P. de Marcillac

Planck pre-launch status: The HFI instrument, from specification to actual performance

Context. The High Frequency Instrument (HFI) is one of the two focal instruments of the Planck mission. It will observe the whole sky in six bands in the 100 GHz-1 THz range. Aims: The HFI instrument is designed to measure the cosmic microwave background (CMB) with a sensitivity limited only by fundamental sources: the photon noise of the CMB itself and the residuals left after the removal of foregrounds. The two high frequency bands will provide full maps of the submillimetre sky, featuring mainly extended and point source foregrounds. Systematic effects must be kept at negligible levels or accurately monitored so that the signal can be corrected. This paper describes the HFI design and its characteristics deduced from ground tests and calibration. Methods: The HFI instrumental concept and architecture are feasible only by pushing new techniques to their extreme capabilities, mainly: (i) bolometers working at 100 mK and absorbing the radiation in grids; (ii) a dilution cooler providing 100 mK in microgravity conditions; (iii) a new type of AC biased readout electronics and (iv) optical channels using devices inspired from radio and infrared techniques. Results: The Planck-HFI instrument performance exceeds requirements for sensitivity and control of systematic effects. During ground-based calibration and tests, it was measured at instrument and system levels to be close to or better than the goal specification.

Planck pre-launch status: High Frequency Instrument polarization calibration

The High Frequency Instrument of Planck will map the entire sky in the millimeter and sub-millimeter domain from 100 to 857 GHz with unprecedented sensitivity to polarization (ΔP/Tcmb ∼ 4 × 10 −6 for P either Q or U and Tcmb � 2.7 K) at 100, 143, 217 and 353 GHz. It will lead to major improvements in our understanding of the cosmic microwave background anisotropies and polarized foreground signals. Planck will make high resolution measurements of the E-mode spectrum (up to � ∼ 1500) and will also play a prominent role in the search for the faint imprint of primordial gravitational waves on the CMB polarization. This paper addresses the effects of calibration of both temperature (gain) and polarization (polarization efficiency and detector orientation) on polarization measurements. The specific requirements on the polarization parameters of the instrument are set and we report on their pre-flight measurement on HFI bolometers. We present a semi-analytical method that exactly accounts for the scanning strategy of the instrument as well as the combination of different detectors. We use this method to propagate errors through to the CMB angular power spectra in the particular case of Planck-HFI, and to derive constraints on polarization parameters. We show that in order to limit the systematic error to 10% of the cosmic variance of the E-mode power spectrum, uncertainties in gain, polarization efficiency and detector orientation must be below 0.15%, 0.3% and 1 ◦ respectively. Pre-launch ground measurements reported in this paper already fulfill these requirements.

ALPHA/GAMMA DISCRIMINATION WITH A CAF2(EU) TARGET BOLOMETER OPTICALLY COUPLED TO A COMPOSITE INFRARED BOLOMETER

Abstract On account of its qualities for dark matter research, a 300 mg luminescent CaF 2 (Eu) bolometer light-coupled to an infrared sapphire bolometer has been successfully investigated. At a working temperature of about 130 mK, a discrimination between alpha particles and gamma irradiation has been achieved. The rejection power as a function of energy is given. We finally discuss an extrapolation of our results to CaF 2 (Eu) targets of several grams and lower working temperatures.

Purification of molybdenum, growth and characterization of medium volume ZnMoO4 crystals for the LUMINEU program

The LUMINEU program aims at performing a pilot experiment on neutrinoless double beta decay of 100Mo using radiopure ZnMoO4 crystals operated as cryogenic scintillating bolometers. Growth of high quality radiopure crystals is a complex task, since there are no commercial molybdenum compounds available with the required level of purity and radioactive contamination. This paper discusses approaches to purify molybdenum and synthesize compounds for high quality radiopure ZnMoO4 crystal growth. A combination of a double sublimation (with addition of zinc molybdate) with subsequent recrystallization in aqueous solutions (using zinc molybdate as a collector) was used. Zinc molybdate crystals up to 1.5 kg were grown by the low-thermal-gradient Czochralski technique; their optical, luminescent, diamagnetic, thermal and bolometric properties were tested.

First results of the ROSEBUD dark matter experiment

Abstract ROSEBUD (Rare Objects SEarch with Bolometers UndergrounD) is an experiment which attempts to detect low mass weak interacting massive particles through their elastic scattering off Al and O nuclei. It consists of three small sapphire bolometers (of a total mass of 100 g) with NTD-Ge sensors in a dilution refrigerator operating at 20 mK in the Canfranc Underground Laboratory. We report in this paper the results of several runs (of about 10 days each) with successively improved energy thresholds, and the progressive background reduction obtained by improvement of the radiopurity of the components and subsequent modifications in the experimental assembly, including the addition of old lead shields. Mid-term plans and perspectives of the experiment are also presented.

