Pasi Hakulinen

Enhancement of chemically induced reactive oxygen species production and DNA damage in human SH-SY5Y neuroblastoma cells by 872 MHz radiofrequency radiation

The objective of the study was to investigate effects of 872 MHz radiofrequency (RF) radiation on intracellular reactive oxygen species (ROS) production and DNA damage at a relatively high SAR value (5 W/kg). The experiments also involved combined exposure to RF radiation and menadione, a chemical inducing intracellular ROS production and DNA damage. The production of ROS was measured using the fluorescent probe dichlorofluorescein and DNA damage was evaluated by the Comet assay. Human SH-SY5Y neuroblastoma cells were exposed to RF radiation for 1 h with or without menadione. Control cultures were sham exposed. Both continuous waves (CW) and a pulsed signal similar to that used in global system for mobile communications (GSM) mobile phones were used. Exposure to the CW RF radiation increased DNA breakage (p<0.01) in comparison to the cells exposed only to menadione. Comparison of the same groups also showed that ROS level was higher in cells exposed to CW RF radiation at 30 and 60 min after the end of exposure (p<0.05 and p<0.01, respectively). No effects of the GSM signal were seen on either ROS production or DNA damage. The results of the present study suggest that 872 MHz CW RF radiation at 5 W/kg might enhance chemically induced ROS production and thus cause secondary DNA damage. However, there is no known mechanism that would explain such effects from CW RF radiation but not from GSM modulated RF radiation at identical SAR.

Toxicological effects of emission particles from fossil- and biodiesel-fueled diesel engine with and without DOC/POC catalytic converter

There is increasing demand for renewable energy and the use of biodiesel in traffic is a major option when implying this increment. We investigated the toxicological activities of particulate emissions from a nonroad diesel engine, operated with conventional diesel fuel (EN590), and two biodiesels: rapeseed methyl ester (RME) and hydrotreated fresh vegetable oil (HVO). The engine was operated with all fuels either with or without catalyst (DOC/POC). The particulate matter (PM1) samples were collected from the dilution tunnel with a high-volume cascade impactor (HVCI). These samples were characterized for ions, elements, and polycyclic aromatic hydrocarbon (PAH) compounds. Mouse RAW264.7 macrophages were exposed to the PM samples for 24 h. Inflammatory mediators, (TNF-α and MIP-2), cytotoxicity, genotoxicity, and oxidative stress (reactive oxygen species [ROS]) were measured. All the samples displayed mostly dose-dependent toxicological activity. EN590 and HVO emission particles had larger inflammatory responses than RME-derived particles. The catalyst somewhat increased the responses per the same mass unit. There were no substantial differences in the cytotoxic responses between the fuels or catalyst use. Genotoxic responses by all the particulate samples were at same level, except weaker for the RME sample with catalyst. Unlike other samples, EN590-derived particles did not significantly increase ROS production. Catalyst increased the oxidative potential of the EN590 and HVO-derived particles, but decreased that with RME. Overall, the use of biodiesel fuels and catalyst decreased the particulate mass emissions compared with the EN590 fuel. Similar studies with different types of diesel engines are needed to assess the potential benefits from biofuel use in engines with modern technologies.

Pulmonary inflammation and tissue damage in the mouse lung after exposure to PM samples from biomass heating appliances of old and modern technologies

Current levels of ambient air fine particulate matter (PM(2.5)) are associated with mortality and morbidity in urban populations worldwide. In residential areas wood combustion is one of the main sources of PM(2.5) emissions, especially during wintertime. However, the adverse health effects of particulate emissions from the modern heating appliances and fuels are poorly known. In this study, health related toxicological properties of PM(1) emissions from five modern and two old technology appliances were examined. The PM(1) samples were collected by using a Dekati® Gravimetric Impactor (DGI). The collected samples were weighed and extracted with methanol for chemical and toxicological analyses. Healthy C57BL/6J mice were intratracheally exposed to a single dose of 1, 3, 10 or 15 mg/kg of the particulate samples for 4, 18 or 24h. Thereafter, the lungs were lavaged and bronchoalveolar lavage fluid (BALF) was assayed for indicators of inflammation, cytotoxicity and genotoxicity. Lungs of 24h exposed mice were collected for inspection of pulmonary tissue damage. There were substantial differences in the combustion qualities of old and modern technology appliances. Modern technology appliances had the lowest PM(1) (mg/MJ) emissions, but they induced the highest inflammatory, cytotoxic and genotoxic activities. In contrast, old technology appliances had clearly the highest PM(1) (mg/MJ) emissions, but their effect in the mouse lungs were the lowest. Increased inflammatory activity was associated with ash related components of the emissions, whereas high PAH concentrations were correlating with the smallest detected responses, possibly due to their immunosuppressive effect.

