Pascale Bayle-Guillemaud

Beyond conventional electrocatalysts: hollow nanoparticles for improved and sustainable oxygen reduction reaction activity

Long-term catalytic performance of electrode materials is a well-established research priority in electrochemical energy conversion and storage systems, such as proton-exchange membrane fuel cells. Despite extensive efforts in research and development, Pt-based nanoparticles remain the only – but an unstable – electrocatalyst able to accelerate efficiently the rate of the oxygen reduction reaction. This paper describes the synthesis and the atomic-scale characterization of hollow Pt-rich/C nanocrystallites, which achieve 4-fold and 5-fold enhancement in specific activity for the oxygen reduction reaction over standard solid Pt/C nanocrystallites of the same size in liquid electrolyte and during real proton-exchange membrane fuel cell (PEMFC) testing, respectively. More importantly, the hollow nanocrystallites can sustain this level of performance during accelerated stress tests, therefore opening new perspectives for the design of improved PEMFC cathode materials.

Bridging the Gap between CO Adsorption Studies on Gold Model Surfaces and Supported Nanoparticles

An in-depth understanding of CO adsorption on highly dispersed gold nanoparticles (AuNPs) is critically important to fully interpret the catalytic behavior of supported gold systems in processes such as CO oxidation, PROX (selective oxidation of CO in presence of a large excess of H2), [5–7] or LT-WGS (low-temperature water gas-shift) reactions. Despite its relevance, the quantitative data and fundamental information presently available on the CO–Au interaction mainly comes from studies carried out on model single-crystal and thin-film surfaces under experimental conditions far from those at which catalytic assays on supported gold systems are typically run. Probably because of the very weak and singular nature of the CO–Au interaction, which on the basis of both theoretical and experimental studies is generally acknowledged to take place on low-coordination surface sites, and the additional contribution of the support, a few studies have been carried out that were aimed at estimating the amount of CO adsorbed at low temperature on powdered or model supported AuNPs. To our knowledge, however, none of these have arrived at a detailed quantitative description of this process under conditions close to those occurring in real catalytic reactions. To bridge this gap, we have developed an approach in which AuNP size distributions, as determined from HAADFSTEM (high-angle annular dark-field scanning transmission electron microscopy) and quantitative CO adsorption data, as determined from volumetric adsorption at 308 K, under CO partial pressures ranging from 6.65 10 Pa to 3.99 10 Pa, are jointly analyzed with the help of a nanostructural model for the gold particles. This model could be deduced from the analysis of images recorded in a parallel HRTEM (highresolution transmission electron microscopy) study. As discussed herein, this approach gives a substantial experimental support to the extension to supported gold catalysts of the chemical principles governing the CO adsorption on model surfaces. We investigated two catalyst samples, 2.5 wt% Au/ Ce0.62Zr0.38O2 (Au/CZ) and 1.5 wt% Au/Ce0.50Tb0.12Zr0.38O2 x (Au/CTZ), which have significantly different gold particle size distributions. Two consecutive CO volumetric adsorption isotherms were recorded on the gold catalysts and the corresponding supports. Prior to running the second isotherms, samples were evacuated (residual pressure Pres< 1.33 10 4 Pa) for 30 min at 308 K. By processing the volumetric data in a similar way to earlier studies (for details, see the Supporting Information), the amounts of CO adsorbed on the AuNPs, on the surface cations of the supports (weak adsorption), and on the surface anions of the supports, which mainly consist of strongly chemisorbed carbonate species, could be determined from the difference of the two isotherms. The amount of CO adsorbed on the AuNPs at PCO= 1.33 10 4 Pa (100 Torr) was used as a measurement of the saturation coverage. The corresponding data are reported in Table 1 and the Supporting Information, Figure S1. Gold particle size distributions were determined for each of the investigated catalysts from the analysis of series of experimental ultra-high-resolution HAADF-STEM images (Supporting Information, Figure S2). In accordance with the physical principles lying behind the mechanism of image formation, this technique is particularly suitable for obtaining reliable metal particle size distributions in oxide-supported metal catalysts. Moreover, as recently shown, this technique can be fruitfully applied to a very fine characterization of AuNPs dispersed on mixed oxides of heavy elements, as is the case of those investigated herein. (Size distributions for Au/CZ and Au/CTZ catalysts are shown in the Supporting Information, Figure S2). [*] M. L pez-Haro, Dr. J. J. Delgado, J. M. Cies, E. del Rio, S. Bernal, Dr. M. A. Cauqui, Dr. S. Trasobares, Dr. J. A. P rez-Omil, Dr. J. J. Calvino Departamento de Ciencia de los Materiales e Ingenier a Metalfflrgica y Qu mica Inorg nica Facultad de Ciencias, Universidad de C diz Campus Rio San Pedro, 11510-Puerto Real, C diz (Spain) Fax: (+34)956-016-288 E-mail: jose.calvino@uca.es

Imaging nanostructural modifications induced by electronic metal-support interaction effects at Au||cerium-based oxide nanointerfaces.

