Rosane Palissari

Annealing experiments on induced fission tracks in apatite: Measurements of horizontal-confined track lengths and track densities in basal sections and randomly oriented grains

Abstract To improve kinetic models for apatite fission-track annealing, we present new experimental annealing data that complement previously published data. To determine the degree of annealing of induced tracks, surface density (ρ), and mean horizontal-confined track lengths (l), were measured, both for basal and randomly oriented faces. Our annealing data were obtained by submitting an apatite sample collected in Itambé, Bahia, Brazil, to 46 different isothermal treatments where temperature ranged from 150 to 600 °C (duration of 1, 10, 100, and 1000 h). To compare the behavior of Itambé to Durango apatite, the latter was also annealed for 1 h in 9 isothermal experiments at temperatures between 240 and 380 °C. Our results show that the l/l0 values in Durango are systematically smaller than those in Itambé sample, both in basal and random faces. The curves depicting relative track density reduction, ρ/ρ0, and relative mean confined track length reduction, l/l0, as a function of time and temperature, are similar for ρ/ρ0 > ~0.5, but different for ρ/ρ0 < ~0.5. In this interval, ρ/ρ0 can be measured but the measurement of l/l0 is very difficult because the confined tracks become undetectable. Measurements of ρ/ρ0 and l/l0 for tracks revealed in basal surfaces are systematically lower (but this difference is <3%) than those in randomly oriented ones.

Effects of etching on zircon grains and its implications for the fission track method.

Studies of zircon grains using optical microscopy, micro-Raman spectroscopy, and scanning electron microscopy (SEM) have been carried out to characterize the surface of natural zircon as a function of etching time. According to the surface characteristics observed using an optical microscope after etching, the zircon grains were classified as: (i) homogeneous; (ii) anomalous, and (iii) hybrid. Micro-Raman results showed that, as etching time increases, the crystal lattice is slightly altered for homogeneous grains, it is completely damaged for anomalous grains, and it is altered in some areas for hybrid grains. The SEM (energy dispersive X-ray spectroscopy, EDS) results indicated that, independent of the grain types, where the crystallinity remains after etching, the chemical composition of zircon is approximately 33% SiO2:65% ZrO2 (standard natural zircon), and for areas where the grain does not have a crystalline structure, there are variations of ZrO2 and, mainly, SiO2. In addition, it is possible to observe a uniform surface density of fission tracks in grain areas where the determined crystal lattice and chemical composition are those of zircon. Regarding hybrid grains, we discuss whether the areas slightly altered by the chemical etching can be analyzed by the fission track method (FTM) or not. Results of zircon fission track and U-Pb dating show that hybrid and homogeneous grains can be used for dating, and not only homogeneous grains. More than 50 sedimentary samples from the Bauru Basin (southeast Brazil) were analyzed and show that only a small amount of grains are homogeneous (10%), questioning the validity of the rest of the grains for thermo-chronological evolution studies using zircon FTM dating.