Polly M. Fordyce

Individual dimers of the mitotic kinesin motor Eg5 step processively and support substantial loads in vitro

Eg5, a member of the kinesin superfamily of microtubule-based motors, is essential for bipolar spindle assembly and maintenance during mitosis, yet little is known about the mechanisms by which it accomplishes these tasks. Here, we used an automated optical trapping apparatus in conjunction with a novel motility assay that employed chemically modified surfaces to probe the mechanochemistry of Eg5. Individual dimers, formed by a recombinant human construct Eg5–513–5His, stepped processively along microtubules in 8-nm increments, with short run lengths averaging approximately eight steps. By varying the applied load (with a force clamp) and the ATP concentration, we found that the velocity of Eg5 was slower and less sensitive to external load than that of conventional kinesin, possibly reflecting the distinct demands of spindle assembly as compared with vesicle transport. The Eg5–513–5His velocity data were described by a minimal, three-state model where a force-dependent transition follows nucleotide binding.

Stepping and Stretching HOW KINESIN USES INTERNAL STRAIN TO WALK PROCESSIVELY

The ability of kinesin to travel long distances on its microtubule track without dissociating has led to a variety of models to explain how this remarkable degree of processivity is maintained. All of these require that the two motor domains remain enzymatically “out of phase,” a behavior that would ensure that, at any given time, one motor is strongly attached to the microtubule. The maintenance of this coordination over many mechanochemical cycles has never been explained, because key steps in the cycle could not be directly observed. We have addressed this issue by applying several novel spectroscopic approaches to monitor motor dissociation, phosphate release, and nucleotide binding during processive movement by a dimeric kinesin construct. Our data argue that the major effect of the internal strain generated when both motor domains of kinesin bind the microtubule is to block ATP from binding to the leading motor. This effect guarantees the two motor domains remain out of phase for many mechanochemical cycles and provides an efficient and adaptable mechanism for the maintenance of processive movement.

De novo identification and biophysical characterization of transcription-factor binding sites with microfluidic affinity analysis

Gene expression is regulated in part by protein transcription factors that bind target regulatory DNA sequences. Predicting DNA binding sites and affinities from transcription factor sequence or structure is difficult; therefore, experimental data are required to link transcription factors to target sequences. We present a microfluidics-based approach for de novo discovery and quantitative biophysical characterization of DNA target sequences. We validated our technique by measuring sequence preferences for 28 Saccharomyces cerevisiae transcription factors with a variety of DNA-binding domains, including several that have proven difficult to study by other techniques. For each transcription factor, we measured relative binding affinities to oligonucleotides covering all possible 8-bp DNA sequences to create a comprehensive map of sequence preferences; for four transcription factors, we also determined absolute affinities. We expect that these data and future use of this technique will provide information essential for understanding transcription factor specificity, improving identification of regulatory sites and reconstructing regulatory interactions.

Combined optical trapping and single-molecule fluorescence

Background Two of the mainstay techniques in single-molecule research are optical trapping and single-molecule fluorescence. Previous attempts to combine these techniques in a single experiment – and on a single macromolecule of interest – have met with little success, because the light intensity within an optical trap is more than ten orders of magnitude greater than the light emitted by a single fluorophore. Instead, the two techniques have been employed sequentially, or spatially separated by distances of several micrometers within the sample, imposing experimental restrictions that limit the utility of the combined method. Here, we report the development of an instrument capable of true, simultaneous, spatially coincident optical trapping and single-molecule fluorescence. Results We demonstrate the capability of the apparatus by studying force-induced strand separation of a rhodamine-labeled, 15 base-pair segment of double-stranded DNA, with force applied perpendicular to the axis of the DNA molecule. As expected, we observed abrupt mechanical transitions corresponding to the unzipping of DNA at a critical force. Transitions occurred concomitant with changes in the fluorescence of dyes attached at the duplex ends, which became unquenched upon strand separation. Conclusions Through careful optical design, the use of high-performance spectral notch filters, a judicious choice of fluorophores, and the rapid acquisition of data gained by computer-automating the experiment, it is possible to perform combined optical trapping and single-molecule fluorescence. This opens the door to many types of experiment that employ optical traps to supply controlled external loads while fluorescent molecules report concurrent information about macromolecular structure.

Structure of the transcriptional network controlling white-opaque switching in Candida albicans

The human fungal pathogen Candida albicans can switch between two phenotypic cell types, termed ‘white’ and ‘opaque’. Both cell types are heritable for many generations, and the switch between the two types occurs epigenetically, that is, without a change in the primary DNA sequence of the genome. Previous work identified six key transcriptional regulators important for white‐opaque switching: Wor1, Wor2, Wor3, Czf1, Efg1, and Ahr1. In this work, we describe the structure of the transcriptional network that specifies the white and opaque cell types and governs the ability to switch between them. In particular, we use a combination of genome‐wide chromatin immunoprecipitation, gene expression profiling, and microfluidics‐based DNA binding experiments to determine the direct and indirect regulatory interactions that form the switch network. The six regulators are arranged together in a complex, interlocking network with many seemingly redundant and overlapping connections. We propose that the structure (or topology) of this network is responsible for the epigenetic maintenance of the white and opaque states, the switching between them, and the specialized properties of each state.