A variety of advanced (scanning) transmission electron microscopy experiments, carried out in aberration-corrected equipment, provide direct evidence about subtle structural changes taking place at nanometer-sized Au||ceria oxide interfaces, which agrees with the occurrence of charge transfer effects between the reduced support and supported gold nanoparticles suggested by macroscopic techniques. Tighter binding of the gold nanoparticles onto the ceria oxide support when this is reduced is revealed by the structural analysis. This structural modification is accompanied by parallel deactivation of the CO chemisorption capacity of the gold nanoparticles, which is interpreted in exact quantitative terms as due to deactivation of the gold atoms at the perimeter of the Au||cerium oxide interface.

Synergistic effect in carbon coated LiFePO4 for high yield spontaneous grafting of diazonium salt. Structural examination at the grain agglomerate scale.

Molecular grafting of p-nitrobenzene diazonium salt at the surface of (Li)FePO4-based materials was thoroughly investigated. The grafting yields obtained by FTIR, XPS, and elemental analysis for core shell LiFePO4-C are found to be much higher than the sum of those associated with either the LiFePO4 core or the carbon shell alone, thereby revealing a synergistic effect. Electrochemical, XRD, and EELS experiments demonstrate that this effect stems from the strong participation of the LiFePO4 core that delivers large amounts of electrons to the carbon substrate at a constant energy, above the Fermi level of the diazonium salt. Correspondingly large multilayer anisotropic structures that are associated with outstanding grafting yields could be observed from TEM experiments. Results therefore constitute strong evidence of a grafting mechanism where homolytic cleavage of the N2(+) species occurs together with the formation and grafting of radical nitro-aryl intermediates. Although the oxidation and concomitant Li deintercalation of LiFePO4 grains constitute the main driving force of the functionalization reaction, EFTEM EELS mapping shows a striking lack of spatial correlation between grafted grains and oxidized ones.

Nanoscale Chemical Evolution of Silicon Negative Electrodes Characterized by Low-Loss STEM-EELS

Continuous solid electrolyte interface (SEI) formation remains the limiting factor of the lifetime of silicon nanoparticles (SiNPs) based negative electrodes. Methods that could provide clear diagnosis of the electrode degradation are of utmost necessity to streamline further developments. We demonstrate that electron energy-loss spectroscopy (EELS) in a scanning transmission electron microscope (STEM can be used to quickly map SEI components and quantify LixSi alloys from single experiments with resolutions down to 5 nm. Exploiting the low-loss part of the EEL spectrum allowed us to circumvent the degradation phenomena that have so far crippled the application of this technique on such beam-sensitive compounds. Our results provide unprecedented insight into silicon aging mechanisms in full cell configuration. We observe the morphology of the SEI to be extremely heterogeneous at the particle scale but with clear chemical evolutions with extended cycling coming from both SEI accumulation and a transition from lithium-rich carbonate-like compounds to lithium-poor ones. Thanks to the retrieval of several results from a single data set we were able to correlate local discrepancies in lithiation to the initial crystallinity of silicon as well as to the local SEI chemistry and morphology. This study emphasizes how initial heterogeneities in the percolating electronic network and the porosity affect SiNPs aggregates along cycling. These findings pinpoint the crucial role of an optimized formulation in silicon-based thick electrodes.

Low‐Lanthanide‐Content CeO2/MgO Catalysts with Outstandingly Stable Oxygen Storage Capacities: An In‐Depth Structural Characterization by Advanced STEM Techniques

A novel CeO2/MgO catalyst with low ceria loading has been synthesized. This catalyst showed unique redox properties compared with conventional high and low surface area CeO2. Advanced (scanning) transmission electron microscopy techniques revealed the presence of a variety of highly dispersed ceria nanostructures: isolated CeOx entities, CeO2 clusters, as well as fairly small (<5 nm) CeO2 nanoparticles. More interestingly, this CeO2/MgO catalyst showed outstanding stability in its redox response against high temperature aging treatments. Thus, after reduction in hydrogen at 950 °C and further oxidation at 500 °C, CeO2 reduction effects took still place at low temperatures, and no significant loss of oxygen storage capacity (OSC) was detected. Unique ceria‐bilayer nanostructures were found and characterized in the aged catalyst. Their peculiar structural and chemical properties seem to be responsible for the large improvement observed in the stability of the redox response.