Philip Krantz

Direct observation of the thickness distribution of ultra thin AlOx barriers in Al/AlOx/Al Josephson junctions

We have directly measured the thickness distribution of the tunnel barriers in state-of-the-art Al/AlOx/Al tunnel junctions. From the distribution we can conclude that less than 10% of the junction area dominates the electron tunnelling. The barriers have been studied by transmission electron microscopy, specifically using atomic resolution annular dark field (ADF) scanning transmission electron microscopy (STEM) imaging. The direct observation of the local barrier thickness shows a Gaussian distribution of the barrier thickness variation along the junction, from ~1 to ~2nm. We have investigated how the thickness distribution varies with oxygen pressure (Po) and oxidation time (to) and we find, in agreement with resistance measurements, that an increased to has a larger impact on barrier thickness and its uniformity compared to an increased Po.

Single-shot read-out of a superconducting qubit using a Josephson parametric oscillator

We propose and demonstrate a read-out technique for a superconducting qubit by dispersively coupling it with a Josephson parametric oscillator. We employ a tunable quarter wavelength superconducting resonator and modulate its resonant frequency at twice its value with an amplitude surpassing the threshold for parametric instability. We map the qubit states onto two distinct states of classical parametric oscillation: one oscillating state, with 185±15 photons in the resonator, and one with zero oscillation amplitude. This high contrast obviates a following quantum-limited amplifier. We demonstrate proof-of-principle, single-shot read-out performance, and present an error budget indicating that this method can surpass the fidelity threshold required for quantum computing.

Coupling of an erbium spin ensemble to a superconducting resonator

A quantum coherent interface between optical and microwave photons can be used as a basic building block within a future quantum information network. The interface is envisioned as an ensemble of rare-earth ions coupled to a superconducting resonator, allowing for coherent transfer between optical and microwave photons. Towards this end, we have realized a hybrid device coupling a Er3 +-doped Y2SiO5 crystal in a superconducting coplanar waveguide cavity. We observe a collective spin coupling of 4 MHz and a spin linewidth of down to 75 MHz.

3D integrated superconducting qubits

As the field of quantum computing advances from the few-qubit stage to larger-scale processors, qubit addressability and extensibility will necessitate the use of 3D integration and packaging. While 3D integration is well-developed for commercial electronics, relatively little work has been performed to determine its compatibility with high-coherence solid-state qubits. Of particular concern, qubit coherence times can be suppressed by the requisite processing steps and close proximity of another chip. In this work, we use a flip-chip process to bond a chip with superconducting flux qubits to another chip containing structures for qubit readout and control. We demonstrate that high qubit coherence (T1, T2,echo > 20 μs) is maintained in a flip-chip geometry in the presence of galvanic, capacitive, and inductive coupling between the chips.Addressing qubits in a large-scale quantum processorSuperconducting qubits are a leading technology for realizing a quantum computer. To date, experiments have demonstrated control of up to ten qubits using interconnects that laterally address the qubits from the edge of a chip. Extending to larger numbers, however, will require utilizing the third dimension to avoid interconnect crowding and enable control and readout of all qubits in a two-dimensional array. Danna Rosenberg and a team led by William D. Oliver at MIT Lincoln Laboratory and MIT campus have developed a 3D design for efficiently addressing large numbers of qubits, comprising a stack of three bonded chips, each of which performs a different function. The team performed a proof-of-principle experiment using two bonded chips, demonstrating off-chip control and read out of a qubit without significantly impacting the quality of the qubit performance. This demonstration is an important step towards the 3D integration required to build larger-scale devices for quantum information processing.

Characterization of a multimode coplanar waveguide parametric amplifier

We characterize a Josephson parametric amplifier based on a flux-tunable quarter-wavelength resonator. The fundamental resonance frequency is ∼1 GHz, but we use higher modes of the resonator for our measurements. An on-chip tuning line allows for magnetic flux pumping of the amplifier. We investigate and compare degenerate parametric amplification, involving a single mode, and nondegenerate parametric amplification, using a pair of modes. We show that we reach quantum-limited noise performance in both cases.