Eg5 steps it up

Understanding how molecular motors generate force and move microtubules in mitosis is essential to understanding the physical mechanism of cell division. Recent measurements have shown that one mitotic kinesin superfamily member, Eg5, is mechanically processive and capable of crosslinking and sliding microtubules in vitro. In this review, we highlight recent work that explores how Eg5 functions under load, with an emphasis on the nanomechanical properties of single enzymes.

Identification and characterization of a previously undescribed family of sequence-specific DNA-binding domains

Sequence-specific DNA-binding proteins are among the most important classes of gene regulatory proteins, controlling changes in transcription that underlie many aspects of biology. In this work, we identify a transcriptional regulator from the human fungal pathogen Candida albicans that binds DNA specifically but has no detectable homology with any previously described DNA- or RNA-binding protein. This protein, named White–Opaque Regulator 3 (Wor3), regulates white–opaque switching, the ability of C. albicans to switch between two heritable cell types. We demonstrate that ectopic overexpression of WOR3 results in mass conversion of white cells to opaque cells and that deletion of WOR3 affects the stability of opaque cells at physiological temperatures. Genome-wide chromatin immunoprecipitation of Wor3 and gene expression profiling of a wor3 deletion mutant strain indicate that Wor3 is highly integrated into the previously described circuit regulating white–opaque switching and that it controls a subset of the opaque transcriptional program. We show by biochemical, genetic, and microfluidic experiments that Wor3 binds directly to DNA in a sequence-specific manner, and we identify the set of cis-regulatory sequences recognized by Wor3. Bioinformatic analyses indicate that the Wor3 family arose more recently in evolutionary time than most previously described DNA-binding domains; it is restricted to a small number of fungi that include the major fungal pathogens of humans. These observations show that new families of sequence-specific DNA-binding proteins may be restricted to small clades and suggest that current annotations—which rely on deep conservation—underestimate the fraction of genes coding for transcriptional regulators.

How duplicated transcription regulators can diversify to govern the expression of nonoverlapping sets of genes

The duplication of transcription regulators can elicit major regulatory network rearrangements over evolutionary timescales. However, few examples of duplications resulting in gene network expansions are understood in molecular detail. Here we show that four Candida albicans transcription regulators that arose by successive duplications have differentiated from one another by acquiring different intrinsic DNA-binding specificities, different preferences for half-site spacing, and different associations with cofactors. The combination of these three mechanisms resulted in each of the four regulators controlling a distinct set of target genes, which likely contributed to the adaption of this fungus to its human host. Our results illustrate how successive duplications and diversification of an ancestral transcription regulator can underlie major changes in an organisms regulatory circuitry.

Basic leucine zipper transcription factor Hac1 binds DNA in two distinct modes as revealed by microfluidic analyses

A quantitative understanding of how transcription factors interact with genomic target sites is crucial for reconstructing transcriptional networks in vivo. Here, we use Hac1, a well-characterized basic leucine zipper (bZIP) transcription factor involved in the unfolded protein response (UPR) as a model to investigate interactions between bZIP transcription factors and their target sites. During the UPR, the accumulation of unfolded proteins leads to unconventional splicing and subsequent translation of HAC1 mRNA, followed by transcription of UPR target genes. Initial candidate-based approaches identified a canonical cis-acting unfolded protein response element (UPRE-1) within target gene promoters; however, subsequent studies identified a large set of Hac1 target genes lacking this UPRE-1 and containing a different motif (UPRE-2). Using a combination of unbiased and directed microfluidic DNA binding assays, we established that Hac1 binds in two distinct modes: (i) to short (6–7 bp) UPRE-2-like motifs and (ii) to significantly longer (11–13 bp) extended UPRE-1-like motifs. Using a genetic screen, we demonstrate that a region of extended homology N-terminal to the basic DNA binding domain is required for this dual site recognition. These results establish Hac1 as the first bZIP transcription factor known to adopt more than one binding mode and unify previously conflicting and discrepant observations of Hac1 function into a cohesive model of UPR target gene activation. Our results also suggest that even structurally simple transcription factors can recognize multiple divergent target sites of very different lengths, potentially enriching their downstream target repertoire.

Microfluidic affinity and ChIP-seq analyses converge on a conserved FOXP2-binding motif in chimp and human, which enables the detection of evolutionarily novel targets

The transcription factor forkhead box P2 (FOXP2) is believed to be important in the evolution of human speech. A mutation in its DNA-binding domain causes severe speech impairment. Humans have acquired two coding changes relative to the conserved mammalian sequence. Despite intense interest in FOXP2, it has remained an open question whether the human protein’s DNA-binding specificity and chromatin localization are conserved. Previous in vitro and ChIP-chip studies have provided conflicting consensus sequences for the FOXP2-binding site. Using MITOMI 2.0 microfluidic affinity assays, we describe the binding site of FOXP2 and its affinity profile in base-specific detail for all substitutions of the strongest binding site. We find that human and chimp FOXP2 have similar binding sites that are distinct from previously suggested consensus binding sites. Additionally, through analysis of FOXP2 ChIP-seq data from cultured neurons, we find strong overrepresentation of a motif that matches our in vitro results and identifies a set of genes with FOXP2 binding sites. The FOXP2-binding sites tend to be conserved, yet we identified 38 instances of evolutionarily novel sites in humans. Combined, these data present a comprehensive portrait of FOXP2’s-binding properties and imply that although its sequence specificity has been conserved, some of its genomic binding sites are newly evolved.