Paolo F. Ambrico

Sensitivity analysis of differential absorption lidar measurements in the mid-infrared region

The availability of new laser sources that are tunable in the IR spectral region opens new perspectives for differential absorption lidar (DIAL) measurements. A region of particular interest is located in the near IR, where some of the atmospheric pollutants have absorption lines that permit monitoring of emissions from industrial plants and in urban areas. In DIAL measurements, the absorption lines for the species to be measured must be carefully chosen to prevent interference from other molecules, to minimize the dependence of the absorption cross section on temperature, and to optimize the measurements with respect to the optical depth. We analyze the influence of these factors and discuss a set of criteria for selecting the best pairs of wavelengths (lambda(on) and lambda(off)) to be used in DIAL measurements of several molecular species (HCl, CO, CO(2), NO(2), CH(4), H(2)O, and O(2)). Moreover, a sensitivity study has been carried out for selected lines in three different regimes: clean air, urban polluted air, and emission from an incinerator stack.

LIF and fast imaging plasma jet characterization relevant for NTP biomedical applications

In the field of biomedical application, many publications report on non-thermal plasma jet potentialities for cell behaviour modifications in cancer treatment, wound healing or sterilization. However most previous plasma jet characterizations were performed when jets expend freely in air. Only recently has the influence of the targeted surface been properly considered. In this work, modifications induced by various types of targets, mimicking the biological samples, in the plasma propagation and production of hydroxyl radicals are evidenced through time-resolved intensified charge-coupled device imaging and laser-induced fluorescence (LIF) measurements. A LIF model, also specifically dedicated to estimate air and water penetration inside the jet, is used and proves to be well adapted to characterize the plasma jet under biomedical application conditions. It is shown that the plasma produced by the plasma gun counter-propagates after impinging the surface which, for the same operating parameters, leads to an increase of almost one order of magnitude in the maximum OH density (from ~2 × 1013 cm−3 for open-air propagation to ~1 × 1014 cm−3 for a grounded metal target). The nature of the target, especially its electrical conductivity, as well as gas flow rate and voltage amplitude are playing a key role in the production of hydroxyl radicals. The strong interplay between gas flow dynamics and plasma propagation is here confirmed by air and water distribution measurements. The need for a multi-diagnostic approach, as well as great care in setting up the in situ characterization of plasma jets, is here emphasized. Special attention must not only be paid to voltage amplitude and gas flow rate but also to the nature, humidity and conductivity of the target.

Melanin Layer on Silicon: an Attractive Structure for a Possible Exploitation in Bio-Polymer Based Metal- Insulator-Silicon Devices

Dr. M. Ambrico , Dr. P. F. Ambrico CNR-Istituto di Metodologie Inorganiche e dei Plasmi-UOS di Bari70125 Bari, Italy E-mail: marianna.ambrico@ba.imip.cnr.it Dr. A. Cardone , Dr. S. R. Cicco CNR-Istituto di Chimica dei Composti OrganoMetallici-UOS di Bari70125 Bari, Italy Ligonzo , Dr. . T Prof. Augelli . V Dipartimento Interateneo di FisicaUniversita degli Studi di Bari “Aldo Moro”70125 Bari, Italy Dr. R. Di Mundo , Prof. G. M. arinola F Dipartimento di ChimicaUniversita degli Studi di Bari “Aldo Moro”70125 Bari, Italy

Aerosol observations by lidar in the nocturnal boundary layer

Aerosol observations by lidar in the nocturnal boundary layer (NBL) were performed in Potenza, Southern Italy, from 20 January to 20 February 1997. Measurements during nine winter nights were considered, covering a variety of boundary-layer conditions. The vertical profiles of the aerosol backscattering coefficient at 355 and 723.37 nm were determined through a Klett-modified iterative procedure, assuming the extinction-to-backscattering ratio within the NBL has a constant value. Aerosol average size characteristics were retrieved from almost simultaneous profiles of the aerosol backscattering coefficient at 355 and 723.37 nm, the measurements being consistent with an accumulation mode radius not exceeding 0.4 microm. Similar results in terms of aerosol sizes were obtained from measurements of the extinction-to-backscattering ratio profile at 355 nm performed on six nights during the measurement campaign. Backscattering profiles at 723.37 nm were also converted into profiles of aerosol liquid water content.

