Pengyue Zhao

Multi-walled carbon nanotubes as alternative reversed-dispersive solid phase extraction materials in pesticide multi-residue analysis with QuEChERS method.

A multi-residue method based on modified QuEChERS sample preparation with multi-walled carbon nanotubes (MWCNTs) as reversed-dispersive solid phase extraction (r-DSPE) material and gas chromatography-mass spectrometry determination by selected ion monitoring (GC/MS-SIM) mode was validated on 30 representative pesticides residues in vegetables and fruits. The acetonitrile-based QuEChERS (quick, easy, cheap, effective, rugged and safe) sample preparation technique was used to obtain the extracts, and the further cleanup was carried out by applying r-DSPE. It was found that the amount of MWCNTs influenced the cleanup performance and the recoveries. The optimal amount of 10mg MWCNTs was suitable for cleaning up all selected matrices, as a suitable alternative r-DSPE material to primary secondary amine (PSA). This method was validated on cabbage, spinach, grape and orange spiked at concentration levels of 0.02 and 0.2 mg/kg. The recoveries of 30 pesticides were in the range of 71-110%, with relative standard deviations (RSDs, n=5) lower than 15%. Matrix effects were observed by comparing the slope of matrix-matched standard calibration with that of solvent. Good linearity was achieved at the concentration levels of 0.02-0.5 mg/L. The limits of quantification (LOQs) and the limits of detection (LODs) for 30 pesticides ranged from 0.003 to 0.05 mg/kg and 0.001 to 0.02 mg/kg at the signal-to-noise ratio (S/N) of 10 and 3, respectively. The method was successfully applied to analysis real samples in Beijing. In conclusion, the modified QuEChERS method with MWCNTs cleanup step showed reliable method validation performances and good cleanup effects in this study.

Determination of pesticide residues in complex matrices using multi‐walled carbon nanotubes as reversed‐dispersive solid‐phase extraction sorbent

A modified quick, easy, cheap, effective, rugged and safe (QuEChERS) method with multi-walled carbon nanotubes (MWCNTs) as a reversed-dispersive solid-phase extraction (r-DSPE) material combined with gas chromatography-mass spectrometry was developed for the determination of 14 pesticides in complex matrices. Four vegetables (leek, onion, ginger and garlic) were selected as the complex matrices for validating this new method. This technique involved the acetonitrile-based sample preparation and MWCNTs were used as the r-DSPE material in the cleanup step. Two important parameters influencing the MWCNTs efficiency, the external diameters and the amount of MWCNTs used, were investigated. Under the optimized conditions, recoveries of 78-110% were obtained for the target analytes in the complex matrices at two concentration levels of 0.02 and 0.2 mg/kg. In addition, the RSD values ranged from 1 to 13%. LOQs and LODs for 14 pesticides ranged from 2 to 20 μg/kg and from 1 to 6 μg/kg, respectively.

Dispersive cleanup of acetonitrile extracts of tea samples by mixed multiwalled carbon nanotubes, primary secondary amine, and graphitized carbon black sorbents.

A method for analysis of 37 pesticide residues in tea samples was developed and validated and was based on reversed-dispersive solid-phase extraction (r-DSPE) cleanup in acetonitrile solution, followed by liquid chromatography-electrospray tandem mass spectrometry determination. Green tea, oolong tea, and puer tea were selected as matrixes and represent the majority of tea types. Acetonitrile was used as the extraction solvent, with sodium chloride and magnesium sulfate enhancing partitioning of analytes into the organic phase. The extract was then cleaned up by r-DSPE using a mixture of multiwalled carbon nanotubes, primary secondary amine, and graphitized carbon black as sorbents to absorb interferences. Further optimization of sample preparation and determination allowed recoveries of between 70% and 111% for all 37 pesticides with relative standard deviations lower than 14% at two concentration levels of 10 and 100 μg kg(-1). Limits of quantification ranged from 5 to 20 μg kg(-1) for all pesticides. The developed method was successfully applied to the determination of pesticide residues in market tea samples.

