Richard L. Wixson

Functional Outcome and Patient Satisfaction in Total Knee Patients Over the Age of 75

Seventy-four patients, age 75 or older, who had undergone 98 primary total knee arthroplasties were evaluated in a retrospective cohort study, with validated questionnaires that assessed self-reported pain, physical function, mental health, and satisfaction. Average follow-up period was 34 months (range, 12-67 months). Overall, 90.8% reported improvement, 88.8% were satisfied with the results of surgery, and 91.8% felt they had made the right decision. Dissatisfaction with the results correlated with poorer mental health scores, decreased physical function, and increased bodily pain scores (P < .05). Satisfaction was correlated with better pain scores on the Western Ontario and McMaster Universities Osteoarthritis Index (WOMAC) and SF-36 (P < .05) but not with Hospital for Special Surgery scores (P = .328). Poor surgical results leading to revision surgery (5%) were associated with preoperative deformity greater than 20 degrees. Based on this patient-assessed outcome analysis, total knee arthroplasty is a worthwhile and beneficial procedure in the elderly.

Adverse Local Tissue Reaction Arising from Corrosion at the Femoral Neck-Body Junction in a Dual-Taper Stem with a Cobalt-Chromium Modular Neck

BACKGROUND Femoral stems with dual-taper modularity were introduced to allow additional options for hip-center restoration independent of femoral fixation in total hip arthroplasty. Despite the increasing availability and use of these femoral stems, concerns exist about potential complications arising from the modular neck-body junction. METHODS This was a multicenter retrospective case series of twelve hips (eleven patients) with adverse local tissue reactions secondary to corrosion at the modular neck-body junction. The cohort included eight women and three men who together had an average age of 60.1 years (range, forty-three to seventy-seven years); all hips were implanted with a titanium-alloy stem and cobalt-chromium-alloy neck. Patients presented with new-onset and increasing pain at a mean of 7.9 months (range, five to thirteen months) following total hip arthroplasty. After serum metal-ion studies and metal artifact reduction sequence (MARS) magnetic resonance imaging (MRI) revealed abnormal results, the patients underwent hip revision at a mean of 15.2 months (range, ten to twenty-three months). Tissue specimens were examined by a single histopathologist, and the retrieved implants were studied with use of light and scanning electron microscopy. RESULTS Serum metal levels demonstrated greater elevation of cobalt (mean, 6.0 ng/mL) than chromium (mean, 0.6 ng/mL) or titanium (mean, 3.4 ng/mL). MRI with use of MARS demonstrated adverse tissue reactions in eight of nine patients in which it was performed. All hips showed large soft-tissue masses and surrounding tissue damage with visible corrosion at the modular femoral neck-body junction. Available histology demonstrated large areas of tissue necrosis in seven of ten cases, while remaining viable capsular tissue showed a dense lymphocytic infiltrate. Microscopic analysis was consistent with fretting and crevice corrosion at the modular neck-body interface. CONCLUSIONS Corrosion at the modular neck-body junction in dual-tapered stems with a modular cobalt-chromium-alloy femoral neck can lead to release of metal ions and debris resulting in local soft-tissue destruction. Adverse local tissue reaction should be considered as a potential cause for new-onset pain in patients with these components, and early revision should be considered given the potentially destructive nature of these reactions. A workup including serologic studies (erythrocyte sedimentation rate and C-reactive protein), serum metal levels, and MARS MRI can be helpful in establishing this diagnosis.

Use of helical computed tomography for the assessment of acetabular osteolysis after total hip arthroplasty.

Background: Acetabular osteolysis is a major problem affecting long-term survival of total hip prostheses. Since lytic lesions may be asymptomatic until extensive bone loss has occurred, early detection of lytic lesions is important. The purposes of this study were to determine the efficacy and potential role of high-resolution helical (or spiral) computed tomography with metal-artifact minimization in the early detection of osteolysis of the pelvis and to use the method to determine if there was a relationship between the extent of osteolysis and the amount of polyethylene wear. Methods: Forty patients (fifty hips) who had undergone primary cementless total hip arthroplasty between 1988 and 1994 were evaluated as part of an ongoing prospective study. These patients had a history of high-level activity that was believed to place them at increased risk for accelerated polyethylene wear. The most recent follow-up radiographs were compared with the three-month postoperative radiographs. Helical computed tomography scans with metal-artifact minimization were made, and evidence of osteolytic lesions on these scans was compared with that on the radiographs. Two-dimensional wear analysis was performed with use of digitized radiographs, and the results were compared with loss of bone volume as calculated from the computed tomography scans. Results: Acetabular lysis was identified on the radiographs of sixteen hips and on the computed tomography scans of twenty-six hips. Radiographs underestimated the extent of the lysis in thirteen of the sixteen hips. There was no correlation (r = 0.036) between linear wear and the measured volume of bone loss, with the numbers available. On the basis of the amount of lysis seen on the computed tomography scans, one patient underwent a revision procedure. Conclusions: Helical computed tomography with metal-artifact minimization is more sensitive for identifying and quantifying osteolysis after total hip arthroplasty than is plain radiography. Since computed tomography scans show both the extent and the location of lytic lesions, they are useful to guide treatment decisions as well as to assist in planning for surgical intervention, when needed, in patients with suspected osteolysis.

Vacuum mixing of acrylic bone cement

A partial-vacuum (500-550 mmHg), slow-speed (2 Hz) system for optimal blending of the liquid and powder components of Simplex-P acrylic bone cement was developed to eliminate five different sources of porosity observed with x-ray during the course of cement preparation and specimen fabrication. The vacuum mixing system produces set specimens of less than 1% porosity that have significant improvements over specimens prepared with conventional mixing in the mechanical properties of tensile and compressive strength and uniaxial tensile fatigue life. Hence, a much stronger cement can be available in surgery without any change in original chemical composition.

