Rosa María Alonso

LC-MS/MS method for the determination of several drugs used in combined cardiovascular therapy in human plasma

A simple, fast and validated method is reported for the simultaneous analysis, in human plasma, of several drugs usually combined in cardiovascular therapy (atenolol, bisoprolol, hydrochlorothiazide, chlorthalidone, salicylic acid, enalapril and its active metabolite enalaprilat, valsartan and fluvastatin) using high performance liquid chromatography-tandem mass spectrometry (LC-MS/MS) with electrospray ionization (ESI), working in multiple reaction monitoring mode (MRM). Separation of analytes and internal standard (pravastatin) was performed on a Luna C18(2) (150mm×4.6mm, 3μm) column using a gradient elution mode with a run time of 15min. The mobile phase consisted of a mixture of acetonitrile and water containing 0.01% formic acid and 10mM ammonium formate at pH 4.1. Sample treatment consisted of a simple protein precipitation with acetonitrile, enabling a fast analysis. The method showed good linearity, precision (RSD% values between 0.7% and 12.7%) and accuracy (relative error values between 0.9% and 14.0%). Recoveries were within 68-106% range and the ion-suppression was not higher than 22% for any analyte. The method was successfully applied to plasma samples obtained from patients under combined cardiovascular treatment.

Development of an LC-MS/MS method for the quantitation of 55 compounds prescribed in combined cardiovascular therapy

This paper reports an LC-MS/MS method with positive electrospray ionization for the screening of commonly prescribed cardiovascular drugs in human plasma, including compounds with antihypertensive (57), antidiabetic (12), hypolipemiant (5), anticoagulant (2) and platelet anti-aggregation (2) effects. Sample treatment consisted of a simple protein precipitation with MeOH/0.1 M ZnSO₄ (4:1, v/v) solution after the addition of internal standard, followed by evaporation and reconstitution. Analytes separation was performed on a Polar-RP column (150 m x 2 mm, 4 μm) using a gradient elution of 15 min. The MS system was operated in MRM mode, monitoring one quantitation and one confirmation transition for each analyte. The recovery of the protein precipitation step ranged from 50 to 70% for most of the compounds, while some were considerably affected by matrix effects. Since several analytes fulfilled the linearity, accuracy and precision values required by the ICH guidelines, the method proved to be suitable for their quantitative analysis. The limits of quantitation varied from 0.38 to 9.1 μg/L and the limits of detection from 0.12 to 5.34 μg/L. The method showed to be suitable for the detection of plasma samples of patients under cardiovascular treatment with the studied drugs, and for 55 compounds reliable quantitative results could be obtained.

Validated Quantitation of Angiotensin II Receptor Antagonists (ARA-II) in Human Plasma by Liquid-Chromatography-Tandem Mass Spectrometry Using Minimum Sample Clean-up and Investigation of Ion Suppression

For the quantitation of angiotensin II receptor antagonists (ARA-II) in human plasma, a method using liquid-chromatography (LC)-electrospray ionization tandem mass spectrometry (MS/MS) has been developed with respect to simple sample clean-up and investigation of ion suppression effects. For sample preparation, protein precipitation using zinc sulphate and methanol showed advantages in speed, recovery, and reproducibility over solid-phase extraction. A triple quadrupole mass spectrometer (Sciex API 365) with turbo ionspray source was used for detection of compounds with multireaction monitoring (MRM) of two transitions per compound. Suppression effects caused by endogenous matrix compounds were investigated by post-column infusion of analytes and LC analysis of precipitates of blank plasma samples and could be excluded. A validation was performed for the ARA-II drugs (valsartan, irbesartan, losartan and its active metabolite EXP 3174, eprosartan, candesartan, and telmisartan). The developed method showed good intra- and interday precision (<12% relative standard deviation) and accuracy (<11.5% bias) at different concentrations for all the studied compounds. The calculated lower limits of quantitation were between 7 and 13 ng/mL, and the compounds were stable during the analytical process. These rather expensive drugs against hypertension are prescribed with increasing numbers in Europe and the industrialized nations. Complications might arise from overdosage or metabolic disorders. However, drug monitoring is not usually performed. Because the therapeutic concentrations range from a few nanograms to hundreds of nanograms per milliliter for the different drugs, and they are not amenable to gas chromatography/MS analysis because of their high molecular weight and polarity, the LC-MS/MS method is the golden standard for therapeutic drug monitoring and for clinical and forensic toxicology of ARA-II drugs.

