Piotr Patoka

Near-field imaging and nano-Fourier-transform infrared spectroscopy using broadband synchrotron radiation

We demonstrate scanning near-field optical microscopy with a spatial resolution below 100 nm by using low intensity broadband synchrotron radiation in the IR regime. The use of such a broadband radiation source opens up the possibility to perform nano-Fourier-transform infrared spectroscopy over a wide spectral range.

Surface plasmons and magneto-optic activity in hexagonal Ni anti-dot arrays.

The influence of surface plasmons on the magneto-optic activity in a two-dimensional hexagonal array is addressed. The experiments were performed using hexagonal array of circular holes in a ferromagnetic Ni film. Well pronounced troughs are observed in the optical reflectivity, resulting from the presence of surface plasmons. The surface plasmons are found to strongly enhance the magneto-optic response (Kerr rotation), as compared to a continuous film of the same composition. The influence of the hexagonal symmetry of the pattern on the coupling between the plasmonic excitations is demonstrated, using optical diffraction measurements and theoretical calculations of the magneto-optic and of the angular dependence of the optical activity.

Characterization of semiconductor materials using synchrotron radiation-based near-field infrared microscopy and nano-FTIR spectroscopy

We describe the application of scattering-type near-field optical microscopy to characterize various semiconducting materials using the electron storage ring Metrology Light Source (MLS) as a broadband synchrotron radiation source. For verifying high-resolution imaging and nano-FTIR spectroscopy we performed scans across nanoscale Si-based surface structures. The obtained results demonstrate that a spatial resolution below 40 nm can be achieved, despite the use of a radiation source with an extremely broad emission spectrum. This approach allows not only for the collection of optical information but also enables the acquisition of near-field spectral data in the mid-infrared range. The high sensitivity for spectroscopic material discrimination using synchrotron radiation is presented by recording near-field spectra from thin films composed of different materials used in semiconductor technology, such as SiO2, SiC, SixNy, and TiO2.

Self-assembly of latex particles for the creation of nanostructures with tunable plasmonic properties

In this short review we are discussing the creation of two dimensional nanostructures based on self-assembly of latex particles. Furthermore we are showing that optical properties of these structures can be controlled with their morphology and materials used for their preparation. Two representative structures, namely two dimensional arrays of triangles and holes are discussed in detail, starting with the preparatory step, followed by the structural and optical characterization, as well as the theoretical explanation of the plasmonic properties.

Nanoribbon plasmonic gratings and their anomalous interaction with electromagnetic waves.

The simple concept of this technique is to self-assemble a layer (usually a monolayer) of polystyrene spheres (PS) on a fl at substrate. The layer of PS is subsequently used as a shadow mask for evaporation of thin fi lms, e.g., metallic thin fi lms. In the simplest version, NSL employs the self-assembly of a densely packed hexagonal lattice of PS and perpendicular substrate evaporation, which leads after PS removal to a honeycomb array of nano-quasi-triangles. [ 1 ] More complicated patterns and nanoparticle shapes can be obtained if the evaporation angle is statically or dynamically modifi ed. [ 7 ] Here, we demonstrate fabrication of nanoribbon gratings by employing NSL with a very shallow static evaporation. The PS diameter is reduced by ionic etching after the assembly and controls the grating geometry. We use this shallow angle NSL (SANSL) technique to make Au and Fe nanoribbon gratings deposited on transparent substrates. Interaction of gratings with the electromagnetic radiation has been studied extensively since 1902. [ 8 ] Classically, subwavelength metallic gratings are polarizers of the transmitted waves; a wave with electric fi eld polarized perpendicular to the grating lines passes through the grating with little back refl ection. In turn, a wave polarized parallel to the lines is strongly back refl ected. This follows from simple boundary conditions at the perfect metal surface: [ 9 ] the parallel to the metal surface component of the electric fi eld must vanish, but the perpendicular one does not. Thus, the wave polarized parallel to the grating lines cannot pass since it would have to have wavelength λ = 2 d / n (where d is the interline distance and n = 1,2,3..) in order to assure the vanishing fi eld nodes at the metal surfaces of the neighboring grating lines. This cannot happen, since in the subwavelength limit λ > > d . In the optical range, most metals (e.g., Au, Ag) cannot be considered as perfect and thus the above analysis is no longer valid. In this range, some metals can support various plasmonic oscillations, including the surface plasmon polariton (SPP). [ 11 ] The extraordinary

Nanoscale plasmonic phenomena in CVD-grown MoS 2 monolayer revealed by ultra-broadband synchrotron radiation based nano-FTIR spectroscopy and near-field microscopy

