Regina V. Oliveira

Microwave-assisted digestion procedures for biological samples with diluted nitric acid: identification of reaction products.

Microwave-assisted sample preparation using diluted nitric acid solutions is an alternative procedure for digesting organic samples. The efficiency of this procedure depends on the chemical properties of the samples and in this work it was evaluated by the determination of crude protein amount, fat and original carbon. Soybeans grains, bovine blood, bovine muscle and bovine viscera were digested in a cavity-microwave oven using oxidant mixtures in different acid concentrations. The digestion efficiency was evaluated based on the determination of residual carbon content and element recoveries using inductively coupled plasma optical emission spectrometry (ICP OES). In order to determine the main residual organic compounds, the digests were characterized by nuclear magnetic resonance ((1)H NMR). Subsequently, studies concerning separation of nitrobenzoic acid isomers were performed by ion pair reversed phase liquid chromatography using a C18 stationary phase, water:acetonitrile:methanol (75:20:5, v/v/v)+0.05% (v/v) TFA as mobile phase and ultraviolet detection at 254 nm. Sample preparation based on diluted acids proved to be feasible and a recommendable alternative for organic sample digestion, reducing both the reagent volumes and the variability of the residues as a result of the process of decomposition. It was shown that biological matrices containing amino acids, proteins and lipids in their composition produced nitrobenzoic acid isomers and other organic compounds after cleavage of chemical bonds.

Restricted-access media supports for direct high-throughput analysis of biological fluid samples: review of recent applications

This review presents an update on the use of restricted-access materials (RAMs) for direct injection of biological samples. The fundamental improvements in the preparation of tailored RAMs and the diversity of applications with these phases are presented. Insights into diminishing the matrix effect by the use of RAM supports in methods by LC-MS and into the low number of methods for enantiomeric separations by direct injections of biological samples are addressed. The diversity of systems that incorporate RAMs for selective sample clean-up or fractionation in proteome and peptidome analysis is also covered.

Validação em métodos cromatográficos para análises de pequenas moléculas em matrizes biológicas

Chromatographic methods are commonly used for analysis of small molecules in different biological matrices. An important step to be considered upon a bioanalytical methods development is the capacity to yield reliable and reproducible results. This review discusses validation procedures adopted by different governmental agencies, such as Food and Drug Administration (USA), European Union (EU) and Agencia Nacional de Vigilância Sanitaria (BR) for quantification of small molecules by bioanalytical chromatographic methods. The main parameters addressed in this review are: selectivity, linearity, precision, accuracy, quantification and detection limits, recovery, dilution integrity, stability and robustness. Also, the acceptance criterions are clearly specified.

Quantification of cephalexin as residue levels in bovine milk by high-performance liquid chromatography with on-line sample cleanup.

A multidimensional, selective and precise high performance liquid chromatography (HPLC) method based on direct injection of biological samples has been developed for the determination of cephalexin in skimmed and whole bovine milk. The cephalosporin antibiotic was extracted from bovine milk using an octyl restricted access medium bovine serum albumin column (C(8)-RAM-BSA) and analyzed on an octadecyl column using phosphate buffer (pH 7.5, 0.01M): ACN (92:8, v/v) and ultraviolet detection at 260nm. The calibration graph was linear in the concentration range of 25-1600ng/mL and this is in accordance with the tolerance level of 100ng/mL set by the FDA (Food and Drug Administration) and EU (European Union) for cephalexin as residue in bovine milk. The intra- and inter-day coefficients of variation for the replicate analysis at the quality control levels were less than 15% while the transfer efficiency was in the range of 90.2-92.3%. The limits of detection and quantification were 10 and 20ng/mL, respectively.

Microsample analyses via DBS: challenges and opportunities

The use of DBS is an appealing approach to employing microsampling techniques for the bioanalysis of samples, as has been demonstrated for the past 50 years in the metabolic screening of metabolites and diseases. In addition to its minimally invasive sample collection procedures and its economical merits, DBS microsampling benefits from the very high sensitivity, selectivity and multianalyte capabilities of LC-MS, which has been especially well demonstrated in newborn screening applications. Only a few microliters of a biological fluid are required for analysis, which also translates to significantly reduced demands on clinical samples from patients or from animals. Recently, the pharmaceutical industry and other arenas have begun to explore the utility and practicality of DBS microsampling. This review discusses the basis for why DBS techniques are likely to be part of the future, as well as offering insights into where these benefits may be realized.

