Riasat Ali

Evaluation of the impacts of deep open drains on groundwater levels in the wheatbelt of Western Australia

Abstract. Over one million hectares of the wheatbelt of Western Australia (WA) are affected by secondary salinisation and this area is expected to increase to between 3 and 5 million hectares if current trends continue. Deep open drains, as an engineering solution to dryland salinity, have been promoted over the past few decades; however, the results of initial experiments were variable and no thorough analysis has been done. This research quantifies the effects of deep open drains on shallow and deep groundwater at farm and subcatchment level. Analysis of rainfall data showed that the only dry year (below average rainfall) after the construction of drainage in the Narembeen area of WA (in 1998 and 1999) was 2002. The dry year caused some decline in groundwater levels in the undrained areas but had no significant impact in the drained areas. The study found that the effect of drains on the groundwater levels was particularly significant if the initial water levels were well above the drain bed level, permeable materials were encountered, and drain depth was adequate (2.0–3.0 m). Visual observations and evidence derived from this study area suggested that if the drain depth cut through more permeable, macropore-dominated siliceous and ferruginous hardpans, which exist 1.5–3 m from the soil surface, its efficiency exceeded that predicted by simple drainage theory based on bulk soil texture. The effect of drains often extended to distances away (>200 m) from the drain. Immediately following construction, drains had a high discharge rate until a new hydrologic equilibrium was reached. After equilibrium, flow largely comprised regional groundwater discharge and was supplemented by quick responses driven by rainfall recharge. Comparison between the hydrology of the drained and undrained areas in the Wakeman subcatchment showed that, in the valley floors of the drained areas, the water levels fluctuated mainly between 1.5 and 2.5 m of the soil surface during most of the year. In the valley floors of the undrained areas, they fluctuated between 0 and 1 m of the soil surface. The impact of an extreme rainfall event (or unusual wet season) on drain performance was predicted to vary with distance from the drain. Within 100 m from the drain, water levels declined relatively quickly, whereas it took a year before the water levels at 200–300 m away from the drain responded. The main guidelines that can be recommended based on the results from this study are the drain depth and importance of ferricrete layer. In order to be effective, a drain should be more than 2 m deep and it should cut through the ferricrete layer that exists in many landscapes in the wheatbelt.

Groundwater Resource Assessment and Conceptualization in the Pilbara Region, Western Australia

The Pilbara region is one of the most important mining hubs in Australia. It is also a region characterised by an extreme climate, featuring environmental assets of national significance, and considered a valued land by indigenous people. Given the arid conditions, surface water is scarce, shows large variability, and is an unreliable source of water for drinking and industrial/mining purposes. In such conditions, groundwater has become a strategic resource in the Pilbara region. To date, however, an integrated regional characterization and conceptualization of the occurrence of groundwater resources in this region were missing. This article addresses this gap by integrating disperse knowledge, collating available data on aquifer properties, by reviewing groundwater systems (aquifer types) present in the region and identifying their potential, and proposing conceptualizations for the occurrence and functioning of the groundwater systems identified. Results show that aquifers across the Pilbara Region vary substantially and can be classified in seven main types: coastal alluvial systems, concealed channel iron deposits, inland valley-fill aquifers, karstified dolomites, sandstone aquifers (West Canning Basin), Permian/Cenozoic Paleochannels, and Fractured Rock aquifers. Coastal alluvial systems show the greatest regional potential as water sources and are currently intensively utilised. Conceptually, the main recharge processes are infiltration of precipitation associated with cyclonic events and the interaction with streamflows during summer season, whereas the main discharge mechanisms correspond to evapotranspiration from riverine and coastal vegetation, discharge into the Indian Ocean, and dewatering of iron-ore bodies to facilitate mining activities. Important gaps in the knowledge relate to aquifer connectivity and accurate quantification of recharge/discharge mechanisms.