Peter J. Lawrence

A review of the methodologies used in the computer simulation of evacuation from the built environment

Computer based analysis of evacuation can be performed using one of three different approaches, namely optimisation, simulation or risk assessment. Furthermore, within each approach different means of representing the enclosure, the population, and the behaviour of the population are possible. The myriad of approaches which are available has led to the development of some 22 different evacuation models. This article attempts to describe each of the modelling approaches adopted and critically review the inherent capabilities of each approach. The review is based on available published literature.

Modelling occupant interaction with fire conditions using the buildingEXODUS evacuation model

When evacuating through fire environments, the presence of smoke may not only have a physiological impact on the evacuees but may also lead occupants to adapt their evacuation strategy through the adoption of another exit. This paper attempts to introduce this type of adaptive behaviour within the buildingEXODUS evacuation model through enabling occupants to make decisions concerning the selection of the most viable available exit during an evacuation involving fire. The development of this adaptive behaviour requires the introduction of several new capabilities namely, the representation of the occupants’ familiarity with the structure, the behaviour of an occupant that is engulfed in smoke and the behaviour of an occupant that is faced with a smoke barrier. The appropriateness of the redirection decision is dependent upon behavioural data gathered from real fire incidents (in the UK and USA) that is used to construct the redirection probabilities. The implementation is shown to provide a more complex and arguably more realistic representation of this behaviour than that provided previously.

The Exodus Evacuation Model Applied To Building Evacuation Scenarios

The purpose of this paper is to demonstrate the potential of the EXODUS evacuation model in building environments. The latest PC/workstation version of EXODUS is described and is also applied to a large hypothetical supermarket/restaurant complex measuring 50 m x 40 m. A range of scenarios is presented where population characteristics (such as size, individual travel speeds, and individual response times), and enclosure configuration characteristics (such as number of exits, size of exits, and opening times of exits) are varied.The results demonstrate a wide range of occupant behavior including overtaking, queuing, redirection, and conflict avoidance. Evacuation performance is measured by a number of model predicted parameters including individual exit flow rates, overall evacuation flow rates, total evacuation time, average evacuation time per occupant, average travel distance, and average wait time.The simulations highlight the profound impact that variations in individual travel speeds and occupant res...

A review of the methodologies used in evacuation modelling

Computer based analysis of evacuation can be performed using one of three different approaches, namely optimization, simulation and risk assessment. Furthermore, within each approach different means of representing the enclosure, the population and the behaviour of the population are possible. The myriad of approaches that are available has led to the development of some 22 different evacuation models. This review attempts to describe each of the modelling approaches adopted and critically review the inherent capabilities of each approach. The review is based on available published literature.

Investigating the Representation of Merging Behavior at the Floor-Stair Interface in Computer Simulations of Multi-Floor Building Evacuations

In this article, the representation of the merging process at the floor- stair interface is examined within a comprehensive evacuation model and trends found in experimental data are compared with model predictions. The analysis suggests that the representation of floor-stair merging within the comprehensive model appears to be consistent with trends observed within several published experiments of the merging process. In particular: (a) The floor flow rate onto the stairs decreases as the stair population density increases. (b) For a given stair population density, the floor populations flow rate onto the stairs can be maximized by connecting the floor to the landing adjacent to the incoming stair. (c) In situations where the floor is connected adjacent to the incoming stair, the merging process appears to be biased in favor of the floor population. It is further conjectured that when the floor is connected opposite the incoming stair, the merging process between the stair and floor streams is almost in balance for high stair population densities, with a slight bias in favor of the floor stream at low population densities. A key practical finding of this analysis is that the speed at which a floor can be emptied onto a stair can be enhanced simply by connecting the floor to the landing at a location adjacent to the incoming stair rather than opposite the stair. Configuring the stair in this way, while reducing the floor emptying time, results in a corresponding decrease in the descent flow rate of those already on the stairs. While this is expected to have a negligible impact on the overall time to evacuate the building, the evacuation time for those higher up in the building is extended while those on the lower flows is reduced. It is thus suggested that in high-rise buildings, floors should be connected to the landing on the opposite side to the incoming stair. Information of this type will allow engineers to better design stair-floor interfaces to meet specific design objectives.

An investigation of the aspects of occupant behavior required for evacuation modeling

This article examines occupant behavior exhibited during evacuation conditions. This is based on a review of a wide range of published literature concerned with evacuation. Factors influencing evacuation performance can be categorized into four broad areas, namely, configurational, environmental, procedural, and, most importantly, behavioral. The contributory factors associated with each of the four influencing categories are examined in detail and it is suggested that these factors should be represented within evacuation models. Language: en

Signage Legibility Distances as a Function of Observation Angle

Signage systems are widely used in buildings to provide information for wayfinding, thereby assisting in navigation during normal circulation of pedestrians and, more importantly, exiting information during emergencies. An important consideration in determining the effectiveness of signs is establishing the region from which the sign is visible to occupants, the so-called visibility catchment area (VCA). This study attempts to factor into the determination of the VCA of signs, the observation angle of the observer. In building regulations, it is implicitly assumed that the VCA is independent of the observation angle. A theoretical model is developed to explain the relationship between the VCA and observation angle and experimental trials are performed in order to assess the validity of this model. The experimental findings demonstrate a consistency with the theoretical model. Given this result, the functionality of a comprehensive evacuation model is extended in accordance with the assumptions on which the theoretical model is based and is then demonstrated using several examples

A systematic comparison of model predictions produced by the buildingExodus evacuation model and the Tsukuba Pavilion evacuation data

In this article, the buildingEXODUS (V1.1) evacuation model is described and discussed and attempts at qualitative and quantitative model validation are presented. The data set used for the validation is the Tsukuba pavilion evacuation data. This data set is of particular interest as the evacuation was influenced by external conditions, namely inclement weather. As part of the validation exercise, the sensitivity of the buildingEXODUS predictions to a range of variables and conditions is examined, including: exit flow capacity, occupant response times, and the impact of external conditions on the developing evacuation. The buildingEXODUS evacuation model was found to produce good qualitative and quantitative agreement with the experimental data.

Representing the Influence of Signage on Evacuation Behavior within an Evacuation Model

Occupant interaction with signage systems is being introduced into evacuation simulations through the newly developed concept of the Visibility Catchment Area or VCA. In this article, we describe the concept of VCA and how it has been extended to incorporate the presence of physical obstructions and termination distance. The VCA concept is then linked to a prototype behavior model intended to represent the occupants interaction with the signage system. The functionality and performance of the newly developed model is then demonstrated through the simulation of various evacuation scenarios within a hypothetical supermarket layout.

Coupled Fire/Evacuation Analysis of the Station Nightclub Fire

In this paper, coupled fire and evacuation simulation tools are used to simulate the Station Nightclub fire. This study differs from the analysis conducted by NIST in three key areas; (1) an enhanced flame spread model and (2) a toxicity generation model are used, (3) the evacuation is coupled to the fire simulation. Predicted early burning locations in the full-scale fire simulation are in line with photographic evidence and the predicted onset of flashover is similar to that produced by NIST. However, it is suggested that both predictions of the flashover time are approximately 15 sec earlier than actually occurred. Three evacuation scenarios are then considered, two of which are coupled with the fire simulation. The coupled fire and evacuation simulation suggests that 180 fatalities result from a building population of 460. With a 15 sec delay in the fire timeline, the evacuation simulation produces 84 fatalities which are in good agreement with actual number of fatalities. An important observation resulting from this work is that traditional fire engineering ASET/RSET calculations which do not couple the fire and evacuation simulations have the potential to be considerably over optimistic in terms of the level of safety achieved by building designs.