Nihar R. Pradhan

Controlled synthesis and transfer of large-area WS2 sheets: from single layer to few layers.

The isolation of few-layered transition metal dichalcogenides has mainly been performed by mechanical and chemical exfoliation with very low yields. In this account, a controlled thermal reduction-sulfurization method is used to synthesize large-area (~1 cm(2)) WS2 sheets with thicknesses ranging from monolayers to a few layers. During synthesis, WOx thin films are first deposited on Si/SiO2 substrates, which are then sulfurized (under vacuum) at high temperatures (750-950 °C). An efficient route to transfer the synthesized WS2 films onto different substrates such as quartz and transmission electron microscopy (TEM) grids has been satisfactorily developed using concentrated HF. Samples with different thicknesses have been analyzed by Raman spectroscopy and TEM, and their photoluminescence properties have been evaluated. We demonstrated the presence of single-, bi-, and few-layered WS2 on as-grown samples. It is well known that the electronic structure of these materials is very sensitive to the number of layers, ranging from indirect band gap semiconductor in the bulk phase to direct band gap semiconductor in monolayers. This method has also proved successful in the synthesis of heterogeneous systems of MoS2 and WS2 layers, thus shedding light on the controlled production of heterolayered devices from transition metal chalcogenides.

New First Order Raman-active Modes in Few Layered Transition Metal Dichalcogenides

Although the main Raman features of semiconducting transition metal dichalcogenides are well known for the monolayer and bulk, there are important differences exhibited by few layered systems which have not been fully addressed. WSe2 samples were synthesized and ab-initio calculations carried out. We calculated phonon dispersions and Raman-active modes in layered systems: WSe2, MoSe2, WS2 and MoS2 ranging from monolayers to five-layers and the bulk. First, we confirmed that as the number of layers increase, the E′, E″ and E2g modes shift to lower frequencies, and the A′1 and A1g modes shift to higher frequencies. Second, new high frequency first order A′1 and A1g modes appear, explaining recently reported experimental data for WSe2, MoSe2 and MoS2. Third, splitting of modes around A′1 and A1g is found which explains those observed in MoSe2. Finally, exterior and interior layers possess different vibrational frequencies. Therefore, it is now possible to precisely identify few-layered STMD.

CVD-grown monolayered MoS2 as an effective photosensor operating at low-voltage

We report the fabrication of a photosensor based on as-grown single crystal monolayers of MoS2 synthesized by chemical vapor deposition (CVD). The measurements were performed using Au/Ti leads in a two terminal configuration on CVD-grown MoS2 on a SiO2/Si substrate. The device was operated in air at room temperature at low bias voltages ranging from −2 V to 2 V and its sensing capabilities were tested for two different excitation wavelengths (514.5 nm and 488 nm). The responsivity reached 1.1 mA W−1 when excited with a 514.5 nm laser at a bias of 1.5 V. This responsivity is one order of magnitude larger than that reported from photo devices fabricated using CVD-grown multilayered WS2. A rectifying-effect was observed for the optically excited current, which was four times larger in the direct polarization bias when compared to the reverse bias photocurrent. Such rectifying behavior can be attributed to the asymmetric electrode placement on the triangular MoS2 monocrystal. It is envisioned that these components could eventually be used as efficient and low cost photosensors based on CVD-grown transition metal dichalcogenide monolayers.

Intrinsic carrier mobility of multi-layered MoS2 field-effect transistors on SiO2

By fabricating and characterizing multi-layered MoS2-based field-effect transistors in a four terminal configuration, we demonstrate that the two terminal-configurations tend to underestimate the carrier mobility μ due to the Schottky barriers at the contacts. For a back-gated two-terminal configuration, we observe mobilities as high as 91 cm2 V−1 s−1 which is considerably smaller than 306.5 cm2 V−1 s−1 as extracted from the same device when using a four-terminal configuration. This indicates that the intrinsic mobility of MoS2 on SiO2 is significantly larger than the values previously reported, and provides a quantitative method to evaluate the charge transport through the contacts.

Hall and field-effect mobilities in few layered p-WSe2 field-effect transistors

Here, we present a temperature (T) dependent comparison between field-effect and Hall mobilities in field-effect transistors based on few-layered WSe2 exfoliated onto SiO2. Without dielectric engineering and beyond a T-dependent threshold gate-voltage, we observe maximum hole mobilities approaching 350 cm2/Vs at T = 300 K. The hole Hall mobility reaches a maximum value of 650 cm2/Vs as T is lowered below ~150 K, indicating that insofar WSe2-based field-effect transistors (FETs) display the largest Hall mobilities among the transition metal dichalcogenides. The gate capacitance, as extracted from the Hall-effect, reveals the presence of spurious charges in the channel, while the two-terminal sheet resistivity displays two-dimensional variable-range hopping behavior, indicating carrier localization induced by disorder at the interface between WSe2 and SiO2. We argue that improvements in the fabrication protocols as, for example, the use of a substrate free of dangling bonds are likely to produce WSe2-based FETs displaying higher room temperature mobilities, i.e. approaching those of p-doped Si, which would make it a suitable candidate for high performance opto-electronics.

