Sa'ardin Abdul Aziz

Design of ultrasonic compaction tool for powder metallurgy

The current study is presented into the investigation of the application of ultrasonic vibration on the lower punch during compaction process of powder metallurgy material. The lower punch is specifically designed of ultrasonic horn which has been tuned at frequency of 20 kHz and vibrates in longitudinal mode. Finite Element modeling was used to assist the design process of the lower punch or horn. The horn was fabricated using high grade aluminium alloy and mounted onto the ultrasonic system test rig and subsequently tested prior the experimental process begins. Various static and ultrasonic compaction procedures have been carried out to confirm the capability of the tool to operate. The compaction force was reduced significantly at the onset of ultrasonic vibration applied compared to without ultrasonic.

Mechanical behavior of Kenaf/Epoxy corrugated sandwich structures

This study presents the response of kenaf/epoxy corrugated sandwich structure during quasi-static test. Force-displacements curves have been deducted to determine the deformation pattern and collapse behavior of the structure. Kenaf/epoxy sandwich structures skins fabricated by using hand layup technique and the corrugated core were moulded by using steel mould. Different thicknesses of corrugated core web with two sizes of kenaf fibers were used. The corrugated core is then bonded with the skins by using poly-epoxy resin and has been cut into different number of cells. The specimens then tested under tensile and compression at different constant speeds until the specimens fully crushed. Tensile tests data showed the structure can be considered brittle when it breaking point strain, e less than 0.025. In compression test, the specimens fail due to dominated by stress concentration that initiated by prior cracks. Also, the specimens with more number of cells and thicker core web have higher strength and the ability to absorb higher energy.

Energy management strategies at emergency department block C Hospital Sungai Buloh, Malaysia

Energy is an important element in human daily life. In Malaysia, about 80% of electrical energy produced from burning fuels that will cause of carbon dioxide emission to atmosphere. The effect could be reduced with less energy consumption. This project focuses on energy management strategies for energy saving that can be done on the HVAC system, air-cond, lighting and office equipment in Emergency Department, Block C Hospital Sungai Buloh. The annual profit, total cost and payment period for each research method are also studied. To implement for all major system must be link to chapter by Buiding Automation System. Major studies for this topic is to implement energy saving, calculate energy comsumption, power, area specific room, return of investment, analysis for daily cost for used, total for kWh for monthly usage.