S. K. Mahesh

Influence of cation substitution and activator site exchange on the photoluminescence properties of Eu3+-doped quaternary pyrochlore oxides.

Stannate-based pyrochlore-type red phosphors CaGd(1-x)SnNbO7:xEu(3+), Ca(1-y)Sr(y)Gd(1-x)SnNbO7:xEu(3+), and Ca(0.8-x)Sr0.2GdSnNbO(7+δ): xEu(3+) were prepared via conventional solid-state method. Influence of cation substitution and activator site control on the photoluminescence properties of these phosphors are elucidated using powder X-ray diffraction, Rietveld analysis, Raman spectrum analysis, and photoluminescence excitation and emission spectra. The Eu(3+) luminescence in quaternary pyrochlore lattice exemplifies as a very good structural probe for the detection of short-range disorder in the lattice, which otherwise is not detected by normal powder X-ray diffraction technique. The Eu(3+) emission due to magnetic dipole transition ((5)D0-(7)F1 MD) is modified with the increase in europium concentration in the quaternary pyrochlore red phosphors. (5)D0-(7)F1 MD transition splitting is not observable for low Eu(3+) doping because of the short-range disorder in the pyrochlore lattice. Appearance of narrow peaks in Raman spectra confirms that short-range disorder in the crystal lattice disappears with progressive europium doping. By using Sr as a network modifier ion in place of Ca we were able to increase the f-f transition intensities and europium quenching concentration. The influence of effective positive charge of the central Eu(3+) ions when it replaces a metal ion having lower oxidation state such as Ca(2+) was also investigated. The relative intensities of A1g (∼500 cm(-1)) and F2g (∼330 cm(-1)) Raman vibrational modes get inverted when Eu(3+) ions replaces Ca(2+) ions instead of Gd(3+) as trivalent europium ions can attract the electron cloud of oxygen ions strongly in comparison with divalent calcium ions. The influence of positive charge effect of Eu(3+) in Ca0.7Sr0.2GdSnNbO7+δ:0.1Eu(3+) phosphor is greatly strengthened the charge transfer band and (7)F0-(5)L6 transition intensities than that of the Ca0.8Sr0.2Gd0.9SnNbO7:0.1Eu(3+) phosphor. Our results suggest that the photoluminescence properties can be enhanced by simple compositional adjustments in the quaternary pyrochlore-type red phosphors.

Role of bond strength on the lattice thermal expansion and oxide ion conductivity in quaternary pyrochlore solid solutions.

Quaternary pyrochlore-type solid solutions, CaGdZrNb(1-x)Ta(x)O(7) (x = 0, 0.2, 0.4, 0.6, 0.8, 1), were prepared by a high-temperature ceramic route. The pyrochlore phases of the compounds were confirmed by powder X-ray diffraction (XRD), Raman spectroscopy, and transmission electron microscopy. The crystallographic parameters of the pyrochlore compounds were accurately determined by Rietveld analysis of the powder XRD data. The isovalent substitution of Ta in place of Nb at the B site can reveal the effect of chemical bonding on lattice thermal expansion and oxide ion conductivity because both Nb and Ta have the same ionic radius (0.64 Å). Lattice thermal expansion coefficients of the samples were calculated from high-temperature XRD measurements, and it was found that the thermal expansion coefficient decreases with substitution of Ta. Oxide ion conductivity measured by a two-probe method also shows the same trend with substitution of Ta, and this can be attributed to the high bond strength of the Ta-O bond compared to that of the Nb-O bond. Microstructural characterization using scanning electron microscopy proves that the size of the grains has a small effect on the oxide ion conductivity. Our studies established the role of chemical bonding in deciding the conductivity of pyrochlore oxides and confirmed that the 48f-48f mechanism of oxide ion conduction is dominant in pyrochlore oxides.