The pumpistor: A linearized model of a flux-pumped superconducting quantum interference device for use as a negative-resistance parametric amplifier

We describe a circuit model for a flux-driven Superconducting QUantum Interference Device (SQUID). This is useful for developing insight into how these devices perform as active elements in parametric amplifiers. The key concept is that frequency mixing in a flux-pumped SQUID allows for the appearance of an effective negative resistance. In the three-wave, degenerate case treated here, a negative resistance appears only over a certain range of allowed input signal phase. This model readily lends itself to testable predictions of more complicated circuits.

Fabrication of large dimension aluminum air-bridges for superconducting quantum circuits

Proper grounding between different ground planes in coplanar superconducting qubit circuits is important to avoid spurious resonances which increase decoherence. Here, the authors present a possible solution to suppress such undesired modes using superconducting aluminum air-bridges which have been fabricated on top of aluminum coplanar waveguide transmission lines. 3D electromagnetic simulations were done to guide the design of the air-bridges such that the input reflection (S11) of the bridges was kept at a minimum level. A fabrication method based on optical lithography techniques was developed and it resulted in air-bridges with a height of approximately 10 μm and lengths of up to 500 μm. The method can be generalized to arbitrary length air-bridge with heights even exceeding 15 μm.

The atomic details of the interfacial interaction between the bottom electrode of Al/AlOx/Al Josephson junctions and HF-treated Si substrates

The interface between the Al bottom contact layer and Si substrates in Al based Josephson junctions is believed to have a significant effect on the noise observed in Al based superconducting devices. We have studied the atomic structure of it by transmission electron microscopy. An amorphous layer with a thickness of ∼5 nm was found between the bottom Al electrode and HF-treated Si substrate. It results from intermixing between Al, Si, and O. We also studied the chemical bonding states among the different species using energy loss near edge structure. The observations are of importance for the understanding of the origin of decoherence mechanisms in qubits based on these junctions.

An On-Chip Mach-Zehnder Interferometer in the Microwave Regime

The design, simulation and measurements of an on-chip Mach-Zehnder interferometer operating in the microwave regime are described. Using microwave signals in microfabricated superconducting Al waveguides, the concept of an interferometer is transferred from optics to on-chip. Tuning of the path length of one of the interferometer arms is executed through the tunable inductance of a SQUID. By placing one or more SQUIDs in the waveguide structure and by varying the magnetic flux through the SQUID loop, the total SQUID inductance can be tuned. In this way, a phase difference leading to destructive or constructive interference at the interferometer output can be achieved. Thorough software simulations were performed to determine the different design parameters, assign a desired working frequency and provide a reference for comparison with experimental results. Measurements at 300 mK show an effective working frequency close to the simulations, with a deviation smaller than 0.05 GHz. The behavior of the interferometer is very similar to the simulations as well. The on-off ratio exceeds 40 dB.

Nondegenerate parametric oscillations in a tunable superconducting resonator

We investigate nondegenerate parametric oscillations in a superconducting microwave multimode resonator that is terminated by a superconducting quantum interference device (SQUID). The parametric effect is achieved by modulating magnetic flux through the SQUID at a frequency close to the sum of two resonator-mode frequencies. For modulation amplitudes exceeding an instability threshold, self-sustained oscillations are observed in both modes. The amplitudes of these oscillations s how good quantitative agreement with a theoretical model. The oscillation phases are found to be correlated and exhibit strong fluctuations which broaden the oscillation spectral linewidths. These linewidths are significantly reduced by applying a weak on-resonant tone, which also suppresses the phase fluctuations. When the weak tone is detuned, we observe synchronization of the oscillation frequency with the frequency of the input. For the detuned input, we also observe an emergence of three idlers in the output. This observation is in agreement with theory indicating four-mode amplification and squeezing of a coherent input.