Atypical Exciton–Phonon Interactions in WS2 and WSe2 Monolayers Revealed by Resonance Raman Spectroscopy

Resonant Raman spectroscopy is a powerful tool for providing information about excitons and exciton-phonon coupling in two-dimensional materials. We present here resonant Raman experiments of single-layered WS2 and WSe2 using more than 25 laser lines. The Raman excitation profiles of both materials show unexpected differences. All Raman features of WS2 monolayers are enhanced by the first-optical excitations (with an asymmetric response for the spin-orbit related XA and XB excitons), whereas Raman bands of WSe2 are not enhanced at XA/B energies. Such an intriguing phenomenon is addressed by DFT calculations and by solving the Bethe-Salpeter equation. These two materials are very similar. They prefer the same crystal arrangement, and their electronic structure is akin, with comparable spin-orbit coupling. However, we reveal that WS2 and WSe2 exhibit quite different exciton-phonon interactions. In this sense, we demonstrate that the interaction between XC and XA excitons with phonons explains the different Raman responses of WS2 and WSe2, and the absence of Raman enhancement for the WSe2 modes at XA/B energies. These results reveal unusual exciton-phonon interactions and open new avenues for understanding the two-dimensional materials physics, where weak interactions play a key role coupling different degrees of freedom (spin, optic, and electronic).

Pronounced Photovoltaic Response from Multilayered Transition-Metal Dichalcogenides PN-Junctions

Transition metal dichalcogenides (TMDs) are layered semiconductors with indirect band gaps comparable to Si. These compounds can be grown in large area, while their gap(s) can be tuned by changing their chemical composition or by applying a gate voltage. The experimental evidence collected so far points toward a strong interaction with light, which contrasts with the small photovoltaic efficiencies η ≤ 1% extracted from bulk crystals or exfoliated monolayers. Here, we evaluate the potential of these compounds by studying the photovoltaic response of electrostatically generated PN-junctions composed of approximately 10 atomic layers of MoSe2 stacked onto the dielectric h-BN. In addition to ideal diode-like response, we find that these junctions can yield, under AM-1.5 illumination, photovoltaic efficiencies η exceeding 14%, with fill factors of ~70%. Given the available strategies for increasing η such as gap tuning, improving the quality of the electrical contacts, or the fabrication of tandem cells, our study suggests a remarkable potential for photovoltaic applications based on TMDs.

Role of spin-orbit coupling and evolution of the electronic structure of WTe 2 under an external magnetic field

Here, we present a detailed study on the temperature and angular dependence of the Shubnikovde-Haas (SdH) effect in the semi-metal WTe2. This compound was recently shown to display a very large non-saturating magnetoresistance which was attributed to nearly perfectly compensated densities of electrons and holes. We observe four fundamental SdH frequencies and attribute them to spin-orbit split, electron- and hole-like, Fermi surface (FS) cross-sectional areas. Their angular dependence is mildly consistent with ellipsoidal FSs with volumes implying an excess of � 7 % in the density of electrons with respect to that of the holes. Nevertheless, we show that density functional theory (DFT) calculations can reasonably describe the experimentally determined electron FSs but fail to accurately describe the hole FSs. When their cross-sectional areas are adjusted to reflect the experimental data, the resulting volumes of the electron/hole FSs obtained from the DFT would imply a strong imbalance between the densities of electrons and holes. We observe a severe fieldinduced renormalization of the effective masses suggesting that the electronic structure of WTe2 is particularly sensitive to the Zeeman-effect. By combining the results of our DFT calculations with our analysis of the experimental results we conclude that WTe2 is unlikely to remain compensated under an external field.

Fabrication and characterization of ultraviolet photosensors from ZnO nanowires prepared using chemical bath deposition method

Highly crystalline zinc oxide (ZnO) nanowires (NWs) were synthesized through chemical bath deposition (CBD) method by using a simple seeding technique. The process includes dispersion of commercially available ZnO nanoparticles through spraying on a desired substrate prior to the CBD growth. A typical growth period of 16 h produced ZnO NW assemblies with an average diameter of ∼45 nm and lengths of 1–1.3 μm, with an optical band gap of ∼3.61 eV. The as-prepared ZnO NWs were photoactive under ultra violet (UV) illumination. Photodetector devices fabricated using these NW assemblies demonstrated a high photoresponse factor of ∼40 and 120 at room temperature under moderate UV illumination power of ∼250 μW/cm2. These findings indicate the possibility of using ZnO NWs, grown using the simple method discussed in this paper, for various opto-electronic applications.

Photoconductivity of few-layered p-WSe2 phototransistors via multi-terminal measurements

Recently, two-dimensional materials and in particular transition metal dichalcogenides (TMDs) were extensively studied because of their strong light-matter interaction and the remarkable optoelectronic response of their field-effect transistors (FETs). Here, we report a photoconductivity study from FETs built from few-layers of p-WSe2 measured in a multi-terminal configuration under illumination by a 532 nm laser source. The photogenerated current was measured as a function of the incident optical power, of the drain-to-source bias and of the gate voltage. We observe a considerably larger photoconductivity when the phototransistors were measured via a four-terminal configuration when compared to a two-terminal one. For an incident laser power of 248 nW, we extract 18 A/W and ~4000% for the two-terminal responsivity (R) and the concomitant external quantum efficiency (EQE) respectively, when a bias voltage Vds = 1 V and a gate voltage Vbg = 10 V are applied to the sample. R and EQE are observed to increase by 370% to ~85 A/W and ~20000% respectively, when using a four-terminal configuration. Thus, we conclude that previous reports have severely underestimated the optoelectronic response of transition metal dichalcogenides, which in fact reveals a remarkable potential for photosensing applications.