Patrick Bottke

DFT Study of the Role of Al3+ in the Fast Ion-Conductor Li7–3xAl3+xLa3Zr2O12 Garnet

We investigate theoretically the site occupancy of Al3+ in the fast-ion-conducting cubic-garnet Li7–3xAl3+xLa3Zr2O12 (Ia-3d) using density functional theory. By comparing calculated and measured 27Al NMR chemical shifts an analysis shows that Al3+ prefers the tetrahedrally coordinated 24d site and a distorted 4-fold coordinated 96h site. The site energies for Al3+ ions, which are slightly displaced from the exact crystallographic sites (i.e., 24d and 96h), are similar leading to a distribution of slightly different local oxygen coordination environments. Thus, broad 27Al NMR resonances result reflecting the distribution of different isotropic chemical shifts and quadrupole coupling constants. From an energetic point of view, there is evidence that Al3+ could also occupy the 48g site with its almost regular octahedral coordination sphere. Although this has been reported by neutron powder diffraction, the NMR chemical shift calculated for such an Al3+ site has not been observed experimentally.

Order vs. disorder—a huge increase in ionic conductivity of nanocrystalline LiAlO2 embedded in an amorphous-like matrix of lithium aluminate

Coarse grained, well crystalline γ-LiAlO2 (P43212) is known as an electronic insulator and a very poor ion conductor with the lithium ions occupying tetrahedral voids in the oxide structure. The introduction of structural disorder such as point defects or higher-dimensional defects, however, may greatly affect ionic conduction on both short-range as well as long-range length scales. In the present study, we used high-energy ball milling to prepare defect-rich, nanocrystalline LiAlO2 that was characterized from a structural point of view by powder X-ray diffraction, TEM as well as small angle X-ray scattering (SAXS). Temperature-dependent conductivity spectroscopy revealed an increase of the room-temperature ionic conduction by several orders of magnitude when going from microcrystalline γ-LiAlO2 to its nanocrystalline form. The enhanced ion transport found is ascribed to the increase of Li ions near defective sites both in the bulk as well as in the large volume fraction of interfacial regions in nano-LiAlO2. The nanocrystalline ceramic prepared at long milling times is a mixture of γ-LiAlO2 and the high-pressure phase δ-LiAlO2; it adapts an amorphous like structure after it has been treated in a planetary mill under extremely harsh conditions.

Synthesis of ternary transition metal fluorides Li3MF6via a sol–gel route as candidates for cathode materials in lithium-ion batteries

A sol–gel route for ternary lithium fluorides of transition metals (M) is presented allowing the synthesis of Li3MF6-type and Li2MF5-type compounds. It is based on a fluorolytic process using transition metal acetylacetonates as precursors. The domain size of the obtained powders can be controlled by modifying the conditions of synthesis. 6Li and 7Li magic angle spinning (MAS) nuclear magnetic resonance (NMR) spectroscopy is used to study local environments of the Li ions in orthorhombic and monoclinic Li3VF6 as well as Li2MnF5. The number of magnetically inequivalent Li sites found by MAS NMR is in agreement with the respective crystal structure of the compounds studied. Quantum chemical calculations show that all materials have high de-lithiation energies making them suitable candidates to be used as high-voltage battery cathode materials.

Ion dynamics in solid electrolytes for lithium batteries

All-solid-state batteries with ceramic electrolytes and lithium metal anodes represent an attractive alternative to conventional ion battery systems. Conventional batteries still rely on flammable liquids as electronic insulators. Despite the great efforts reported over the last years, the optimum solid electrolyte has, however, not been found yet. One of the most important properties which decides whether a ceramic is useful to work as electrolyte is ionic transport. The various time-domain nuclear magnetic resonance (NMR) techniques might help characterize and select the most suitable candidates. Together with conductivity measurements it is possible to analyze ion dynamics on different length-scales, i.e., to differentiate between local, within-site hopping processes from long-range ion transport. The latter needs to be sufficiently fast in the ceramic, in the best case competing with that of liquid electrolytes. In addition to conductivity spectroscopy, NMR can help understand the relationship between local structure and dynamic parameters. Besides information on activation energies and jump rates the data also contain suggestions about the relevant elementary steps of ion hopping and, thus, diffusion pathways through the crystal lattice. Recent progress in characterizing ion dynamics in ceramic electrolytes by NMR relaxometry will be briefly reviewed. Focus is put on presently discussed solid electrolytes such as garnets, phosphates and sulfides, which have so far been studied in our lab.

