R. Solera

Effect of thermal pretreatment on the biogas production and microbial communities balance during anaerobic digestion of urban and industrial waste activated sludge

The effect of thermal pre-treatment on the microbial populations balance and biogas production was studied during anaerobic digestion of waste activated sludge (WAS) coming from urban (US: urban sludge) and industrial (IS: industrial sludge) wastewater treatment plants (WWTP). The highest biogas yields of 0.42l/gvolatile solid (VS) removed and 0.37l/gVS removed were obtained with urban and industrial sludge pre-treated at 120°C, respectively. Fluorescent in situ hybridization (FISH) was used to quantify the major Bacteria and Archaea groups. Compared to control trails without pretreatment, Archaea content increased from 34% to 86% and from 46% to 83% for pretreated IS and US, respectively. In fact, the thermal pre-treatment of WAS enhanced the growth of hydrogen-using methanogens (HUMs), which consume rapidly the H2 generated to allow the acetogenesis. Therefore, the stable and better performance of digesters was observed involving the balance and syntrophic associations between the different microbial populations.

Changes in microbial community during hydrogen and methane production in two-stage thermophilic anaerobic co-digestion process from biowaste.

In this paper, the microbial community in a two-phase thermophilic anaerobic co-digestion process was investigated for its role in hydrogen and methane production, treating waste activated sludge and treating the organic fraction of municipal solid waste. In the acidogenic phase, in which hydrogen is produced, Clostridium sp. clusters represented 76% of total Firmicutes. When feeding the acidogenic effluent into the methanogenic reactors, these acidic conditions negatively influenced methanogenic microorganisms: Methanosaeta sp., (Methanobacteriales, Methanomicrobiales, Methanococcales) decreased by 75%, 50%, 38% and 52%, respectively. At the same time, methanogenic digestion lowered the numbers of Clostridium sp. clusters due to both pH increasing and substrate reduction, and an increase in both Firmicutes genera (non Clostridium) and methanogenic microorganisms, especially Methanosaeta sp. (208%). This was in accordance with the observed decrease in acetic (98%) and butyric (100%) acid contents. To ensure the activity of the acetate-utilizing methanogens (AUM) and the acetogens, high ratios of H2-utilizing methanogens (HUM)/AUM (3.6) were required.

Analysis of methanogenic activity in a thermophilic-dry anaerobic reactor: Use of fluorescent in situ hybridization

Methanogenic activity in a thermophilic-dry anaerobic reactor was determined by comparing the amount of methane generated for each of the organic loading rates with the size of the total and specific methanogenic population, as determined by fluorescent in situ hybridization. A high correlation was evident between the total methanogenic activity and retention time [-0.6988Ln(x)+2.667] (R(2) 0.8866). The total methanogenic activity increased from 0.04x10(-8) mLCH(4) cell(-1)day(-1) to 0.38x10(-8) mLCH(4) cell(-1)day(-1) while the retention time decreased, augmenting the organic loading rates. The specific methanogenic activities of H(2)-utilizing methanogens and acetate-utilizing methanogens increased until they stabilised at 0.64x10(-8) mLCH(4) cell(-1)day(-1) and 0.33x10(-8) mLCH(4) cell(-1)day(-1), respectively. The methanogenic activity of H(2)-utilizing methanogens was higher than acetate-utilizing methanogens, indicating that maintaining a low partial pressure of hydrogen does not inhibit the acetoclastic methanogenesis or the anaerobic process.

Hydrogen production from the organic fraction of municipal solid waste in anaerobic thermophilic acidogenesis: Influence of organic loading rate and microbial content of the solid waste

Hydrogen production (HP) from the organic fraction of municipal solid waste (OFMSW) under thermophilic acidogenic conditions was studied. The effect of nine different organic loading rates (OLRs) (from 9 to 220 g TVS/l/d) and hydraulic retention times (HRTs) (from 10d to 0.25 d) was investigated. Normally, butyrate was the main acid product. The biogas produced was methane- and sulfide-free at all tested OLR. Increasing the OLR resulted in an increase in both the quantity and quality of hydrogen production, except at the maximum OLR tested (220 g TVS/l/d). The maximum hydrogen content was 57% (v/v) at an OLR of 110 g TVS/l/d (HRT=0.5 d). HP was in the range of 0.1-5.7 l H2/l/d. The results have clearly shown that the increase in OLR was directly correlated with HP and microbial activity. The bacterial concentration inside the reactor is strongly influenced by the content of microorganisms in the OFMSW.

Optimisation of single-phase dry-thermophilic anaerobic digestion under high organic loading rates of industrial municipal solid waste: Population dynamics

Different high feed organic loading rates (OLRs) (from 5.7 g to 46.0 g TVS/l/d) or hydraulic retention times (HRTs) (from 15 d to 2 d) in single-phase dry-thermophilic anaerobic digestion (AD) of organic fraction municipal solid waste (OFMSW) were investigated. The specific gas production (SGP) values (0.25-0.53 m(3)/kg TVS) and the percentages of Eubacteria, Archaea, H2-utilising methanogens (HUMs) and acetate-utilising methanogens (AUMs) were stable within the ranges 80.2-91.1%, 12.4-18.5%, 4.4-9.8% and 5.5-10.9%, respectively. A HUM/AUM ratio greater than 0.7 seems to be necessary to maintain very low partial pressures of H2 required for dry AD process. Increasing OLR resulted in an increase in all the populations, except for propionate-utilising acetogens (PUAs). Optimal conditions were obtained at 3d HRT (OLR=30.7 g TVS/l/d), which is lower than the doubling time of acetogens and methanogens. The methane production (MP) was clearly higher than those reported in AD of OFMSW.

