Régis Pailhé

Obesity is no longer a risk factor for dislocation after total hip arthroplasty with a double-mobility cup

PurposeDislocation is one of the most feared complications after total hip arthroplasty (THA). This risk is greater in obese patients compared with the general population.MethodsWe performed a retrospective cohort study in which the main objective was to compare the dislocation rate between obese patients (BMI > 30 kg/m²) (exposed group) and non-obese patients (BMI ≤ 30 kg/m²) (unexposed group) after primary THA with a double-mobility acetabular cup. The patients had a minimum follow-up of 24 months.ResultsThe ‘obese’ group consisted of 77 THA cases and the ‘non-obese’ group of 425 cases; the two groups were similar in terms of age, gender and ASA score. After a mean follow-up of 58.3 ± 27 months (range 27–159), 43 patients had been lost to follow-up and 56 had died; the two groups had similar mean values. One patient in the ‘obese’ group had suffered a dislocation due to a fall 16 months after the THA. One patient in the ‘non-obese’ group had suffered a dislocation after a periprosthetic femur fracture with stem subsidence two months after the THA procedure. Both patients underwent surgical revision where the double-mobility cup was preserved; there were no further dislocation events as of the last follow-up. The dislocation rate in the two groups was similar (1.3 % versus 0.23 %, p > 0.05). No cases of loosening were found. Revisions were secondary to deep or superficial infection (n = 22), periprosthetic femur fracture (n = 10) or haematoma (n = 3).ConclusionThese findings imply that double-mobility cups are a reliable way of reducing the risk of dislocation in obese patients after primary THA.

Biomechanical study of ACL reconstruction grafts

There are no published studies describing the strength quadrupled gracilis tendon alone and quadrupled semitendinosus tendon alone in the configuration used for anterior cruciate ligament (ACL) reconstruction. The primary objective was to compare the mechanical properties of grafts used for ACL reconstruction during a tensile failure test. The secondary objective was to evaluate the effect of uniform suturing on graft strength. Fifteen pairs of knees were used. The mechanical properties of five types of ACL grafts were evaluated: patellar tendon (PT), sutured patellar tendon (sPT), both hamstring tendons (GST4), quadrupled semitendinosus (ST4), and quadrupled gracilis (G4). Validated methods were used to perform the tensile tests to failure and to record the results. Students t‐test was used to compare the various samples. The maximum load to failure was 630.8N (± 239.1) for the ST4, 473.5N (± 176.9) for the GST4, 413.3N (± 120.4) for the sPT, and 416.4N (± 187.7) for the G4 construct. Only the ST4 had a significantly higher failure load than the other grafts. The sPT had a higher failure load than the PT. The ST4 construct had the highest maximum load to failure of all the ACL graft types in the testing performed here. Uniform suturing of the grafts improved their ability to withstand tensile loading.

Total knee arthroplasties from the origin to navigation: history, rationale, indications

Since the early 1970s, total knee arthroplasties have undergone many changes in both their design and their surgical instrumentation. It soon became apparent that to improve prosthesis durability, it was essential to have instruments which allowed them to be fitted reliably and consistently. Despite increasingly sophisticated surgical techniques, preoperative objectives were only met in 75% of cases, which led to the development, in the early 1990s, in Grenoble (France), of computer-assisted orthopaedic surgery for knee prosthesis implantation. In the early 2000s, many navigation systems emerged, some including pre-operative imagery (“CT-based”), others using intra-operative imagery (“fluoroscopy-based”), and yet others with no imagery at all (“imageless”), which soon became the navigation “gold standard”. They use an optoelectronic tracker, markers which are fixed solidly to the bones and instruments, and a navigation workstation (computer), with a control system (e.g. pedal). Despite numerous studies demonstrating the benefit of computer navigation in meeting preoperative objectives, such systems have not yet achieved the success they warrant, for various reasons we will be covering in this article. If the latest navigation systems prove to be as effective as the older systems, they should give this type of technology a well-deserved boost.