Nanostructured Ceramics: Ionic Transport and Electrochemical Activity

Abstract Ceramics with nm-sized dimensions are widely used in various applications such as batteries, fuel cells or sensors. Their oftentimes superior electrochemical properties as well as their capabilities to easily conduct ions are, however, not completely understood. Depending on the method chosen to prepare the materials, nanostructured ceramics may be equipped with a large area fraction of interfacial regions that exhibit structural disorder. Elucidating the relationship between microscopic disorder and ion dynamics as well as electrochemical performance is necessary to develop new functionalized materials. Here, we highlight some of the very recent studies on ion transport and electrochemical properties of nanostructured ceramics. Emphasis is put on TiO2 in the form of nanorods, nanotubes or being present as mesoporous material. Further examples deal with nanocrystalline peroxides such as Li2O2 or nanostructured oxides (Li2TiO3, LiAlO2, LiTaO3, Li2CO3 and Li2B4O7). These materials served as model systems to explore the influence of ball-milling on overall ionic transport.

A simple and straightforward mechanochemical synthesis of the far-from-equilibrium zinc aluminate, ZnAl2O4, and its response to thermal treatment

Zinc aluminate (ZnAl2O4) nanoparticles with an average size of about 10 nm are synthesized via one-step mechanochemical processing of the ZnO : γ-Al2O3 stoichiometric mixture at ambient temperature. The mechanochemically induced formation of the phase is followed by XRD and 27Al MAS NMR. High-resolution TEM studies reveal a non-uniform nanostructure of mechanosynthesized aluminate consisting of ordered grains surrounded or separated by disordered surface and interfacial regions. Due to the capability of 27Al MAS NMR to probe the local environment of the Al cations, valuable insights into the short-range structure of ZnAl2O4 on the Angstrom length scale are provided. It is demonstrated that the as-prepared aluminate possesses a partly inverse spinel structure with a far-from equilibrium arrangement of cations and distorted polyhedra, which are spatially confined to the surface and interfacial regions with a volume fraction of ca. 50% and a thickness of ca. 1 nm. The response of the nanostructured ZnAl2O4 to subsequent thermal treatment is further investigated. It turned out that the thermally induced grain growth is accompanied by a release of microstrain, by a shrinkage of the lattice parameter, as well as by a variation in the oxygen parameter and metal–oxygen bond lengths. Evidence is given of the thermally induced redistribution of cations approaching their equilibrium positions. Upon heating above 1100 K, mechanosynthesized ZnAl2O4 relaxes towards a structural state that is similar to the bulk one.

Li Ion Dynamics in Nanocrystalline and Structurally Disordered Li2TiO3

Abstract The monoclinic polymorph of Li2TiO3 (β-form) is known to be a relatively poor Li ion conductor. Up to now, no information is available on how the ion transport properties change when going from well-ordered crystalline Li2TiO3 to a structurally disordered form with the same chemical composition. Here, we used high-energy ball milling to prepare nanocrystalline, defect-rich Li2TiO3; ion dynamics have been studied via impedance spectroscopy. It turned out that ball milling offers the possibility to enhance long-range ion transport in the oxide by approximately 3 orders of magnitude. Its effect on the oxide ceramic is two-fold: besides the introduction of a large number of defects, the originally μm-sized crystallites are decreased to crystallites with a mean diameter of less than 50 nm. This process is accompanied by a mechanically induced phase transformation towards the α-form of Li2TiO3; besides that, a significant amount of amorphous materials is produced during milling. Structural disorder in nanocrystalline as well as amorphous Li2TiO3 is anticipated to play the capital role in governing Li ion dynamics of the sample finally obtained.