Optimization and validation of a SPE-HPLC-PDA-fluorescence method for the simultaneous determination of drugs used in combined cardiovascular therapy in human plasma.

This paper reports the chemometrical optimization and the validation of a quantitative high performance liquid chromatography-photodiode array-fluorescence (HPLC-PDA-Fluo) method for the simultaneous analysis, in human plasma, of drugs usually combined in cardiovascular therapy. Separation of chlorthalidone (CLTD), valsartan (VAL), valsartan-M1 (VAL-M1), fluvastatin (FLUV) and the internal standard (IS) candesartan cilexetil was performed on a dC18 Atlantis column (100 mm x 3.9 mm, 3 microm) using a gradient with a run time of 15 min. The mobile phase consisted of a mixture of acetonitrile and water containing 0.01% of formic acid and 10 mM of ammonium formate at pH 4.1. UV and fluorimetric (valsartan, its metabolite and fluvastatin) detectors were used. The sample preparation consisted of protein precipitation using acetonitrile suited to a solid-phase extraction (SPE) on a Strata-X cartridge for sample clean-up. Method validation was developed following the recommendations for bioanalytical method validation of International Conference on Harmonisation (ICH) and Food and Drug Administration (FDA) organizations. The method showed good linearity (31-3000 microg/l for chlorthalidone, 20-1000 microg/l for valsartan-M1, 10-5000 microg/l for valsartan and 14-1000 microg/l for fluvastatin), precision and accuracy. Recoveries were in the range of 78-91%. This method allowed the determination of these drugs in human plasma samples obtained from patients under cardiovascular treatment.

Validation of a fast liquid chromatography-UV method for the analysis of drugs used in combined cardiovascular therapy in human plasma.

Ultra-performance liquid chromatography (UPLC) was investigated as a faster alternative to high-performance liquid chromatography (HPLC) for the simultaneous analysis of drugs usually prescribed in cardiovascular therapy. Upon a previously developed and validated solid phase extraction (SPE)-HPLC-photodiode array (PDA)-fluorescence (FLR) method, separation of chlorthalidone (CLTD; diuretic), valsartan and its metabolite (VAL and VAL-M1 respectively; angiotensin II receptor antagonist drugs) and fluvastatin (FLUV; statin) was performed in human plasma using an RP C18 column (50mmx2.1mm, 1.7microm, Waters Acquity UPLC (BEH)) and a tunable UV-vis (TUV) detector. After method transfer, different system variables were modulated to study the evolution of responses of the analytes and the endogenous interferences. The improved method was fully validated and the results were compared with its precursor HPLC method relating to analysis time, efficiency and sensitivity. The studied compounds were separated in less than 8min and the method showed good linearity (20-3000microg/L for chlorthalidone, 110-1100microg/L for valsartan-M1, 67-1900microg/L for valsartan and 48-1100microg/L for fluvastatin), precision and accuracy. The proposed method was found to be reproducible (RSD<10%), accurate (RE<15%), robust and suitable for quantitative analysis of the studied drugs in plasma obtained from patients under combined cardiovascular treatment.

Separation and quantitation of several angiotensin II receptor antagonist drugs in human urine by a SPE–HPLC–DAD method

In this work, an SPE-HPLC method coupled to photodiode array detection was validated in human urine matrix, in order to monitor four antihypertensive angiotensin II receptor antagonist drugs in patients under cardiovascular treatment. For that purpose, experimental design was used. Quantitation was accomplished by the internal standard method. The obtained LOQs were 95, 113, 125, and 85 ng/mL for eprosartan, telmisartan, irbesartan, and valsartan, respectively. The intraday and interday precision and accuracy at four concentration levels in the working range (LOQ-15 microg/mL) were always lower than 11% RSD and 8% relative error. The urine samples proved to be stable during 4 h at room temperature, after three thaw-freeze cycles, and for 2 months at -20 degrees C. No interferences from other endogenous compounds or co-administered drugs were found. The method has been successfully applied to monitor the renal elimination of eprosartan and valsartan during 24 h.