The BIOSAFEPAPER project for in vitro toxicity assessments: Preparation, detailed chemical characterisation and testing of extracts from paper and board samples

Nineteen food contact papers and boards and one non-food contact board were extracted following test protocols developed within European Union funded project BIOSAFEPAPER. The extraction media were either hot or cold water, 95% ethanol or Tenax, according to the end use of the sample. The extractable dry matter content of the samples varied from 1200 to 11,800 mg/kg (0.8-35.5 mg/dm2). According to GC-MS the main substances extracted into water were pulp-derived natural products such as fatty acids, resin acids, natural wood sterols and alkanols. Substances extracted into ethanol particularly, were diisopropylnaphthalenes, alkanes and phthalic acid esters. The non-food contact board showed the greatest number and highest concentrations of GC-MS detectable compounds. The extracts were subjected to a battery of in vitro toxicity tests measuring both acute and sublethal cytotoxicity and genotoxic effects. None of the water or Tenax extracts was positive in cytotoxicity or genotoxicity assays. The ethanol extract of the non-food contact board gave a positive response in the genotoxicity assays, and all four ethanol extracts gave positive response(s) in the cytotoxicity assays to some extent. These responses could not be pinpointed to any specific compound, although there appeared a correlation between the total amount of extractables and toxicity.

Toxicological properties of emission particles from heavy duty engines powered by conventional and bio-based diesel fuels and compressed natural gas

BackgroundOne of the major areas for increasing the use of renewable energy is in traffic fuels e.g. bio-based fuels in diesel engines especially in commuter traffic. Exhaust emissions from fossil diesel fuelled engines are known to cause adverse effects on human health, but there is very limited information available on how the new renewable fuels may change the harmfulness of the emissions, especially particles (PM). We evaluated the PM emissions from a heavy-duty EURO IV diesel engine powered by three different fuels; the toxicological properties of the emitted PM were investigated. Conventional diesel fuel (EN590) and two biodiesels were used − rapeseed methyl ester (RME, EN14214) and hydrotreated vegetable oil (HVO) either as such or as 30% blends with EN590. EN590 and 100% HVO were also operated with or without an oxidative catalyst (DOC + POC). A bus powered by compressed natural gas (CNG) was included for comparison with the liquid fuels. However, the results from CNG powered bus cannot be directly compared to the other situations in this study.ResultsHigh volume PM samples were collected on PTFE filters from a constant volume dilution tunnel. The PM mass emission with HVO was smaller and with RME larger than that with EN590, but both biofuels produced lower PAH contents in emission PM. The DOC + POC catalyst greatly reduced the PM emission and PAH content in PM with both HVO and EN590. Dose-dependent TNFα and MIP-2 responses to all PM samples were mostly at the low or moderate level after 24-hour exposure in a mouse macrophage cell line RAW 264.7. Emission PM from situations with the smallest mass emissions (HVO + cat and CNG) displayed the strongest potency in MIP-2 production. The catalyst slightly decreased the PM-induced TNFα responses and somewhat increased the MIP-2 responses with HVO fuel. Emission PM with EN590 and with 30% HVO blended in EN590 induced the strongest genotoxic responses, which were significantly greater than those with EN590 + cat or 100% HVO. The emission PM sample from the CNG bus possessed the weakest genotoxic potency but had the strongest oxidative potency of all the fuel and catalyst combinations. The use of 100% HVO fuel had slightly weaker and 100% RME somewhat stronger emission PM induced ROS production, when compared to EN590.ConclusionsThe harmfulness of the exhaust emissions from vehicle engines cannot be determined merely on basis of the emitted PM mass. The study conditions and the engine type significantly affect the toxicity of the emitted particles. The selected fuels and DOC + POC catalyst affected the PM emission from the heavy EURO IV engine both qualitative and quantitative ways, which influenced their toxicological characteristics. The plain HVO fuel performed very well in emission reduction and in lowering the overall toxicity of emitted PM, but the 30% blend of HVO in EN590 was no better in this respect than the plain EN590. The HVO with a DOC + POC catalyst in the EURO IV engine, performed best with regard to changes in exhaust emissions. However some of the toxicological parameters were significantly increased even with these low emissions.

