Rogéli Tibúrcio Ribeiro da Cunha Peixoto

Light Transmission through a Translucent Fiber Post

This study is a quantitative assessment of the luminous energy transmitted through different translucent fiber posts. After embedding the posts in black resin, the blocks were submitted to sequential cuts in a precision machine, and depths of 16 mm, 12 mm, 8 mm, and 4 mm were assessed for light transmission with a digital photometer. The quantitative analysis showed significant differences between different posts and depths. Furthermore, the values obtained revealed that the quantity of luminous energy transmitted depends on the type of post and that for all of them there was a significant reduction of the quantity of light transmitted as the depth increased. Even without the post, the luminous intensity inside the canal seems to decrease to levels that are insufficient for polymerization, especially in the apical third.

LED and Halogen Light Transmission through a CAD/CAM Lithium Disilicate Glass-Ceramic

The effect of thickness, shade and translucency of CAD/CAM lithium disilicate glass-ceramic on light transmission of light-emitting diode (LED) and quartz-tungsten-halogen units (QTH) were evaluated. Ceramic IPS e.max CAD shades A1, A2, A3, A3.5, high (HT) and low (LT) translucency were cut (1, 2, 3, 4 and 5 mm). Light sources emission spectra were determined. Light intensity incident and transmitted through each ceramic sample was measured to determine light transmission percentage (TP). Statistical analysis used a linear regression model. There was significant interaction between light source and ceramic translucency (p=0.008) and strong negative correlation (R=-0.845, p<0.001) between ceramic thickness and TP. Increasing one unit in thickness led to 3.17 reduction in TP. There was no significant difference in TP (p=0.124) between shades A1 (ß1=0) and A2 (ß1=-0.45) but significant reduction occurred for A3 (ß1=-0.83) and A3.5 (ß1=-2.18). The interaction QTH/HT provided higher TP (ß1=0) than LED/HT (ß1=-2.92), QTH/LT (ß1=-3.75) and LED/LT (ß1=-5.58). Light transmission was more effective using halogen source and high-translucency ceramics, decreased as the ceramic thickness increased and was higher for the lighter shades, A1 and A2. From the regression model (R2=0.85), an equation was obtained to estimate TP value using each variable ß1 found. A maximum TP of 25% for QTH and 20% for LED was found, suggesting that ceramic light attenuation could compromise light cured and dual cure resin cements polymerization.