The comparison of dispersive solid phase extraction and multi-plug filtration cleanup method based on multi-walled carbon nanotubes for pesticides multi-residue analysis by liquid chromatography tandem mass spectrometry

In this study, dispersive-Solid Phase Extraction (d-SPE) cleanup and multi-plug filtration cleanup (m-PFC) methods were compared for 25 representative pesticides in six matrices (wheat, spinach, carrot, apple, citrus and peanut) by QuEChERS-LC-ESI-MS/MS detection. The type of sorbents in dispersive-SPE (d-SPE) was optimized for the above matrices. Multi-walled carbon nanotubes (MWCNTs), which mixed other materials like PSA (Primary Secondary Amines), GCB (Graphitized Carbon Black) and C18 (Octadecyl-silica), showed brilliant cleanup performance in multi residue monitoring (MRM) pesticide residue analysis. Cleanup effects with d-SPE and m-PFC methods were examined. When spiked at 3 concentration levels of 10, 100, 500 μg/kg in above matrices, for both d-SPE and m-PFC methods, the recoveries ranged from 70 to 110% with relative standard deviations (RSDs) lower than 20%. Limits of quantification (LOQs) for both cleanup methods ranged from 1 to 25 μg/kg. Matrix-matched calibrations were performed with the coefficients of determination more than 0.99 between concentration levels of 10-1000 μg/kg. It was found that m-PFC was more convenient and effective than d-SPE with the same sorbents, due to the increased contact time and contact area between the extracts and compressed sorbents. The study demonstrated that m-PFC method could be used as a rapid, convenient and high-throughput cleanup method for analysis of pesticide residues.

Rapid Multiplug Filtration Cleanup with Multiple-Walled Carbon Nanotubes and Gas Chromatography–Triple-Quadruple Mass Spectrometry Detection for 186 Pesticide Residues in Tomato and Tomato Products

This study reports the development and validation of a novel rapid cleanup method based on multiple-walled carbon nanotubes in a packed column filtration procedure for analysis of pesticide residues followed by gas chromatography-triple-quadruple tandem mass spectrometry detection. The cleanup method was carried out by applying the streamlined procedure on a multiplug filtration cleanup column with syringes. The sorbent used for removing the interferences in the matrices is multiple-walled carbon nanotubes mixed with anhydrous magnesium sulfate. The proposed cleanup method is convenient and time-saving as it does not require any solvent evaporation, vortex, or centrifugation procedures. It was validated on 186 pesticides and 3 tomato product matrices spiked at two concentration levels of 10 and 100 μg kg(-1). Satisfactory recoveries and relative standard deviations are shown for most pesticides using the multiplug filtration cleanup method in tomato product samples. The developed method was successfully applied to the determination of pesticide residues in market samples.

Multiplug filtration clean-up with multiwalled carbon nanotubes in the analysis of pesticide residues using LC-ESI-MS/MS.

A novel design for a rapid clean-up method was developed for the analysis of pesticide residues in fruit and vegetables followed by LC-ESI-MS/MS. The acetonitrile-based sample extraction technique was used to obtain the extracts, and further clean-up was carried out by applying the streamlined procedure on a multiplug filtration clean-up column coupled with a syringe. The sorbent used for clean-up in this research is multiwalled carbon nanotubes, which was mixed with anhydrous magnesium sulfate to remove water from the extracts. This method was validated on 40 representative pesticides and apple, cabbage, and potato sample matrices spiked at two concentration levels of 10 and 100 μg/kg. It exhibited recoveries between 71 and 117% for most pesticides with RSDs < 15%. Matrix-matched calibrations were performed with the coefficients of determination >0.995 for most studied pesticides between concentration levels of 10-500 μg/L. The LOQs for 40 pesticides ranged from 2 to 50 μg/kg. The developed method was successfully applied to the determination of pesticide residues in market fruit and vegetable samples.