Engineering polydopamine films with tailored behaviour for next-generation eumelanin-related hybrid devices

Eumelanin-type biopolymers have attracted growing interest in the quest for soft bioinspired functional materials for application in organoelectronics. Recently, a metal-insulator-semiconductor device with a good quality interface was produced by spin coating of a commercial synthetic eumelanin-like material on a dry plasma-modified silicon surface. As a proof-of-concept step toward the design and implementation of next-generation eumelanin-inspired devices, we report herein an expedient chemical strategy to bestow n-type performance to polydopamine, a highly popular eumelanin-related biopolymer with intrinsic semiconductor behaviour, and to tune its electrical properties. The strategy relies on aerial co-oxidation of dopamine with suitable aromatic amines, e.g. 3-aminotyrosine or p-phenylenediamine, leading to good quality black polymeric films. Capacitance–voltage experiments on poly(dopamine/3-aminotyrosine) and poly(dopamine/p-phenylenediamine)-based metal insulator semiconductor devices on p-Si indicated a significant increase in flat band voltage with respect to polydopamine and previous synthetic eumelanin-based diodes. Variations of the flat band voltage under vacuum were observed for each device. These results point to polydopamine as a versatile eumelanin-type water-dependent semiconductor platform amenable to fine tuning of its electronic properties through incorporation of π-conjugating aromatic amines to tailor functionality.

{\rm N}_{2}(A\,^{3}\Sigma _{\rm u}^{+}) density measurement in a dielectric barrier discharge in N2 and N2 with small O2 admixtures

This paper deals with the measurement of metastable state density in a dielectric barrier discharge in nitrogen and nitrogen with small admixtures of oxygen, operating in a Townsend-like discharge regime. The measurement is made by optical?optical double resonance-LIF, calibrated by a method based on the measurement of the ratio of nitrogen second positive system and NO-? emissions, and of NO density by LIF. A metastable density of the order of 1013?cm?3 was found in a nitrogen diffuse discharge. Addition of small oxygen concentrations to the discharge drives a transition to the filamentary regime that appears to be caused not by a marked decrease of the metastable density in the discharge but rather by a considerable increase of its quenching rate. Such an increase, due to collision quenching by O2 and O, strongly reduces the survival of the metastable between two discharge pulses. These observations are consistent with the idea that the diffuse regime can be due to a space charge memory effect due to the nitrogen triplet metastable, which is cancelled by the introduction of oxygen in the gas feed.

OH density measurement by time-resolved broad band absorption spectroscopy in an Ar–H2O dielectric barrier discharge

We report results of a novel time-resolved broad-band absorption spectroscopy experiment for OH density measurement applied to a pulsed dielectric barrier discharge in Ar/H2O mixtures. The measurement is aimed at the calibration of our previous OH LIF measurements in the same discharge. The apparatus is simple and cheap, being based on a UV LED light source and a non-intensified, non-cooled, gateable linear CCD array as a detector. The set-up is capable of ruling out both medium/long-term drifts of the UV source and of the discharge, and discharge emission from the measurement. Performances of the set-up are discussed, together with possible improvements for its use as a standalone technique.

On the collision quenching of by N2 and O2 and its influence on the measurement of E/N by intensity ratio of nitrogen spectral bands

Laser induced fluorescence measurements of the rate coefficients of collision quenching by N2 and O2 are presented. The values of (8.84 ± 0.37) × 10−10 cm3 s−1 and (10.45 ± 0.45) × 10−10 cm3 s−1 have been found for N2 and O2, respectively. The present results agree well with the literature data obtained by selective methods for ion B state excitation. The data are discussed in the framework of the spectroscopic evaluation of the reduced electric field in electrical discharges at high pressure, which makes use of the second positive system and first negative system emissions of nitrogen.

Thermoluminescence study of the trapped charge at an alumina surface electrode in different dielectric barrier discharge regimes

In this study, the charge trapping effect in alumina dielectric surfaces has been deeply investigated by means of a dedicated dielectric barrier discharge apparatus in different discharge regimes and gas mixtures. This work further validates our previous findings in the case of air discharges in a filamentary regime. Long lasting charge trapping has been evidenced by ex situ thermoluminescence characterizations of alumina dielectric barrier plates exposed to a plasma. The density of trapped surface charges was found to be higher in the glow discharge with respect to pseudo-glow and filamentary regimes, and for all regimes the minimum trap activation temperature was 390 K and the trap energy was less than or around 1 eV. This implies that in the case of glow discharges a higher reservoir of electrons is present. Also, the effect was found to persist for several days after running the discharge.

{\rm N}_2 \left({A\,^3\Sigma_{\rm u}^+} \right) behaviour in a N2?NO surface dielectric barrier discharge in the modulated ac regime at atmospheric pressure

Optical, electrical and discharge product measurements were performed in order to reveal the behaviour of metastables in a surface dielectric barrier discharge (DBD) driven in N2 with small NO admixtures in a modulated ac regime. Metastable species were detected both in a thin surface plasma layer and in the space afterglow through plasma induced emission and optical?optical double resonance laser induced fluorescence, respectively. Basically, the observed species follow the discharge current oscillations in the plasma layer, while they evolve on a millisecond time scale due to diffusion through the space afterglow. Emission spectrometry provides a rough estimation of average metastable concentration in a thin surface plasma layer ~9 ? 1013?cm?3. Fluorescence measurements then allow an upper estimation of metastable concentration in the space afterglow ?1 ? 1012?cm?3.