending on which considered component (lignin or holocellulose) was measured and to which data set (softwood or hardwood) the samples belonged. It is shown that the predictive ability of the models is affected by high ash content (too contaminated samples had to be excluded in order to attain good results, because of excessive overlapping of bands related to the inorganic fraction) but not by the preliminary extraction of sample. Furthermore, the stability of best models is also demonstrated and a procedure of external validation carried out on an external set of samples confirmed the general validity of the identified models.

Argentinean native wood species: Physical and mechanical characterization of some Prosopis species and Acacia aroma (Leguminosae; Mimosoideae).

One of the problems in marketing the wood of Prosopis and Acacia is the lack of standardization of its qualities. The aim of this paper was to obtain a preliminary detection of some properties of the wood of four species of the genus Prosopis and one species from Acacia grown in Argentina. To accomplish this objective, the content of extractives and some physical and mechanical characteristics were analyzed. The density rho(12) of all the species indicates that these woods range from heavy to very heavy (>or=0.69g/cm(3)). The total volumetric shrinkage values are low, less than 10%, for all species. The parallel compression strength and the shear strength for all the species indicate a very resistant wood (>or=46.93MPa and >or=18.35MPa, respectively). Brinell hardness was higher than 5kg/mm(2) in all cases. The species with less content of extractives is P. ruscifolia (approximately 9% of anhydrous mass) whereas A. aroma was the one with the greatest content (approximately 25% of anhydrous mass in the heartwood).

Measurements of fungal wood decay on Scots pine and beech by means of X-ray microdensitometry

In this work, we present a fast and promising method to evaluate the natural durability of wood based on X-ray microdensitometry. Tested on beech and Scots pine wood samples, our findings show that this methodology and the traditional EN standards methodology based on mass loss are strongly correlated. X-ray methodology is less time consuming (we can detect the effectiveness of the attack within 5–6xa0weeks) and less expensive (very cheap plastic Petri dishes instead of the expensive glass Kolle flasks); moreover, the proposed method allows to thoroughly examine the phases and the kinetics of the fungal attack, and to investigate the spatial repartition of the attack within the samples due to the low thickness of the sample.

Provenance effect on the ring structure of teak (Tectona grandis L.f.) wood by X-ray microdensitometry

Abstract• ContextTeak (Tectona grandis L.f.) is a tropical timber which is appreciated worldwide and has been planted into many regions of the tropics. It is essential to obtain information about provenance variation of basic wood properties in order to preserve the wood quality of end-products derived from future plantations. Figuring is one of the wood characteristics valued for panelling and furniture and it is an important parameter to evaluate the quality of teak wood. The ring structure affects within-ring and between-ring colour variation and, therefore, the figure of wood and the related aesthetical aspects.• MethodsBy means of microdensity profiles, we constructed a segmented linear model that depicts the anatomical structure of the rings. It effectively distinguished ring porous and diffuse porous rings, leading to the development of an efficient ring porosity index, further used to study the provenance variation of the ring structure.• ResultsA significant provenance effect was detected for both wood density variables and ring anatomical structure. Although no correlation was detected between the ring structure and the precipitation level at the provenance origin, the two provenances from very wet climates were distinguished by low values of ring porosity index (diffuse porous ring).• ConclusionThe progenies in our study, collected from origins with various climates, planted in a new climate, seem to maintain to some extent the wood characteristics typical of their mother trees, suggesting that these ring characteristics may be inherited.

How an Accurate Surface Observation Can Help in the Interpretation of an Ancient Timber Structure: The Example of the Valdese Church in Florence

The Valdese church of Florence was built in the second half of the XIX century as the Anglican Church of the local rich British community, reaching the actual status of Valdese church in 1967.

A Peculiar Spanish Timber Floor, the "Revoltón": A Diagnostic Example at the "Palacio del Marqués de Benicarló"

The paper deals with the application of the Italian method for assessing on-site and diagnosing timber elements to a distinctive Spanish type of horizontal structure called “revoltón” i.e. jack arch floor. As in Spain does not exist a specific regulation for the on-site diagnosis of timber elements, this analysis was performed according to the Italian standard UNI 11119. Due to the peculiar features of the jack arch floor some modifications were applied to the method.During spring 2012 the authors had the opportunity to carry out a pilot project by making a diagnostic analysis on a whole three stories building. The building, “Palacio del Marqués de Benicarló”, located in Spain in the town of Benicarló, between Barcelona and Valencia, was erected during the second half of the XVIII century. It maintains the original internal distribution and structure, and it is characterized by precious ceramic decorations on walls and floors. All the horizontal structures studied inside the palace were jack arch floor except the roof structure that was also made of timber.The results of the project described in the paper clarify the specific problems of the horizontal structures and the roof surveyed during the fieldwork. These results are accompanied by several plans that represent the information recovered on-site and lead to a complete assessment of the structures. The plans include the grading based on wood defects, the local moisture content of wood, the superficial and inner decay due to insects and rot and the deformation of the joists. In this way it was possible to locate the areas of the palace where more problems were concentrated, and better understand the causes and origin of the damages.