Nanoscale plasmonic phenomena observed in single and bi-layers of molybdenum disulfide (MoS(2)) on silicon dioxide (SiO(2)) are reported. A scattering type scanning near-field optical microscope (s-SNOM) with a broadband synchrotron radiation (SR) infrared source was used. We also present complementary optical mapping using tunable CO(2)-laser radiation. Specifically, there is a correlation of the topography of well-defined MoS(2) islands grown by chemical vapor deposition, as determined by atomic force microscopy, with the infrared (IR) signature of MoS(2). The influence of MoS(2) islands on the SiO(2) phonon resonance is discussed. The results reveal the plasmonic character of the MoS(2) structures and their interaction with the SiO(2) phonons leading to an enhancement of the hybridized surface plasmon-phonon mode. A theoretical analysis shows that, in the case of monolayer islands, the coupling of the MoS(2) optical plasmon mode to the SiO(2) surface phonons does not affect the infrared spectrum significantly. For two-layer MoS(2), the coupling of the extra inter-plane acoustic plasmon mode with the SiO(2) surface transverse phonon leads to a remarkable increase of the surface phonon peak at 794 cm(-1). This is in agreement with the experimental data. These results show the capability of the s-SNOM technique to study local multiple excitations in complex non-homogeneous structures.

Selective Probing of the Penetration of Dexamethasone into Human Skin by Soft X-ray Spectromicroscopy

Selective probing of dexamethasone in excised human skin using soft X-ray spectromicroscopy provides quantitative concentration profiles as well as two-dimensional drug distribution maps. Element- and site-selective excitation of dexamethasone at the oxygen K-edge with the lateral step width adjusted to 1 μm provides detailed information on the location of the drug in the different skin layers. The key of this work is to probe dexamethasone selectively at the carbonyl site (C3) by the O 1s → π* transition, providing also a most efficient way to quantify the drug concentration as a function of penetration depth in correlation with structural properties of the skin containing carboxyl and amide oxygen sites occurring at higher transition energy than dexamethasone. Following drug exposure for 4 h, the glucocorticoide is located in about equal amounts in the stratum corneum, the outermost horny layer of skin, and in the viable epidermis, whereas in the dermis no dexamethasone is detected. In the stratum corneum, most of the lipophilic drug is found in regions between corneocytes, where epidermal lipids are dominating.

Transmission of Light through Magnetic Nanocavities

The transmission of light through a metallic film stack on a transparent substrate, perforated with a periodic array of cylindrical holes/nanocavities, is studied. The structure is fabricated by using self-assembled nanosphere lithography. Since one layer in the film stack is made of a ferromagnetic metal (iron), exposure of the structure to a solution containing iron oxide nanoparticles causes nanoparticle accumulation inside the nanocavities. This changes the dielectric constant inside the nanocavities and thus affects the light transmission. Simulations are in good agreement with experiment, and show large sensitivity of the response to the amount of iron oxide nanoparticles deposited. This could be used in various sensor applications.

Enhancing the sensitivity of nano-FTIR spectroscopy

Synchrotron radiation-based nano-FTIR spectroscopy utilizes the highly brilliant and ultra-broadband infrared (IR) radiation provided by electron storage rings for the infrared spectroscopic characterization of samples at the nanoscale. In order to exploit the full potential of this approach we investigated the influence of the properties of the radiation source, such as the electron bunch shape and spectral bandwidth of the emitted radiation, on near-field infrared spectra of silicon-carbide (SiC). The adapted configuration of the storage ring optics enables a modification of the transverse electron bunch profile allowing an increase of the measured near-field signal amplitude. Additionally, the decay of the signal amplitude due to the decreasing storage ring current is also eliminated. Further options for improving the sensitivity of nano-FTIR spectroscopy, which can also be applied to other broadband radiation sources, are the adaption of the spectral bandwidth to the wavelength range of interest or the use of polarization optics. The sensitivity enhancement emerging from these options is verified by comparing near-field spectra collected from crystalline SiC samples. The improvement in sensitivity by combining these approaches is demonstrated by acquiring nano-FTIR spectra from thin organic films, which show weak resonances in the IR-regime.

Infrared Nanospectroscopy of Phospholipid and Surfactin Monolayer Domains

A main challenge in understanding the structure of a cell membrane and its interactions with drugs is the ability to chemically study the different molecular species on the nanoscale. We have achieved this for a model system consisting of mixed monolayers (MLs) of the biologically relevant phospholipid 1,2-distearoyl-sn-glycero-phosphatidylcholine and the antibiotic surfactin. By employing nano-infrared (IR) microscopy and spectroscopy in combination with atomic force microscopy imaging, it was possible to identify and chemically detect domain formation of the two constituents as well as to obtain IR spectra of these species with a spatial resolution on the nanoscale. A novel method to enhance the near-field imaging contrast of organic MLs by plasmon interferometry is proposed and demonstrated. In this technique, the organic layer is deposited on gold and ML graphene substrates, the latter of which supports propagating surface plasmons. Plasmon reflections arising from changes in the dielectric environment provided by the organic layer lead to an additional contrast mechanism. Using this approach, the interfacial region between surfactin and the phospholipid has been mapped and a transition region is identified.