Optimisation of the two-phase dry-thermophilic anaerobic digestion process of sulphate-containing municipal solid waste: Population dynamics

Microbial population dynamics and anaerobic digestion (AD) process to eight different hydraulic retention times (HRTs) (from 25d to 3.5d) in two-phase dry-thermophilic AD from sulphate-containing solid waste were investigated. Maximum values of gas production (1.9 ± 0.2 l H2/l/d; 5.4 ± 0.3 l CH4/l/d and 82 ± 9 ml H2S/l/d) and microbial activities were obtained at 4.5d HRT; where basically comprised hydrolysis step in the first phase (HRT=1.5d) and acidogenic step finished in the second phase as well as acetogenic-methanogenic steps (HRT=3d). In the first phase, hydrolytic-acidogenic bacteria (HABs) was the main group (44-77%) and Archaea, acetogens and sulphate-reducing bacteria (SRBs) contents were not significant; in the second phase (except to 2d HRT), microbial population was able to adapt to change in substrate and HRTs to ensure the proper functioning of the system and both acetogens and Archaea were dominated over SRBs. Decreasing HRT resulted in an increase in microbial activities.

Dark fermentation from real solid waste. Evolution of microbial community

The purpose of this paper was to study the evolution of microbial community and its relation to the hydrogen production (HP) steps in thermophilic-dry dark fermentation from real organic fraction of municipal solid waste (OFMSW). Nine organic loading rates (OLRs) (from 9 to 220 g TVS/l/d) were investigated. Population dynamics study showed that increasing OLR (between 9 and 110 g TVS/l/d) resulted in an increase in the relations between Eubacteria:Archaea and hydrolytic-acidogenic bacteria (HABs):acetogens. This was strongly influenced by the microbial content of the OFMSW. The presence of acetogens and Archaea was due to contribution of these microorganisms in the substrate (the biogas produced was methane-free). The maximum value of hydrolysis (63±7%) was observed at 110 g TVS/l/d OLR according to maximum HP and HAB activity. The highest average values of acidification yields (57-60%) were achieved for OLR between 28 and 43 g TVS/l/d.

Analysis of the methane production in thermophilic anaerobic reactors: use of autofluorescence microscopy

Methanogenic activity in thermophilic, anaerobic reactors was determined by comparing the amount of methane generated in single- and two-stage systems with the size of the methanogenic population, as determined by microscopy. The methanogenic activities were 2.71 × 10−9 ml methane cell−1 d−1 and 1.10 × 10−9 ml methane cell−1 d−1 for 10 and 4 days of the hydraulic retention time (HRT), in the single-stage system. In the two-stage system, 7.49 × 10−9 ml methane cell−1 d−1 in the acidogenic reactor and 1.56 × 10−9 ml methane cell−1 d−1 in the methanogenic reactor for 4 days of the HRT. A high correlation was evident between the methane production and methanogenic population [0.1354 ln(x) − 2.1375](R2 0.8619).

Anaerobic co-digestion of sewage sludge and sugar beet pulp lixiviation in batch reactors: effect of temperature.

The feasibility of anaerobic co-digestion of sewage sludge (SS) and sugar beet pulp lixiviation (SBPL) was assessed. Mesophilic and thermophilic batch assays of five different SS/SBPL ratios were used to investigate the effect of temperature, providing basic data on methane yield and reduction in total volatiles. Microbe concentrations (Eubacteria and methanogenic Archaea) were linked to traditional parameters, namely biogas production and removal of total volatile solids (TVS). The relationship between Eubacteria and Archaea was analysed. Given equal masses of organic matter, net methane generation was higher in the mesophilic range on the biochemical methane potential (BMP) test. Methane yield, TVS removal data and high levels of volatile fatty acids provided further evidence of the best behaviour of the mesophilic range. At the end of testing the microbial population under of the reactors consisted of Eubacteria and Archaea, with Eubacteria predominant in all cases.

Mesophilic anaerobic co-digestion of sewage sludge and a lixiviation of sugar beet pulp: Optimisation of the semi-continuous process

This study examine the effect of an increased organic loading rate on the efficiency of the stirred tank reactor treating sewage sludge and sugar beet pellets and to report on its steady-state performance. The digester was subjected to a program of steady-state operation over a range of hydraulic retention times (HRTs) of 30 to 6 days and organic loading rates (OLRs) of up to 1.7 kgCOD/m(3)d to evaluate its treatment capacity. The COD removal efficiency was found to be 84.23% COD in the digester when treating mixture sewage sludge/lixiviation of sugar beet pulp at 1.27 kgCOD/m(3)d (10-days SRT). The volumetric methane level produced in the digester reached 0.7 m(3)CH4/m(3)d and the methane yield was 0.64m(3)CH4/kgCODremoval. Therefore, anaerobic co-digestion of sewage sludge and lixiviation of sugar beet pulp improve the biogas productivity and the organic matter removal in addition to lowering solids retention times in the system.