Direct analysis in real time mass spectrometry for the rapid identification of four highly hazardous pesticides in agrochemicals

RATIONALE Direct analysis in real time (DART) is a new ion source technique, which is conducted in the open air under ambient conditions, applied to the rapid and direct analysis of any material (gases, liquids, and solids) with minimal or no sample preparation. In order to take advantage of the capacity of DART mass spectrometry for the real-time analysis of hazardous ingredients in commercial agrochemicals, a pilot study of rapid qualitative determination of hazardous pesticides was performed. METHODS Highly hazardous pesticides were identified by DART ionization coupled to a single-quadrupole mass spectrometer (DART-MS). Acetonitrile was chosen for dissolving samples prior to the analysis. Samples were analyzed by this technique in as little as 5 s. RESULTS Phorate, carbofuran, ethoprophos and fipronil were be detected directly from commercial agrochemicals. The ionization-related parameters (DART temperature, grid voltage and MS fragment) of these compounds were optimized to obtain highly response. Isotope patterns were taken into consideration for qualitative identification. Relative standard deviations (RSDs, n = 5) of 2.3-15.0% were obtained by measuring the relative abundance of selected isotopes. CONCLUSIONS This study showed that DART-MS technology was able to qualitatively determine the existence of highly hazardous pesticides in commercial pesticide formulations. It is suggested that this technology should be applied for routine monitoring in the market.

Simultaneous determination of 36 pesticide residues in spinach and cauliflower by LC-MS/MS using multi-walled carbon nanotubes-based dispersive solid-phase clean-up

A multi-residue method based on a modified QuEChERS sample preparation with multi-walled carbon nanotubes (MWCNTs) as reversed-dispersive solid-phase extraction (r-DSPE) material and LC-MS/MS determination by MRM mode was validated for 36 representative pesticides in spinach and cauliflower. It was demonstrated that MWCNTs can be used as effective r-DSPE materials with the QuEChERS method for the clean-up of extract from different matrices. However, MWCNTs could absorb pyrimethanil, diflubenzuron, and chlorbenzuron in both spinach and cauliflower, which leads to the low recoveries compared with PSA. The LODs and LOQs for 36 pesticides ranged from 0.1 to 5 μg kg−1 and from 2 to 30 μg kg−1, respectively. Good linearity was found for all pesticides with coefficients better than 0.995 in a range of 0.02–0.5 mg l−1. The developed method with MWCNTs clean-up was successfully used to determine the 36 pesticides in real samples.

Dissipation and residue behavior of emamectin benzoate on apple and cabbage field application

A LC-ESI-MS/MS method with QuEChERS for analysis of emamectin benzoate in cabbage, apple and soil was established. At fortification levels of 0.001, 0.01 and 0.1 mg/kg in cabbage, apple and soil, it was shown that recoveries ranged from 75.9 to 97.0 percent with relative standard deviation (RSD) of 4.4-19.0 percent. The limit of quantification (LOQ) was 0.001 mg/kg for cabbage, apple and soil. The dissipation half-lives of emamectin benzoate in cabbage, apple and soil were 1.34-1.72 day, 2.75-3.09 day and 1.89-4.89 day, respectively. The final residues of emamectin benzoate ranged from 0.001 to 0.052 mg/kg in cabbages, 0.003 to 0.090 mg/kg in apples and 0.001 to 0.089 mg/kg in soils, respectively. Therefore, it would be unlikely to cause health problems if emamectin benzoate was applied according to the use pattern suggested by the manufactures on the label.

Residue determination of glufosinate in plant origin foods using modified Quick Polar Pesticides (QuPPe) method and liquid chromatography coupled with tandem mass spectrometry

A sensitive and specific method for the determination of glufosinate in plant origin foods was developed. The method involves extraction using modified QuPPe method, clean-up by multi-walled carbon nanotubes (MWCNTs), derivatization with 9-fluorenylmethyl chloroformate (FMOC-Cl) and detection with liquid chromatography coupled to tandem mass spectrometry (LC-MS/MS). The method was validated on twelve matrices spiked at 10 or 20, 100 and 500 μg/kg. The recovery ranged from 80% to 108% with intra-day RSDs (n=5) of 0.6-9.8% and inter-day RSDs (n=15) of 3.0-9.4%. Good linearities (R(2)⩾0.9991) were obtained for all matrices. The limit of detection (LOD) and limit of quantification (LOQ) for the selected matrices ranged from 0.3 to 3.3 μg kg(-1) and from 1 to 10 μg kg(-1), respectively. The method was demonstrated to be reliable and sensitive for the routine monitoring of glufosinate in plant origin foods.