P. Reina

Structural analysis of the human tibia by tomographic (pQCT) serial scans

This study analyses the evaluation of tomographic indicators of tibia structure, assuming that the usual loading pattern shifts from uniaxial compression close to the heel to a combined compression, torsion and bending scheme towards the knee. To this end, pQCT scans were obtained at 5% intervals of the tibia length (S5–S95 sites from heel to knee) in healthy men and women (10/10) aged 20–40 years. Indicators of bone mass [cortical area, cortical/total bone mineral content (BMC)], diaphyseal design (peri/endosteal perimeters, cortical thickness, circularity, bending/torsion moments of inertia – CSMIs), and material quality [(cortical vBMD (bone mineral density)] were determined. The longitudinal patterns of variation of these measures were similar between genders, but male values were always higher except for cortical vBMD. Expression of BMC data as percentages of the minimal values obtained along the bone eliminated those differences. The correlative variations in cortical area, BMC and thickness, periosteal perimeter and CSMIs along the bone showed that cortical bone mass was predominantly associated with cortical thickness toward the mid‐diaphysis, and with bone diameter and CSMIs moving more proximally. Positive relationships between CSMIs (y) and total BMC (x) showed men’s values shifting to the upper‐right region of the graph and women’s values shifting to the lower‐left region. Total BMC decayed about 33% from S5 to S15 (where minimum total BMC and CSMI values and variances and maximum circularity were observed) and increased until S45, reaching the original S5 value at S40. The observed gender‐related differences reflected the natural allometric relationships. However, the data also suggested that men distribute their available cortical mass more efficiently than women. The minimum amount and variance of mass indicators and CSMIs, and the largest circularity observed at S15 reflected the assumed adaptation to compression pattern at that level. The increase in CSMIs (successively for torsion, A–P bending, and lateral bending), the decrease in circularity values and the changes in cortical thickness and periosteal perimeter toward the knee described the progressive adaptation to increasing torsion and bending stresses. In agreement with the biomechanical background, the described relationships: (i) identify the sites at which some changes in tibial stresses and diaphyseal structure take place, possibly associated with fracture incidence; (ii) allow prediction of mass indicators at any site from single determinations; (iii) establish the proportionality between the total bone mass at regions with highly predominant trabecular and cortical bone of the same individual, suitable for a specific evaluation of changes in trabecular mass; and (iv) evaluate the ability of bone tissue to self‐distribute the available cortical bone according to specific stress patterns, avoiding many anthropometric and gender‐derived influences.

Absorptiometric assessment of muscle-bone relationships in humans: reference, validation, and application studies.

This report summarizes some preliminary absorptiometric (DXA, QCT/pQCT) studies from our laboratory, supporting the following assumptions. 1. InHomo sapiens at all ages, natural proportionality between DXA-assessed bone mineral mass (bone mineral content, BMC) and muscle mass (lean mass, LM) of the whole body or limbs is specific for ethnicity, gender, and reproductive status, but not for body weight, height, or body mass index. 2. This proportionality is sensitive to many kinds of endocrine-metabolic perturbations. 3. Percentilized or Z-scored charts of the BMC/LM correlations as determined in large samples of healthy individuals can provide a diagnostic reference for evaluating proportionality in different conditions. 4. Employing exclusively DXA, this methodology can be applied to discriminate between “disuse-related” and “metabolic” osteopenias based on the finding of normal or low BMC/LM percentiles or Z-scores respectively, with important therapeutic and monitoring implications.

Novel experimental effects on bone material properties and the pre- and postyield behavior of bones may be independent of bone mineralization

In this article, we summarize the results of six different tomographic/biomechanical rat studies involving hypophysectomy (Hx), ovariectomy, treatment with rhGH, olpadronate, alendronate, and toxic doses of aluminum and the development of a genetic diabetes in theeSS strain. All these conditions induced some interesting and rarely reported effects on postyield bone strength. These effects were generally related neither to the degree of mineralization or the elastic modulus of the bone tissue nor to the preyield behavior of the bones. In two particular cases (Hx,eSS), the elastic modulus of bone tissue varied independently of its degree of mineralization. These results suggest the involvement of some microstructural factor(s) of bone tissue resistance to crack progression (a postyield feature of bone behavior), rather than to crack initiation (the yield-determining factor) in the corresponding mechanism. Changes in collagen or crystal structure may play that role. These changes are relevant to the mechanism of fracture production during plastic deformation, a feature of bone strength that might be independent from mineralization. Therefore, these changes might help to explain some effects of novel treatments on bone strength unrelated to bone mineralization. This questions the belief that the remaining bone mass in metabolic osteopenias is biologically and mechanically normal.