The influence of prosthetic stem stiffness and of a calcar collar on stresses in the proximal end of the femur with a cemented femoral component.

UNLABELLED We used three-dimensional finite-element models of the proximal end of the femur to examine the influence of stem material, stem geometry, and the use of a calcar collar on the stresses in and around implanted total hip-replacement femoral components. Anatomical bone geometries and realistic prosthetic geometries were considered. A slender titanium-alloy stem with a collar allows creation of calcar stresses of approximately 80 per cent of the anticipated normal levels. A similar stem of cobalt-chromium alloy creates calcar stresses of 67 per cent of these normal values. Stem designs without a collar were shown to generate no more than 40 per cent of normal values while larger, stiffer stems were seen to create less than 30 per cent of normal values, with or without a collar. Proximal cement stresses were increased by the use of titanium-alloy stems, but were reduced to low levels by a functioning collar. The highest cement stresses in the system were found near the tip of the stem, where titanium-alloy stems create lower stresses than do corresponding cobalt-chromium-alloy stems. The achievability of calcar loading with a titanium prosthesis was demonstrated in in vitro strain-gauge tests. CLINICAL RELEVANCE Loosening of the femoral stem and calcar resorption are problems that are seen in many long-term clinical series of total hip prostheses. In order to reduce the incidence of these problems, the goal of the designer of a prosthesis is to reduce cement and cement interface stresses around the femoral stem and to create stress distributions in the bone that will prevent resorption.(ABSTRACT TRUNCATED AT 250 WORDS)

Preoperative risks and outcomes of hip and knee arthroplasty in the veterans health administration

The relationship between patient characteristics and outcomes of total joint arthroplasty (TJA) was examined in a population of veterans treated in VA hospitals. Outcomes included 30-day mortality and morbidity, postoperative length of stay, and readmission caused by surgical complications. A larger proportion of women then men were functionally impaired before surgery in both the hip (22% vs. 14%) and knee samples (14% vs. 7%; all P<.01). Rates of adverse outcomes in this population were very low. Preoperative comorbid conditions, abnormal laboratory values, and being nonwhite were related to poor outcomes of TJA. Gender was a significant independent predictor of morbidity and length of stay for total knee arthroplasty.

How superior placement of the joint center in hip arthroplasty affects the abductor muscles

This study examines the effects of a superiorly placed hip center on the strength of the abductor muscles. A 3-dimensional computer model of the hip and the surrounding musculature was used to calculate the moment arms, forces, and moments generated when the hip abductor muscles are maximally activated. A representation of a hip prosthesis was implanted into the computer model with altered hip center positions and a range of prosthetic neck lengths. Analysis of these simulated hip replacements demonstrated that superolateral placement of the hip center (2 cm superior and 2 cm lateral) decreases the moment arms of the hip abductor muscles by an average of 28%. This decrease in moment arm cannot be restored by increasing prosthetic neck length, resulting in an unrecoverable loss of abduction strength with superolateral displacement. By contrast, a 2-cm superior displacement of the hip center changes the moment arms and force generating capacities of the abductors by less than 10% if prosthetic neck length is increased to compensate for decreased muscle length. The results of this study suggest that superior positioning of the hip center, without lateral placement, does not have major, adverse effects on abduction moment arms or force generating capacities when the neck length is appropriately increased.

A prospective, randomized study of preoperative autologous donation for hip replacement surgery.

Background: Preoperative autologous blood donation is commonly performed to meet potential perioperative transfusion needs and is a common practice prior to total hip arthroplasty. Using standardized transfusion guidelines, we prospectively analyzed the effectiveness of preoperative autologous donation as a method for decreasing allogeneic transfusion among patients undergoing unilateral primary total hip replacement who were eligible to donate autologous blood.Methods: Patients who were scheduled for primary total hip replacement surgery and who had a preoperative baseline hemoglobin level ≥120 g/L were randomized either to donate two units of blood (autologous donors) or not to donate any blood (nondonors). The donors and nondonors were compared with regard to demographic data, blood-loss volumes, hemoglobin measurements, and transfusion rates. Randomization continued until data were obtained from at least forty patients per treatment group.Results: Of the ninety-six patients who completed the study, forty-two were autologous donors and fifty-four were nondonors. There were no significant differences between the donors and nondonors with regard to age, male:female ratio, estimated blood volume, baseline physical condition, or operative blood loss. The hemoglobin values at the time of enrollment (baseline), at the time of hospital discharge, and six weeks postoperatively were not significantly different between the two groups, although values at the time of admission (129 ± 13 g/L versus 138 ± 12 g/L) and in the recovery room (104 ± 12 g/L versus 115 ± 13 g/L) were significantly lower in the autologous donor group (p < 0.05). No patient in either group required an allogeneic transfusion. Twenty-nine (69%) of the forty-two donors received an autologous transfusion. Thirty-four (41%) of eighty-two autologous units were wasted. At a charge of

Total hip replacement with cemented, uncemented, and hybrid prostheses. A comparison of clinical and radiographic results at two to four years.

379 per autologous unit, there was an additional cost of

What Do We Know About Taper Corrosion in Total Hip Arthroplasty

758 for each patient in the donor group.Conclusions: Preoperative autologous donation provided no benefit for nonanemic patients undergoing primary total hip replacement surgery. Preoperative autologous donation increased the likelihood of autologous transfusion, wastage of predonated units, and costs.