Randy Scott Longtin

A multi-source inverse-geometry CT system: initial results with an 8 spot x-ray source array

We present initial experimental results of a rotating-gantry multi-source inverse-geometry CT (MS-IGCT) system. The MS-IGCT system was built with a single module of 2 × 4 x-ray sources and a 2D detector array. It produced a 75 mm in-plane field-of-view (FOV) with 160 mm axial coverage in a single gantry rotation. To evaluate system performance, a 2.5 inch diameter uniform PMMA cylinder phantom, a 200 µm diameter tungsten wire, and a euthanized rat were scanned. Each scan acquired 125 views per source and the gantry rotation time was 1 s per revolution. Geometric calibration was performed using a bead phantom. The scanning parameters were 80 kVp, 125 mA, and 5.4 µs pulse per source location per view. A data normalization technique was applied to the acquired projection data, and beam hardening and spectral nonlinearities of each detector channel were corrected. For image reconstruction, the projection data of each source row were rebinned into a full cone beam data set, and the FDK algorithm was used. The reconstructed volumes from upper and lower source rows shared an overlap volume which was combined in image space. The images of the uniform PMMA cylinder phantom showed good uniformity and no apparent artifacts. The measured in-plane MTF showed 13 lp cm(-1) at 10% cutoff, in good agreement with expectations. The rat data were also reconstructed reliably. The initial experimental results from this rotating-gantry MS-IGCT system demonstrated its ability to image a complex anatomical object without any significant image artifacts and to achieve high image resolution and large axial coverage in a single gantry rotation.

Multi-source inverse-geometry CT: From system concept to research prototype

Third-generation CT architectures are approaching fundamental limits. Dose-efficiency is limited by finite detector efficiency and by limited control over the X-ray flux spatial profile. Increasing the volumetric coverage comes with increased scattered radiation, cone-beam artifacts, Heel effect, wasted dose and cost. Spatial resolution is limited by focal spot size and detector cell size. Temporal resolution is limited by mechanical constraints, and alternative geometries such as electron-beam CT and dual-source CT come with severe tradeoffs in terms of image quality, dose-efficiency and complexity. The concept of multi-source inverse-geometry CT (IGCT) breaks through several of the above limitations [1-3], promising a low-dose high image quality volumetric CT architecture. In this paper, we present recent progress with the design and integration efforts of the first gantry-based multi-source CT scanner.

Multisource inverse-geometry CT — Prototype system integration

Todays 3rd generation CT scanners have one or two X-ray tubes, with one focal spot or “source” per vacuum chamber or “tube”. Our first multi-source inverse geometry CT prototype has eight X-ray sources. We have demonstrated multisource imaging with an 8-spot X-ray tube on a stationary gantry and a rotating phantom. We present an update on the development of the gantry-based multi-source CT scanner: we combine the multi-source X-ray tube and gantry rotation producing the first multi-source gantry-based CT scanner prototype. Currently the system is in the process of being upgraded to 32 X-ray sources to provide a larger field-of-view and to demonstrate the concept of virtual bowtie.