Nikolay Zhelev

Modification of the He3 phase diagram by anisotropic disorder

Motivated by the recent prediction that uniaxially compressed aerogel can stabilize the anisotropic A phase over the isotropic B phase, we measure the pressure dependent superfluid fraction of (3)He entrained in 10% axially compressed, 98% porous aerogel. We observe that a broad region of the temperature-pressure phase diagram is occupied by the metastable A phase. The reappearance of the A phase on warming from the B phase, before superfluidity is extinguished at T(c), is in contrast to its absence in uncompressed aerogel. The phase diagram is modified from that of pure (3)He, with the disappearance of the polycritical point (PCP) and the appearance of a region of A phase extending below the PCP of bulk (3)He, even in zero applied magnetic field. The expected alignment of the A phase texture by compression is not observed.

Observation of a new superfluid phase for 3 He embedded in nematically ordered aerogel

In bulk superfluid 3He at zero magnetic field, two phases emerge with the B-phase stable everywhere except at high pressures and temperatures, where the A-phase is favoured. Aerogels with nanostructure smaller than the superfluid coherence length are the only means to introduce disorder into the superfluid. Here we use a torsion pendulum to study 3He confined in an extremely anisotropic, nematically ordered aerogel consisting of ∼10 nm-thick alumina strands, spaced by ∼100 nm, and aligned parallel to the pendulum axis. Kinks in the development of the superfluid fraction (at various pressures) as the temperature is varied correspond to phase transitions. Two such transitions are seen in the superfluid state, and we identify the superfluid phase closest to Tc at low pressure as the polar state, a phase that is not seen in bulk 3He.

Study of Superfluid ^3He Under Nanoscale Confinement

We review recent experiments in which superfluid 3 He has been studied under highly controlled confinement in nanofluidic sample chambers. We discuss the experimental challenges and their resolution. These methods open the way to a systematic investigation of the superfluidity of 3 He films, and the surface and edge

The A-B transition in superfluid helium-3 under confinement in a thin slab geometry

The influence of confinement on the phases of superfluid helium-3 is studied using the torsional pendulum method. We focus on the transition between the A and B phases, where the A phase is stabilized by confinement and a spatially modulated stripe phase is predicted at the A–B phase boundary. Here we discuss results from superfluid helium-3 contained in a single 1.08-μm-thick nanofluidic cavity incorporated into a high-precision torsion pendulum, and map the phase diagram between 0.1 and 5.6 bar. We observe only small supercooling of the A phase, in comparison to bulk or when confined in aerogel, with evidence for a non-monotonic pressure dependence. This suggests that an intrinsic B-phase nucleation mechanism operates under confinement. Both the phase diagram and the relative superfluid fraction of the A and B phases, show that strong coupling is present at all pressures, with implications for the stability of the stripe phase.

Transfer printing of CVD graphene FETs on patterned substrates

We describe a simple and scalable method for the transfer of CVD graphene for the fabrication of field effect transistors. This is a dry process that uses a modified RCA-cleaning step to improve the surface quality. In contrast to conventional fabrication routes where lithographic steps are performed after the transfer, here graphene is transferred to a pre-patterned substrate. The resulting FET devices display nearly zero Dirac voltage, and the contact resistance between the graphene and metal contacts is on the order of 910 ± 340 Ω μm. This approach enables formation of conducting graphene channel lengths up to one millimeter. The resist-free transfer process provides a clean graphene surface that is promising for use in high sensitivity graphene FET biosensors.

Fabrication of microfluidic cavities using Si-to-glass anodic bonding

We demonstrate the fabrication of ∼1.08 μm deep microfluidic cavities with characteristic size as large as 7 mm × 11 mm or 11 mm diameter, using a silicon-glass anodic bonding technique that does not require posts to act as separators to define cavity height. Since the phase diagram of 3He is significantly altered under confinement, posts might act as pinning centers for phase boundaries. The previous generation of cavities relied on full wafer-bonding which is more prone to failure and requires dicing post-bonding, whereas these cavities are made by bonding a pre-cut piece of Hoya SD-2 glass to a patterned piece of silicon in which the cavity is defined by etching. Anodic bonding was carried out at 425 °C with 200 V, and we observe that pressurizing the cavity to failure (>30 bars pressure) results in glass breaking, rather than the glass-silicon bond separation. In this article, we discuss the detailed fabrication of the cavity, its edges, and details of the junction between the coin silver fill line and the silicon base of the cavity that enables a low internal-friction joint. This feature is important for mass coupling torsional oscillator experimental assays of the superfluid inertial contribution where a high quality factor (Q) improves frequency resolution. The surface preparation that yields well-characterized smooth surfaces to eliminate pinning sites, the use of transparent glass as a cover permitting optical access, low temperature capability, and attachment of pressure-capable ports for fluid access may be features that are important in other applications.

Study of Superfluid 3 He Under Nanoscale Confinement A New Approach to the Investigation of Superfluid 3 He Films

We review recent experiments in which superfluid 3 He has been studied under highly controlled confinement in nanofluidic sample chambers. We discuss the experimental challenges and their resolution. These methods open the way to a systematic investigation of the superfluidity of 3 He films, and the surface and edge

Dissipation signatures of the normal and superfluid phases in torsion pendulum experiments with He 3 in aerogel

This work was supported by the National Science Foundation grants: DMR-1202991 and DMR-1103625.

Study of Superfluid \(^3\)He Under Nanoscale Confinement

We review recent experiments in which superfluid 3 He has been studied under highly controlled confinement in nanofluidic sample chambers. We discuss the experimental challenges and their resolution. These methods open the way to a systematic investigation of the superfluidity of 3 He films, and the surface and edge