Capillary zone electrophoresis applied to the determination of the angiotensin-converting enzyme inhibitor cilazapril and its active metabolite in pharmaceuticals and urine

A capillary zone electrophoresis method has been developed for the quantitation of antihypertensive drug cilazapril and its active metabolite cilazaprilat in pharmaceuticals and urine. The separation of the compounds was performed in a fused-silica capillary filled with the running electrolyte, which consisted of a 60 mM borate buffer solution at pH 9.5. Under the optimized experimental conditions, the separation took less than 5 min. The analysis of urine samples required a previous solid-phase extraction step using C8 cartridges. The method was successfully applied to the determination of the drug and its metabolite in urine samples obtained from three hypertensive patients (detection limits of 115 ng ml(-1) for cilazaprilat and 125 ng ml(-1) for cilazapril) and to pharmaceutical dosage forms. The method was validated in terms of reproducibility, linearity and accuracy.

Deltamethrin degradation and soil microbial activity in a riparian wetland soil.

The effects of deltamethrin, in the presence and absence of nitrate, on soil microbial activity (as reflected by the rates of soil microbial basal respiration, denitrification, and methanogenesis) were studied in a riparian wetland soil under both aerobic and anaerobic conditions. A microcosm study was carried out with soil collected from the vicinity of a wetland. The soil was then amended with 50, 125, and 250 mg deltamethrin kg−1 dry weight soil, in the presence and absence of 20 mg N-NO3− kg−1 dry weight soil. Half-life values for deltamethrin degradation ranged from 27 to 291 days, depending on experimental conditions. Nitrates had an inhibitory effect on deltamethrin degradation. Deltamethrin, under anaerobiosis, had an inhibitory effect on soil respiration; this effect was reversed in the presence of nitrate. An antagonistic effect between deltamethrin degradation and denitrification activity was observed. In the presence of nitrate, the activation of denitrifying bacteria led to competitive inhibition of methanogens. It was concluded that deltamethrin, designed to affect specific functions of its target organisms, also has an effect on nontarget organisms, that is, the soil microbial community. To our knowledge, this is the first report on the degradation and environmental impact of deltamethrin in a riparian wetland soil.

Multivariate optimisation of a cyclodextrin-assisted-capillary zone electrophoretic method for the separation of torasemide and its metabolites

In this work, a rapid cyclodextrin-assisted capillary electrophoretic method is developed for the separation of the diuretic torasemide and three of its metabolites. Both fractional factorial and central composite designs were employed to optimise the separation method. The factors studied were pH, concentration of methyl-beta-cyclodextrin, concentration of the background electrolyte and percentage of acetonitrile as organic modifier. Monitored response was a composite quality response (Q*) which balanced conflicting normalized responses, such as resolution and migration time. Optimal separation of the four studied compounds was achieved in less than 6.5 min, using an electrolyte of 60 mM borate buffer with no organic modifier and 25 mM methyl-beta-cyclodextrin concentration adjusted to pH 8.0 at a potential of 30 kV. Detection wavelength and temperature were 197 nm and 20 degrees C respectively. This work means a significant improvement with regard to a previous separation method for these compounds developed in our laboratory.

Determination of the angiotensin-converting enzyme inhibitor quinapril and its metabolite quinaprilat in pharmaceuticals and urine by capillary zone electrophoresis and solid-phase extraction.

Quinapril is an antihypertensive drug commonly used in the treatment of hypertension and congestive heart failure. In this work, a capillary zone electrophoresis system is optimized for the analysis of quinapril and its active metabolite quinaprilat in urine, as well as for the determination of the drug and its combination with hydrochlorothiazide in pharmaceuticals. The separation takes place in a fused‐silica capillary. The running electrolyte consists of a 60 mM borate buffer solution, pH 9.5. The analysis of urine samples requires a previous extraction step using C8 solid‐phase cartridges. Under the optimum experimental conditions, the separation of the two analytes and the internal standard takes less than 5 min. The detection limits obtained (75 and 95 ng/mL for quinapril and quinaprilat, respectively) allow the application of the electrophoretic method to the determination of the drug and its metabolite in urine samples obtained from four patients treated with quinapril.