Development and underground test of radiopure ZnMoO4 scintillating bolometers for the LUMINEU 0 nu 2 beta project

The LUMINEU (Luminescent Underground Molybdenum Investigation for NEUtrino mass and nature) project envisages a high-sensitivity search for neutrinoless double beta (0 nu 2 beta) decay of Mo-100 with the help of scintillating bolometers based on zinc molybdate (ZnMoO4) crystals. One of the crucial points for the successful performance of this experiment is the development of a protocol for producing high quality large mass ZnMoO4 crystal scintillators with extremely high internal radiopurity. Here we report a significant progress in the development of large volume ZnMoO4 crystalline boules (with mass up to 1 kg) from deeply purified materials. We present and discuss the results achieved with two ZnMoO4 samples (with mass of about 0.3 kg each): one is a precursor of the LUMINEU project, while the other one was produced in the framework of LUMINEU with an improved purification / crystallization procedure. The two crystals were measured deep underground as scintillating bolometers in the EDELWEISS dilution refrigerator at the Laboratoire Souterrain de Modane (France) protected by a rock overburden corresponding to 4800 m w.e. The results indicate that both tested crystals are highly radiopure. However, the advanced LUMINEU sample shows a clear improvement with respect to the precursor, exhibiting only a trace internal contamination related with Po-210 at the level of 1 mBq/kg, while the activity of Ra-226 and Th-228 is below 0.005 mBq/kg. This demonstrates that the LUMINEU purification and crystal-growth procedures are very efficient and leads to radiopurity levels which exceedingly satisfy not only the LUMINEU goals but also the requirements of a next-generation 0 nu 2 beta experiment.

Planck pre-launch status: HFI ground calibration

Context. The Planck satellite was successfully launched on May 14th 2009. We have completed the pre-launch calibration measurements of the High Frequency Instrument (HFI) on board Planck and their processing. Aims. We present the results ot the pre-launch calibration of HFI in which we have multiple objectives. First, we determine instrumental parameters that cannot be measured in-flight and predict parameters that can. Second, we take the opportunity to operate and understand the instrument under a wide range of anticipated operating conditions. Finally, we estimate the performance of the instrument built. Methods. We obtained our pre-launch calibration results by characterising the component and subsystems, then by calibrating the focal plane at IAS (Orsay) in the Saturne simulator, and later from the tests at the satellite level carried out in the CSL (Liege) cryogenic vacuum chamber. We developed models to estimate the instrument pre-launch parameters when no measurement could be performed. Results. We reliably measure the Planck-HFI instrument characteristics and behaviour, and determine the flight nominal setting of all parameters. The expected in-flight performance exceeds the requirements and is close or superior to the goal specifications.

Performances and prospects of the “ROSEBUD” dark matter search experiment

Abstract A cryogenic search for WIMP Dark Matter with small sapphire bolometers through the WIMP scattering off Al2O3 nuclei, the ROSEBUD (Rare Objects SEarch with Bolometers UndergrounD) experiment, is being installed in the Canfranc Underground Laboratory (Spain) at 2450 m water equivalent. The performances of the bolometers, the radioactive background expected from the measurement of the radiopurity of the ROSEBUD components and the estimated sensitivity of the experiment for low mass WIMP detection are presented.

Light yield of undoped sapphire at low temperature under particle excitation

In this letter, we report on the performance of scintillating sapphire bolometers developed in the framework of the ROSEBUD (Rare Objects Search with Bolometers UnDerground) Collaboration devoted to dark matter searches. The simultaneous measurement of heat and light allows the discrimination of the type of particle increasing the sensitivity for these searches. A heat versus light negative correlation for gamma events has been observed. Its interpretation, in a simple framework, allows the estimation of the light yield of undoped sapphire at a temperature of about 20 mK under gamma, alpha, and neutron excitation.

Enriched TeO2 bolometers with active particle discrimination: Towards the CUPID experiment

Abstract We present the performances of two 92% enriched 130TeO2 crystals operated as thermal bolometers in view of a next generation experiment to search for neutrinoless double beta decay of 130Te. The crystals, 435 g each, show an energy resolution, evaluated at the 2615 keV γ-line of 208Tl, of 6.5 and 4.3 keV FWHM. The only observable internal radioactive contamination arises from 238U (15 and 8 μBq/kg, respectively). The internal activity of the most problematic nuclei for neutrinoless double beta decay, 226Ra and 228Th, are both evaluated as β / γ particles by means of Neganov–Luke bolometric light detectors we were able to perform an event-by-event identification of β / γ events with a 95% acceptance level, while establishing a rejection factor of 98.21% and 99.99% for α particles.