Osama Ahmed Hassan

The 2007 rift valley Fever outbreak in Sudan

Rift Valley fever (RVF) is a neglected, emerging, mosquito-borne disease with severe negative impact on human and animal health and economy. RVF is caused by RVF virus (RVFV) affecting humans and a wide range of animals. The virus is transmitted through bites from mosquitoes and exposure to viremic blood, body fluids, or tissues of infected animals. During 2007 a large RVF outbreak occurred in Sudan with a total of 747 confirmed human cases including 230 deaths (case fatality 30.8%); although it has been estimated 75,000 were infected. It was most severe in White Nile, El Gezira, and Sennar states near to the White Nile and the Blue Nile Rivers. Notably, RVF was not demonstrated in livestock until after the human cases appeared and unfortunately, there are no records or reports of the number of affected animals or deaths. Ideally, animals should serve as sentinels to prevent loss of human life, but the situation here was reversed. Animal contact seemed to be the most dominant risk factor followed by animal products and mosquito bites. The Sudan outbreak followed an unusually heavy rainfall in the country with severe flooding and previous studies on RVF in Sudan suggest that RVFV is endemic in parts of Sudan. An RVF outbreak results in human disease, but also large economic loss with an impact beyond the immediate influence on the directly affected agricultural producers. The outbreak emphasizes the need for collaboration between veterinary and health authorities, entomologists, environmental specialists, and biologists, as the best strategy towards the prevention and control of RVF.

Learning theories and assessmant methodologies : an engineering educational perspective

This paper attempts to critically review theories of learning from the perspective of engineering education in order to align relevant assessment methods with each respective learning theory, considering theoretical aspects and practical observations and reflections. The role of formative assessment, taxonomies, peer learning and educational policy as regards promoting the learning of engineering is discussed. It is suggested that an integrated learning method in which cognitive levels, social factors and teamwork and behaviouristic elements are integrated will optimise the learning process on an engineering course. Moreover, assessment of learning should not be isolated from views of teaching and the learning methods employed by the university teacher.

A need for One Health approach : lessons learned from outbreaks of Rift Valley fever in Saudi Arabia and Sudan

Introduction Rift Valley fever (RVF) is an emerging viral zoonosis that impacts human and animal health. It is transmitted from animals to humans directly through exposure to blood, body fluids, or tissues of infected animals or via mosquito bites. The disease is endemic to Africa but has recently spread to Saudi Arabia and Yemen. Our aim was to compare two major outbreaks of RVF in Saudi Arabia (2000) and Sudan (2007) from a One Health perspective. Methods Using the terms ‘Saudi Arabia’, ‘Sudan’, and ‘RVF’, articles were identified by searching PubMed, Google Scholar, and web pages of international organizations as well as local sources in Saudi Arabia and Sudan. Results The outbreak in Saudi Arabia caused 883 human cases, with a case fatality rate of 14% and more than 40,000 dead sheep and goats. In Sudan, 698 human cases of RVF were recognized (case fatality, 31.5%), but no records of affected animals were available. The ecology and environment of the affected areas were similar with irrigation canals and excessive rains providing an attractive habitat for mosquito vectors to multiply. The outbreaks resulted in livestock trade bans leading to a vast economic impact on the animal market in the two countries. The surveillance system in Sudan showed a lack of data management and communication between the regional and federal health authorities, while in Saudi Arabia which is the stronger economy, better capacity and contingency plans resulted in efficient countermeasures. Studies of the epidemiology and vectors were also performed in Saudi Arabia, while in Sudan these issues were only partly studied. Conclusion We conclude that a One Health approach is the best option to mitigate outbreaks of RVF. Collaboration between veterinary, health, and environmental authorities both on national and regional levels is needed.

An Integrated Management Approach To Designing Sustainable Buildings

This article advances building sustainability theory by relating quality and environmental methodologies to building construction. The sustainability criteria and indicators are first defined and then linked to the integration problem. For designing for sustainability, widely-used methodologies, such as total quality management (TQM), life cycle analysis (LCA), life-cycle cost analysis (LCCA), value-focused thinking (VFT), benchmarking, and others are presented. Key concepts that contribute to sustainable building design and construction are found. These concepts are arranged by construction stages and activities, and the common areas for integration are discussed at the level of specific products and processes as well as at the construction company level.

A VALUE-FOCUSED THINKING APPROACH FOR THE ENVIRONMENTAL MANAGEMENT OF BUILDINGS CONSTRUCTION

This paper attempts to adapt the value-focused thinking approach to the decision problems in the field of environmental management of buildings construction. A qualitative value model based on the results of life cycle assessment is presented. The model is applied on a case study in which a decision should be made on three types of roof structures: wood, steel and concrete. It is found that the roof structure made of wood is the most compatible option with respect to the environmental requirements of buildings construction. Thus, the value-focused thinking model can be used in different situations to analyze what management actions will be most effective to maximise the fulfillment of the environmental requirements of building standards.

