Rémi Courson

Aeropectin: Fully Biomass-Based Mechanically Strong and Thermal Superinsulating Aerogel

Monolithic pectin aerogels, aeropectins, were prepared via dissolution-gelation-coagulation and subsequent drying with supercritical CO2. Aeropectin had pore sizes that varied from mesopores to small macropores and compression moduli in the range from 4 to 18 MPa. Aeropectins show plastic deformation up to 60% strain before the pore walls collapse. Pectin aerogels have a thermal conductivity below that of air in ambient conditions, making them new thermal superinsulating fully biomass-based materials. The contribution of gas and solid conduction plus radiative heat transfer were determined and discussed.

Multiphoton Direct Laser Writing and 3D Imaging of Polymeric Freestanding Architectures for Cell Colonization

The realization of 3D architectures for the study of cell growth, proliferation, and differentiation is a task of fundamental importance for both technological and biological communities involved in the development of biomimetic cell culture environments. Here we report the fabrication of 3D freestanding scaffolds, realized by multiphoton direct laser writing and seeded with neuroblastoma cells, and their multitechnique characterization using advanced 3D fluorescence imaging approaches. The high accuracy of the fabrication process (≈200 nm) allows a much finer control of the micro- and nanoscale features compared to other 3D printing technologies based on fused deposition modeling, inkjet printing, selective laser sintering, or polyjet technology. Scanning electron microscopy (SEM) provides detailed insights about the morphology of both cells and cellular interconnections around the 3D architecture. On the other hand, the nature of the seeding in the inner core of the 3D scaffold, inaccessible by conventional SEM imaging, is unveiled by light sheet fluorescence microscopy and multiphoton confocal imaging highlighting an optimal cell colonization both around and within the 3D scaffold as well as the formation of long neuritic extensions. The results open appealing scenarios for the use of the developed 3D fabrication/3D imaging protocols in several neuroscientific contexts.

Multilevel (3D) lab on chip for implementing reconfigurable magnetophoretic functionnalities

This study demonstrates the integration of a multilevel magnetophoretic lab on chip: combining 3D fluid engineering and localized magnetic actuation enables the full integration of a cell tagging and magnetic separation device. A system performing magnetic handling of beads at cell resolution was also devised based on the same technologies.