Safety evaluation of food contact paper and board using chemical tests and in vitro bioassays: role of known and unknown substances

In vitro toxicological tests have been proposed as an approach to complement the chemical safety assessment of food contact materials, particularly those with a complex or unknown chemical composition such as paper and board. Among the concerns raised regarding the applicability of in vitro tests are the effects of interference of the extractables on the outcome of the cytotoxicity and genotoxicity tests applied and the role of known compounds present in chemically complex materials, such as paper and board, either as constituents or contaminants. To answer these questions, a series of experiments were performed to assess the role of natural substances (wood extracts, resin acids), some additives (diisopropylnaphthalene, phthalates, acrylamide, fluorescent whitening agents) and contaminants (2,4-diaminotoluene, benzo[a]pyrene) in the toxicological profile of paper and board. These substances were individually tested or used to spike actual paper and board extracts. The toxic concentrations of diisopropylnaphthalenes and phthalates were compared with those actually detected in paper and board extracts showing conspicuous toxicity. According to the results of the spiking experiments, the extracts did not affect the toxicity of tested chemicals nor was there any significant metabolic interference in the cases where two compounds were used in tests involving xenobiotic metabolism by the target cells. While the identified substances apparently have a role in the cytotoxicity of some of the project samples, their presence does not explain the total toxicological profile of the extracts. In conclusion, in vitro toxicological testing can have a role in the safety assessment of chemically complex materials in detecting potentially harmful activities not predictable by chemical analysis alone.

Efficiency of log wood combustion affects the toxicological and chemical properties of emission particles

Context: Particulate matter (PM) has been identified as a major environmental pollutant causing severe health problems. Large amounts of the harmful particulate matter (PM) are emitted from residential wood combustion, but the toxicological properties of wood combustion particles are poorly known. Objective: To investigate chemical and consequent toxicological characteristics of PM1 emitted from different phases of batch combustion in four heating appliances. Materials and methods: Mouse RAW264.7 macrophages and human BEAS-2B bronchial epithelial cells were exposed for 24 h to different doses (15–300 µg/mL) of wood combustion particles. After the exposure, cytotoxicity, genotoxicity, production of the inflammatory mediators (TNF-α and MIP-2) and effects on the cell cycle were assessed. Furthermore, the detected toxicological responses were compared with the chemical composition of PM1 samples including PAHs, metals and ions. Results: All the wood combustion samples exerted high cytotoxicity, but only moderate inflammatory activity. The particles emitted from the inefficient phase of batch combustion in the sauna stove (SS) induced the most extensive cytotoxic and genotoxic responses in mammalian cells. Polycyclic aromatic hydrocarbons (PAHs) and other organic compounds in PM1 samples might have contributed to these effects. Instead, water-soluble metals seemed to participate in the cytotoxic responses triggered by the particles from more efficient batch combustion in the masonry heaters. Overall, the toxicological responses were decreased when the combustion phase was more efficient. Conclusion: Efficiency of batch combustion plays a significant role in the harmfulness of PM even under incomplete wood combustion processes.

No Consistent Pattern of Mutations in p53 and ras Genes in Liver Tumors of Rat Treated With the Drinking Water Mutagen 3-Chloro-4-(dichloromethyl)-5-hydroxy- 2(5H)-furanone (MX)

The frequency of point mutations in p53 (exons 4–7) and in Ki‐ras, Ha‐ras, and N‐ras (exons 1 and 2) and the expression of p53 protein were evaluated in the liver tumors of Wistar rats of a 104‐week carcinogenicity study on 3‐chloro‐4‐(dichloromethyl)‐5‐hydroxy‐2(5H)‐furanone (MX), a chlorine disinfection by‐product in drinking water. Mutations were analyzed in 16 hepatocellular adenomas, 7 hepatocellular carcinomas, 23 cholangiomas, and 2 cholangiocarcinomas of the MX‐treated animals and one hepatocellular carcinoma and cholangiocarcinoma in control animals using PCR–SSCP (polymerase chain reaction–single‐strand conformation polymorphism) or PCR–TGGE (temperature gradient gel electrophoresis) and direct sequencing. The expression of the p53 protein (wild‐type and mutated protein) was detected by immunohistochemistry (CM5 antibody). The expression of p53 and that of the proliferating cell nuclear antigen (PCNA, 19 A2) were also evaluated in livers of female animals exposed to MX for 1 week, 3 weeks, or 18 weeks. Altogether, four mutations were found in p53 in three tumors, in two hepatocellular adenomas, and one cholangiocarcinoma, all in females receiving the highest MX dose (6.6 mg/kg/day) of the study. Three of the mutations were G:C → A:T transitions and one was an A:T → T:A transversion. The mutations were scattered at different codons and positions of the codon. One hepatocellular adenoma contained two p53 mutations. All cholangiomas and cholangiocarcinomas, but no hepatocellular adenomas and carcinomas, overexpressed the p53 protein. MX treatment did not induce p53 expression at any age in the liver or alter the expression of the PCNA in the liver of younger animals. The p53 protein was overexpressed in hyperplastic bile ducts in aged rats but not in bile ducts of younger rats (up to 24 weeks). No mutations were observed in either Ki‐ras, Ha‐ras, or N‐ras of the liver tumors. These data suggest that point mutations in p53, Ki‐ras, Ha‐ras, and N‐ras are not involved in the MX‐induced liver carcinogenesis in rats. Environ. Mol. Mutagen. 36:292–300, 2000