Rodrigo F. B. De Souza

Ethanol oxidation reaction on IrPtSn/C electrocatalysts with low Pt content

In this work, the ethanol oxidation reaction (EOR) was investigated using ternary nanostructured materials composed of IrPtSn/C in mass proportions of Ir:Pt:Sn at 60:30:10, 60:20:20 and 60:10:30, prepared with a polymeric precursor method and compared with commercial electrocatalyst PtSn/C E-TEK. X-ray diffractometry was used to obtain information about the structure of the material. The transmission electron microscopy showed particle sizes of 5-7 nm. The electrocatalytic activity was investigated using chronoamperometry experiments at 0.5 V vs. RHE and by in situ Fourier transform infrared spectroscopy by attenuated total reflectance (FTIR-ATR) experiments. From in situ FTIR-ATR experiments, it can be seen that using the best material IrPtSn/C 60:20:20, the acetaldehyde was produced at high intensities and CO2 at lower intensities. The use of IrPtSn/C 60:20:20 materials became possible to diminish the Pt fraction to ca. 73% in comparison to the PtSn/C E-TEK electrocatalyst, with an improvement of ca. 282% in the current density of the chronoamperometric experiments.

Glycerol electrooxidation in alkaline medium using Pd/C, Au/C and PdAu/C electrocatalysts prepared by electron beam irradiation

Pd/C, Au/C and PdAu/C electrocatalysts with different atomic ratios prepared using electron beam irradiation were tested for glycerol electrooxidation in single alkaline direct glycerol fuel cell (ADGFC). X-ray diffractograms (XRD) of PdAu/C electrocatalysts showed the presence of Pd (fcc) and Au (fcc) phases. Cyclic voltammetry (CV) and chronoamperometry showed that PdAu/C electrocatalyst with Pd:Au atomic ratio of 50:50 demonstrated superior activity for glycerol electrooxidation, at room temperature. In situ Fourier transform infrared spectroscopy by attenuated total reflectance (ATR-FTIR) experiments were performed for the electrocatalysts, identifying oxalate, glycerate ion, 1,3-dihydroxy-2-propanone, glyceraldehyde and glycolate as products of glycerol electrooxidation. Experiments with single ADGFC were carried out from 50 to 90 oC, using Pd/C electrocatalyst; the best performance was obtained at 80 oC.

PtSnIr/C anode electrocatalysts: promoting effect in direct ethanol fuel cells

This study investigates the promoting effect of PtSnIr/C (1:1:1) electrocatalyst anode, prepared by polymeric precursor method, on the ethanol oxidation reaction in a direct ethanol fuel cell (DEFC). All of the materials used were 20% metal m/m on carbon. X-ray photoelectron spectroscopy (XPS) analysis showed the presence of Pt, PtOH2, PtO2, SnO2xa0and IrO2 at the electrocatalyst surface, indicating a possible decorated particle structure. X-ray diffractometry (XRD) analysis indicated metallic Ptxa0and Ir as well as the formation of an alloy with Sn. Using the PtSnIr/C electrocatalyst prepared here with two times lower loading of Pt than PtSn/C E-tek electrocatalyst, it was possible to obtain the same maximum power density found for the commercial material. The main reaction product was acetic acid probably due to the presence of oxides, in this point the bifunctional mechanism is predominant, but an electronic effect should not be discarded.

Reaproveitamento de óxidos de manganês de pilhas descartadas para eletrocatálise da reação de redução de oxigênio em meio básico

The oxygen reduction reaction was studied in alkaline media using manganese oxides obtained from spent batteries as electrocatalysts. Three processes were used to recover manganese oxides from spent batteries. The particles obtained were in the range from 8 to 11 nm. The electrochemical experiments indicated a good electrocatalytic activity toward oxygen reduction using the different samples and showing approximately a direct transference of 4 electrons during the process. Even though all the processes were efficient, the best result was observed for the prepared sample using reactants of low cost.