Piyasiri Ekanayake

Efficient star-shaped hole transporting materials with diphenylethenyl side arms for an efficient perovskite solar cell

Two symmetrical star-shaped hole transporting materials (HTMs), i.e.FA-MeOPh and TPA-MeOPh with a fused triphenylamine or triphenylamine core and diphenylethenyl side arms were synthesized. FA-MeOPh showed a strong molar absorption coefficient and a red-shifted absorption compared with TPA-MeOPh because of its planar configuration. The power conversion efficiency (PCE) of the perovskite solar cells based on FA-MeOPh and TPA-MeOPh is about 11.86% and 10.79%, in which the efficiency of former is comparable to that (12.75%) of spiro-OMeTAD based cell. The high photocurrent (18.39 mA cm−2) of FA-MeOPh based solar cell relative to TPA-MeOPh based one may be attributable to the enhanced absorption in the near-IR region for mp-TiO2/CH3NH3PbI3/HTM based cell. The high mobility and low series resistance of mp-TiO2/CH3NH3PbI3/FA-MeOPh based cell led to the high fill factor (0.698) of FA-MeOPh based solar cell relative to TPA-MeOPh based one (0.627). In addition, the FA-MeOPh based cell showed a relative stability under light soaking for 250 h. The high efficiency, relative stability, synthetically simple and inexpensive materials as the HTMs hold promise to replace the expensive spiro-OMeTAD.

Potential natural sensitizers extracted from the skin of Canarium odontophyllum fruits for dye-sensitized solar cells.

Possibility of use of dye extract from skin samples of a seasonal, indigenous fruit from Borneo, namely Canarium odontophyllum, in dye sensitized solar cells (DSSCs) are explored. Three main groups of flavonoid pigments are detected and these pigments exhibit different UV-vis absorption properties, and hence showing different light harvesting capabilities. When applied in DSSCs. The detected pigment constituents of the extract consist of aurone (maritimein), anthocyanidin (pelargonidin) and anthocyanidin (cyanidin derivatives). When tested in DSSC, the highest conversion efficiency of 1.43% is exhibited by cyanidin derivatives, and this is followed by conversion efficiencies of 0.51% and 0.79% for aurone and pelargonidin, respectively. It is shown that individual pigments, like cyanidin derivatives and pelargonidin, exhibit higher power conversion efficiency when compared to that of C.odontophyllum skin pigment mixture (with a conversion efficiency of only 0.68%). The results indicate a possibility of masking effects of the pigments when used as a mixture. The acidification of C.odontophyllum skin pigments with concentrated hydrochloric acid improves the conversion efficiency of the mixture from 0.68% to 0.99%. The discussion in this paper will draw data and observations from the variation in absorption and adsorption properties, the HOMO-LUMO levels, the energy band gaps and the functional group compositions of the detected flavonoids.

Higher Performance of DSSC with Dyes from Cladophora sp. as Mixed Cosensitizer through Synergistic Effect

Chlorophyll and xanthophyll dyes extracted from a single source of filamentous freshwater green algae (Cladophora sp.) were used to sensitize dye sensitized solar cells and their performances were investigated. A more positive interaction is expected as the derived dyes come from a single natural source because they work mutually in nature. Cell sensitized with mixed chlorophyll and xanthophyll showed synergistic activity with improved cell performance of 1.5- to 2-fold higher than that sensitized with any individual dye. The effect of temperature and the stability of these dyes were also investigated. Xanthophyll dye was found to be more stable compared to chlorophyll that is attributed in the ability of xanthophyll to dissipate extra energy via reversible structural changes. Mixing the dyes resulted to an increase in effective electron life time and reduced the process of electron recombination during solar cell operation, hence exhibiting a synergistic effect.