Moore I postero-medial articular tibial fracture in alpine skiers: Surgical management and return to sports activity

PURPOSE Over the past 10 years, like many authors, we observed an increasing number of Moore I tibial plateau fractures related to alpine skiing for which the surgeon may face difficult choices regarding surgical approach and fixation means. Some authors have recently been suggesting a posterior approach associated to open reduction and osteosynthesis by a buttress plate. But in our knowledge there is no specific study on sports activity recovery after Moore I tibial fractures. The aim of this work was to assess sports activities and clinical outcomes after surgically treated Moore I tibial plateau fractures in an athletic population of skiers. METHODS We conducted a prospective case series between 2012 and 2014. This included fifteen patients aged 39.6±7 years whom presented with a Moore I tibial plateau fracture during a skiing accident. 12 cases (80%) presented with an associated tibial spine fracture. Treatment consisted of a standard antero-medial approach, with a medial para patellar arthrotomy to allow direct visualisation of articular reduction and spinal fixation. Two or three 6.5mm long cancellous bone screws were placed antero-posteriorly so as to ensure perfect compression of the fracture site. Radiological and functional results were assessed by an independent observer (Lysholm-Tegner, UCLA, KOOS scores) at the longest follow-up. RESULTS Mean follow-up was 18.2±6 months (12-28). An immediate postoperative anatomical reduction was achieved in all cases and remained stable in time. At last follow-up Lysholm mean score was 85±14 points (59-100), UCLA score was 7.3±1.6 (4-10) and Tegner score was 4.6±1.3 (3-6). Mean KOOS score was 77±15 (54-97). 87% of patients had resumed their skiing activity and 93% were satisfied or very satisfied from their post-operative surgical outcome. We observed no pseudarthrosis or secondary varus displacement. CONCLUSION In our series 87% of patients had resumed back to their sporting activities. Surgical management of Moore I tibial plateau fractures by isolated antero-posterior screwing provides excellent clinical and radiological results. The anteromedial incision has a dual advantage of anatomical reduction, tibial spine fixation (in 80% of our cases) and posteromedial fragment reduction.

Radiological validation of a fluoroscopic guided technique for femoral implant positioning during hip resurfacing

PurposeThe positioning of the femoral cup in hip resurfacing is essential for the survival of the implant. We described a technique in 2005 to position the femoral cup guided by fluoroscopy independent of the approach performed. The main objectives were to study the positioning of the femoral components of the implant and the accuracy of the technique.MethodsBetween 2003 and 2011 we conducted a prospective study of 160 consecutive hip resurfacings all operated with this fluoroscopic-guided technique. Three independent observers performed a radiographic analysis at the pre-operative planning stage and on postoperative radiographs using OsiriX software. The statistical analysis was based on comparison of two groups by Student’s t test.ResultsThe entire implant was positioned in valgus, with an average of 7.816° valgus (p <0.001). All implants were positioned in neutral or anteverted with a mean of 1.98° (p <0.001). The risk of malpositioning on the antero-posterior plane was less than 1.41° with p <0.019. The risk of profile positioning error was lower than 0.80° with p <0.047.ConclusionThis study validates a technique of femoral implant positioning for resurfacing. It is simple, precise and independent of the approach performed.

Can the gracilis be used to replace the anterior cruciate ligament in the knee? A cadaver study

PURPOSE The purpose of this study was to evaluate whether a four-strand gracilis-only graft can be used in anterior cruciate ligament (ACL) reconstruction. STUDY DESIGN Cadaver study. METHODS This study involved 16 cadaver knees. The length and diameter of the native ACL were measured in each one. The same measurements were performed on a four-strand graft of the gracilis only, the semitendinosus only and both tendons. Students t-test was used to compare the various conditions. RESULTS The average diameter of the G4 construct was 0.07 mm greater (1%) than the native ACL (p=0.044). The average cross-sectional area of the G4 construct was 1.2 mm(2) greater (3.9%) than the native ACL (p=0.049). The G4 was on average 38.9 mm longer than the intra-articular portion of the ACL (p<0.001). CONCLUSION A four-strand gracilis construct meets the anatomical specifications for use as an ACL reconstruction graft. By using the gracilis only, the morbidity associated with harvesting the gracilis and semitendinosus tendons should be reduced. Further studies must be performed to compare the biomechanical properties of this graft with other graft types and also to evaluate how this four-strand gracilis graft behaves in a clinical setting.