Fully-Automated Approach for Online Dried Blood Spot Extraction and Bioanalysis by Two-Dimensional-Liquid Chromatography Coupled with High-Resolution Quadrupole Time-of-Flight Mass Spectrometry

An integrated automated approach has been developed for the direct determination of drug concentrations using a SCAP DBS system for online extraction and analysis of dried blood spots (DBS) from DBS paper cards to a multidimensional liquid chromatography system coupled to a high-resolution QTOF mass spectrometry (LC-HRMS). An accurate, precise, selective, and sensitive two-dimensional liquid chromatography-high-resolution mass spectrometry (2D LC-HRMS) assay was developed and validated using small volumes of rat blood (approximately 1.25 μL) from a 2 mm DBS punch. The methodology was validated according to internationally accepted regulated bioanalysis acceptance criteria in order to establish the validity of the combination of online DBS assay and use of HRMS for quantitative bioanalysis. The fully automated procedure exhibited acceptable linearity (r(2) > 0.997) over the concentration range of 5 to 1000 ng/mL. Intra- and interday precision and accuracy runs indicated relative errors less than 20% at the LLOQ level and less than 15% at all other levels. The direct extraction and analysis of DBS samples resulted in a 5-fold improvement in assay sensitivity compared to conventional off-line extraction of punched DBS samples. In addition, the impact of blood hematocrit (Hct) on accurate quantification of the studied drugs also was evaluated, comparing Hct values of 30% and 60% against standards prepared at 45%. Hematocrit experiments show that Hct can influence the accuracy of drugs quantified by DBS and needs to be thoroughly evaluated prior to committing to validating a DBS assay. The online DBS system coupled to the LC-HRMS was then successfully applied to a pharmacokinetic study performed on male Sprague-Dawley rats after administration of a single dose of 5 and 10 mg/kg for midazolam and desipramine, respectively.

Development of a HPLC method to follow the degradation of phenol by electrochemical or photoelectrochemical treatment

The development and validation of a HPLC method to follow the degradation of phenol by electrochemical or photoelectrochemical treatment are described. This method, which allows determining amounts of phenol, p-benzoquinone and cathecol in electrolyzed or photoelectrolyzed solutions, was used for analysis of reaction intermediates during electrooxidation or photoelectrooxidation of phenol using a Ti-Pt/PbO2 (obtained by thermal-electrochemical or electrodeposition methods) or Ti/TiO2 doped with Ga3+ (obtained by thermal decomposition of precursor salts) electrode.

Determination of albendazole metabolites by direct injection of bovine plasma and multidimensional achiral–chiral high performance liquid chromatography

The development and validation of a fully automated achiral-chiral high performance liquid chromatography (HPLC) method for the simultaneous determination of albendazole metabolites: enantiomers of albendazole sulphoxide (ABZ-SO), albendazole sulphone (ABZ-SO(2)) and albendazole 2-aminosulphone (ABZ-SO(2)NH(2)) in bovine plasma are described. This method involves an octyl restricted access media bovine serum albumin column (C(8)-RAM-BSA) (50 mm x 4.6 mm I.D.) for sample clean-up, followed by enantioselective analysis on a column containing an amylose tris(3,5-dimethylphenylcarbamate) stationary phase (150 mm x 4.6 mm I.D.). The chromatographic separations of all target compounds were performed at 30 degrees C using a mobile phase composed of phosphate buffer (10 mmol L(-1); pH 7.5):acetonitrile (60:40, v/v), flow rate of 0.5 mL min(-1) and fluorescence detection at 290 nm and 320 nm, excitation and emission, respectively. The influence of different organic modifiers and chiral selector of the stationary phase on enantioseparation of ABZ-SO was investigated. The method developed was fully validated. The calibration curves were linear in the concentration range of 40.00-1280 ng mL(-1) for each albendazole sulphoxide enantiomer, 10.0-320 ng mL(-1) for albendazole sulphone and 20.0-320 ng mL(-1) for albendazole 2-aminosulphone. The inter- and intra-day precision ranged from 0.760% to 7.79% relative standard deviation (R.S.D.), and the accuracy ranged 101% from 114% of the nominal values while the transfer efficiency was in the range of 84.4-103%. The method showed good linearity, precision, accuracy, sensitivity and selectivity allowing it to be appropriate for further pharmacokinetics and metabolism studies of albendazole.

Automated direct extraction and analysis of dried blood spots employing on-line SPE high-resolution accurate mass bioanalysis.

BACKGROUND Online automated extraction of dried blood spots (DBS) via direct extraction to a solid-phase extraction (SPE) cartridge and bioanalysis by high-resolution accurate mass spectrometry was examined. The methodology was validated and used to investigate the effect of hematocrit on assay bias using partial and whole spot extractions from accurately dispensed blood samples. RESULTS The completed analysis of a DBS sample was accomplished within 2 to 3 min using the online DBS-SPE platform. Hematocrit related bias was observed (>15%) for the partial DBS extractions, but not when the whole DBS was eluted. CONCLUSION RESULTS demonstrate successful implementation of automated online DBS-SPE high-resolution accurate mass spectrometry analysis and the remediation of hematocrit bias using a capillary micro dispenser for accurate spotting of blood samples.

Direct bioanalytical sample injection with 2D LC–MS

New analytical platforms have been developed in response to the need for attaining increased peak capacity for multicomponent complex analysis with higher sensitivity and characterization of the analytes, and high-throughput capabilities. This review outlines the fundamental principles of target and comprehensive 2D LC method development and encompasses applications of LC-LC and LC × LC coupled to MS in bioanalysis using a variety of online analytical procedures. It also provides a rationale for the usage of the most employed mass analyzers and ionization sources on these platforms.