Study of the Enhancement of Cell Performance of Dye Sensitized Solar Cells Sensitized With Nephelium lappaceum (F: Sapindaceae)

We have studied the performance of dye sensitized solar cells sensitized with pigments extracted from the fruit sheath of Nephelium lappaceum (F: Sapindaceae). The pH of the pigment solution used for impregnation was controlled by adding concentrated HCl (50:0.2 v/v). The UV-Vis spectroscopic results revealed that the extract consists of the pigment of Anthocyanin, with an additional absorption peak appearing around 540nm at a lower pH of the pigment solution. Also the band gap of the pigment was reduced by 1eV at low pH conditions. The solar cells fabricated with pigment extracted from the fruit sheath of Nephelium lappaceum showed photo-response with the conversion efficiency of 0.26%, with an open-circuit voltage (VOC) of 453mV, short-circuit current density (ISC) of 1.17mA cm � 2 , and fill factor (ff) of 0.48. The conversion efficiency was significantly enhanced when pH of the pigment solution was lowered by adding concentrated HCl. The conversion efficiency of the dye sensitized solar cells (DSSCs) sensitized after HCl treatment of the pigment was increased to 0.56%, with an open-circuit voltage (VOC )o f 404mV, short-circuit current density (ISC) of 2.71mA cm � 2 , and fill factor (ff) of 0.35. The HOMO level of the pigment at low pH was shown to be shifted towards more positive values with respect to vacuum level, giving rise to an enhanced DSSC efficiency. The overall efficiency enhancement of the low pH pigment was due to the combined effect of increased UV-Vis absorption and efficient adsorption of dye molecules onto the TiO2 semiconductor surface. [DOI: 10.1115/1.4023877]

Equilibrium Isotherm Studies of Adsorption of Pigments Extracted from Kuduk-kuduk (Melastoma malabathricum L.) Pulp onto TiO2 Nanoparticles

The adsorption of natural pigments onto TiO2 nanoparticles was investigated. The pigments were extracted from the dark purple colored pulp of the berry-like capsule of Kuduk-kuduk (Melastoma malabathricum L.). The Langmuir, Freundlich, Redlich-Peterson, and Sips isotherm models were used to analyze the equilibrium experimental data. Data correlated well with the Sips isotherm model, where the heterogeneity factor ( ) indicated heterogeneous adsorption characteristics, with a maximum adsorption capacity of 0.0130 mg/g. The heterogeneous adsorption character was further supported by results obtained from zeta-potential measurements. When a dye-sensitized solar cell (DSSC) was sensitized with the extracted pigment, the photo-energy conversion efficiency was measured to be 0.83%, thus proving the suitability of Kuduk-kuduk fruit pulp as a sensitizer in DSSCs.

DFT/TDDFT and Experimental Studies of Natural Pigments Extracted from Black Tea Waste for DSSC Application

We report results of combined experimental and theoretical studies of black tea waste extract (BTE) as a potential sensitizer for TiO2-dye-sensitized solar cells (DSSCs). UV-vis absorption data revealed that BTE contains theaflavin. DSSC sensitized with pigment complexes of BTE showed a photon-energy conversion efficiency of %, while a significant increase (%) is observed when pH of the pigment solution was lowered. The HOMO and LUMO energy levels were calculated using experimental data of UV-vis absorption and cyclic voltammetry. These calculations revealed a reduction of the band gap by 0.17 eV and more negativity of HOMO level of acidified pigment, compared to that of original pigment. Combined effect of these developments caused the enhanced efficiency of DSSC. Density functional theory (DFT) and time-dependent density functional theory (TDDFT) computational calculations were carried out to study the four theaflavin analogues which are responsible for the dark colour of BTE. According to the calculations, two theaflavin analogues, theaflavin and theaflavin digallate, are the most probable sensitizers in this dye-sensitized solar cell system.

Impacts of temperature on the stability of tropical plant pigments as sensitizers for dye sensitized solar cells.

Natural dyes have become a viable alternative to expensive organic sensitizers because of their low cost of production, abundance in supply, and eco-friendliness. We evaluated 35 native plants containing anthocyanin pigments as potential sensitizers for DSSCs. Melastoma malabathricum (fruit pulp), Hibiscus rosa-sinensis (flower), and Codiaeum variegatum (leaves) showed the highest absorption peaks. Hence, these were used to determine anthocyanin content and stability based on the impacts of storage temperature. Melastoma malabathricum fruit pulp exhibited the highest anthocyanin content (8.43 mg/L) followed by H. rosa-sinensis and C. variegatum. Significantly greater stability of extracted anthocyanin pigment was shown when all three were stored at 4°C. The highest half-life periods for anthocyanin in M. malabathricum, H. rosa-sinensis, and C. variegatum were 541, 571, and 353 days at 4°C. These were rapidly decreased to 111, 220, and 254 days when stored at 25°C. The photovoltaic efficiency of M. malabathricum was1.16%, while the values for H. rosa-sinensis and C. variegatum were 0.16% and 1.08%, respectively. Hence, M. malabathricum fruit pulp extracts can be further evaluated as an alternative natural sensitizer for DSSCs.