ASSESSMENT OF FOOTFALL-INDUCED VIBRATIONS IN TIMBER AND LIGHTWEIGHT COMPOSITE FLOORS

In this paper, the footfall-induced vibrations in typical timber and lightweight composite floors in residential buildings are investigated. The two-floor structures have approximately comparable distributed mass and that the transverse flexural stiffnesses of the two structures are not substantially different. An analysis is carried out to assess the floor acceptability of the two structures, based upon derived expressions as well as some design codes and guidelines such as the Eurocode. For the analysis, two cases are considered for each floor structure: a composite action and noncomposite action. It has been shown that use of composite action, under certain conditions, has more advantages than its noncomposite counterpart with respect to the floor acceptability for general residential applications. Moreover, the limitations of the different criteria of the codes, guidelines for assessing floor vibrations in timber and lightweight floor structures, and possible improvements of these criteria are discussed in this paper.

Methods for air tightness analysis for residential buildings in Nordic countries

Envelope air tightness is one factor that has impact on the energy performance ofbuildings. The goals of the directive 2010/31/EU, on energy performance ofbuildings, raise the importance of buildin ...

Ethnic groups' knowledge, attitude and practices and Rift Valley fever exposure in Isiolo County of Kenya

Rift Valley fever (RVF) is an emerging mosquito-borne viral hemorrhagic fever in Africa and the Arabian Peninsula, affecting humans and livestock. For spread of infectious diseases, including RVF, knowledge, attitude and practices play an important role, and the understanding of the influence of behavior is crucial to improve prevention and control efforts. The objective of the study was to assess RVF exposure, in a multiethnic region in Kenya known to experience RVF outbreaks, from the behavior perspective. We investigated how communities in Isiolo County, Kenya were affected, in relation to their knowledge, attitude and practices, by the RVF outbreak of 2006/2007. A cross-sectional study was conducted involving 698 households selected randomly from three different ethnic communities. Data were collected using a structured questionnaire regarding knowledge, attitudes and practices that could affect the spread of RVF. In addition, information was collected from the communities regarding the number of humans and livestock affected during the RVF outbreak. This study found that better knowledge about a specific disease does not always translate to better practices to avoid exposure to the disease. However, the high knowledge, attitude and practice score measured as a single index of the Maasai community may explain why they were less affected, compared to other investigated communities (Borana and Turkana), by RVF during the 2006/2007 outbreak. We conclude that RVF exposure in Isiolo County, Kenya during the outbreak was likely determined by the behavioral differences of different resident community groups. We then recommend that strategies to combat RVF should take into consideration behavioral differences among communities.

The One Health approach to identify knowledge, attitudes and practices that affect community involvement in the control of Rift Valley fever outbreaks

Rift Valley fever (RVF) is a viral mosquito-borne disease with the potential for global expansion, causes hemorrhagic fever, and has a high case fatality rate in young animals and in humans. Using a cross-sectional community-based study design, we investigated the knowledge, attitudes and practices of people living in small village in Sudan with respect to RVF outbreaks. A special One Health questionnaire was developed to compile data from 235 heads of household concerning their knowledge, attitudes, and practices with regard to controlling RVF. Although the 2007 RVF outbreak in Sudan had negatively affected the participants’ food availability and livestock income, the participants did not fully understand how to identify RVF symptoms and risk factors for both humans and livestock. For example, the participants mistakenly believed that avoiding livestock that had suffered spontaneous abortions was the least important risk factor for RVF. Although the majority noticed an increase in mosquito population during the 2007 RVF outbreak, few used impregnated bed nets as preventive measures. The community was reluctant to notify the authorities about RVF suspicion in livestock, a sentinel for human RVF infection. Almost all the respondents stressed that they would not receive any compensation for their dead livestock if they notified the authorities. In addition, the participants believed that controlling RVF outbreaks was mainly the responsibility of human health authorities rather than veterinary authorities. The majority of the participants were aware that RVF could spread from one region to another within the country. Participants received most their information about RVF from social networks and the mass media, rather than the health system or veterinarians. Because the perceived role of the community in controlling RVF was fragmented, the probability of RVF spread increased.

Vibration of axially loaded and partially interacting composite beams

The vibrations of axially loaded composite beams with partial interaction are considered. The equations of motion and the pertaining boundary conditions are derived from Hamiltons principle. Mainly free — but also forced — vibrations are considered. The natural frequencies are calculated as a function of the axial force and the stiffness of the interaction between the layers. The analytical result obtained for the eigenfrequencies of the simply supported beam is taken as a starting point for an approximation of the eigenfrequencies of beams subject to other boundary conditions. The proposed approximation — which has no numerical fitting parameters — is shown to be in good agreement with the exact solutions, especially for the case of a beam clamped at both ends.