Long-term evolution of slipped capital femoral epiphysis treated by in situ fixation: a 26 years follow-up of 11 hips

Slipped capital femoral epiphysis (SFCE) may lead to femoro acetabular impingement and long-term function impairment, depending on initial displacement and treatment. There are several therapeutic options which include in situ fixation (ISF). The objective of this study was to evaluate long-term functional and radiographic outcomes of patients with SFCE treated with ISF. We conducted a single-center, retrospective study evaluating the clinical and radiographic outcomes of SCFE in situ fixation with a mean follow-up of 26 years (10-47). Analysis of preoperative and last follow up radiographs was performed. The functional status of the hip was evaluated according to the Oxford hip score-12 and the radiographic osteoarthritis stage was rated according to Tönnis classification. Signs of femoro acetabular impingement were sought. Ten patients (11 hips) were included. The average initial slip was 33.5° (10-62). At final follow up, the average Oxford hip score was 19.3 (12-37), it was good for groups who had a small initial slip (16.7) or moderate (17) and fair for the severe group (27). Average Tönnis grade was 1.3 (0-3). The average alpha angle was 65.3° (50-80°). Femoro acetabular impingement was likely in 100% of patients with severe slip, in 50% of patients with moderate slip and in 33% of patients with a slight slip. In situ fixation generated poor functional results, substantial hip osteoarthritis and potential femoro acetabular impingement in moderate to severe SCFE’s. However, in cases with minor displacement, functional and radiographic results are satisfactory. The cut off seems to be around 30° slip angle, above which other treatment options should be considered.

Prospective Study Comparing Functional Outcomes and Revision Rates Between Hip Resurfacing and Total Hip Arthroplasty: Preliminary Results for 2 Years

There is a need of independent prospective studies about modern generation of hip resurfacing implants. The aim of this propective observational study was to compare the functional outcomes and revision rates with hip resurfacing arthroplasty and total hip arthroplasty and to present the preliminary results at 2 years. Patients included were recruited prospectively in the Partial Pelvic Replacement Hip Project by a single surgeon between January 2007 and January 2010. Patients were assessed with the Harris Hip Score (HHS) and Postel-Merle d’Aubigné (MDA) score and Devane Score. The end point of the study was reoperation for any cause related to the prosthesis. At a mean follow up of 38.6 months there were a total of 142 patients with hip resurfacing (group 1) [100 Durom® (Zimmer Inc., Warsaw, IN, USA) and 42 Birmingham Hip Resurfacing® (Smith & Nephew, Memphis, TN, USA)] and 278 patients with total hip arthroplasty (group 2). The results showed significantly greater gain of HHS, MDA and Devane score with hip resurfacing procedures. However, considering all the complications, the rate was significantly higher in group 16.4% vs 1.79% in group 2 (P<0.0001). In group 1 we observed 6 complications only concerned males with Durom® implants. The follow up of this cohort is still on going and may deliver more information on the evolution of these results in time.

Response to Jie et al.: How to explain the evaluation of the accuracy of patient-specific cutting blocks for total knee arthroplasty?

Dear Editor, We read with great interest the letter to the Editor entitled “How to explain the evaluation of the accuracy of patientspecific cutting blocks for total knee arthroplasty?” by Jie et al. [1] that was published in the December 2014 issue of International Orthopaedics. This letter was a comment on our recently published article entitled “Evaluation of the accuracy of patient-specific cutting blocks for total knee arthroplasty: a meta-analysis” [2]. Wewere very surprised to come across this letter to the Editor whilst we were doing additional research on the topic of patientspecific cutting blocks, a subject that we feel strongly about. As the authors of the original article in question, we would like to have been informed of these remarks so as to exercise our right to respond immediately in the same issue of the journal. In addition, there was no indication in the title that comments were being made specifically on our article, as is typically done.

Recurring intraprosthetic dislocation of rotating-hinge total knee prosthesis. Effect of implant design on intrinsic stability

During total knee replacement, hinged total knee implants are used in cases where ligament balancing cannot be achieved with less-constrained implants. The case of a patient who experienced two episodes of intraprosthetic dislocation of his rotating-hinge total knee prosthesis is described. There are very few reports of this type of dislocation with these implants. The implants design, particularly of the hinge, plays an important role in stability. The balance between the flexion and extension spaces is very important even when using a hinged total knee implant. The role of the extensor mechanism in anteroposterior stability is reviewed, along with simple ways to augment it.