Efficiency Enhancement of Cocktail Dye of Ixora coccinea and Tradescantia spathacea in DSSC

The use of anthocyanin dyes extracted from epidermal leaves of Tradescantia spathacea (Trant) and petals of Ixora coccinea (IX) was evaluated in the application of dye-sensitized solar cells (DSSCs). Subsequently, cocktail anthocyanin dyes from these dyes were prepared and how they enhanced the cells overall performance was assessed using five different volume-to-volume ratios. Cocktail dyes absorbed a wider range of light in the visible region, thus increasing the cell efficiencies of the cocktail dyes when compared to the DSSC sensitized by individual dyes. The surface charge (zeta-potential), average size of aggregated anthocyanin molecules (zetasizer), and anthocyanin stability in different storage temperatures were analyzed and recorded. Lower size of aggregated dye molecules as revealed from the cocktail dyes ensured better adsorption onto the TiO2 film. Tradescantia/Ixora pigments mixed in 1 : 4 ratio showed the highest cell efficiency of η = 0.80%, under the irradiance of 100 mW cm−2, with a short-circuit current density 4.185 mA/cm2, open-circuit voltage of 0.346 V, and fill factor of 0.499. It was found that the desired storage temperature for these cocktail dyes to be stable over time was −20°C, in which the anthocyanin half-life was about approximately 1727 days.

Cyanidin-Based Novel Organic Sensitizer for Efficient Dye-Sensitized Solar Cells: DFT/TDDFT Study

Cyanidin is widely considered as a potential natural sensitizer in dye-sensitized solar cells due to its promising electron-donating and electron-accepting abilities and cheap availability. We consider modifications of cyanidin structure in order to obtain broader UV-Vis absorption and hence to achieve better performance in DSSC. The modified molecule consists of cyanidin and the benzothiadiazolylbenzoic acid group, where the benzothiadiazolylbenzoic acid group is attached to the cyanidin molecule by replacing one hydroxyl group. The resulting structure was then computationally simulated by using the Spartan’10 software package. The molecular geometries, electronic structures, absorption spectra, and electron injections of the newly designed organic sensitizer were investigated in this work through density functional theory (DFT) and time-dependent density functional theory (TDDFT) calculations using the Gaussian’09W software package. Furthermore, TDDFT computational calculations were performed on cyanadin and benzothiadiazolylbenzoic acid separately, as reference. The computational studies on the new sensitizer have shown a reduced HOMO-LUMO gap; bathochromic and hyperchromic shifts of absorption spectra range up to near-infrared region revealing its enhanced ability to sensitize DSSCs.

Trajectory log file sensitivity: A critical analysis using DVH and EPID

Aim The aim of this study was to investigate the sensitivity of the trajectory log file based quality assurance to detect potential errors such as MLC positioning and gantry positioning by comparing it with EPID measurement using the most commonly used criteria of 3%/3 mm. Materials and methods An in-house program was used to modified plans using information from log files, which can then be used to recalculate a new dose distribution. The recalculated dose volume histograms (DVH) were compared with the originals to assess differences in target and critical organ dose. The dose according to the differences in DVH was also compared with dosimetry from an electronic portal imaging device. Results In all organs at risk (OARs) and planning target volumes (PTVs), there was a strong positive linear relationship between MLC positioning and dose error, in both IMRT and VMAT plans. However, gantry positioning errors exhibited little impact in VMAT delivery. For the ten clinical cases, no significant correlations were found between gamma passing rates under the criteria of 3%/3 mm for the composite dose and the mean dose error in DVH (r < 0.3, P > 0.05); however, a significant positive correlation was found between the gamma passing rate of 3%/3 mm (%) averaged over all fields and the mean dose error in the DVH of the VMAT plans (r = 0.59, P < 0.001). Conclusions This study has successfully shown the sensitivity of the trajectory log file to detect the impact of systematic MLC errors and random errors in dose delivery and analyzed the correlation of gamma passing rates with DVH.