Sandra Pérez

Recent trends in the liquid chromatography-mass spectrometry analysis of organic contaminants in environmental samples.

An overview of liquid chromatography-mass spectrometry methods used for the determination of trace organic contaminants in environmental samples is presented. Among the organic contaminants the focus is given on five groups of emerging contaminants that raised most concern as environmental contaminants and therefore attracted attention of a research community: pharmaceuticals, drugs of abuse, polar pesticides, perfluorinated compounds and nanoparticles. Various aspects of current LC-MS methodology, using tandem and hybrid MS instruments, including sample preparation, are discussed.

Fully automated determination of 74 pharmaceuticals in environmental and waste waters by online solid phase extraction-liquid chromatography-electrospray-tandem mass spectrometry

The present work describes the development of a fully automated method, based on on-line solid-phase extraction (SPE)-liquid chromatography-electrospray-tandem mass spectrometry (LC-MS-MS), for the determination of 74 pharmaceuticals in environmental waters (superficial water and groundwater) as well as sewage waters. On-line SPE is performed by passing 2.5 mL of the water sample through a HySphere Resin GP cartridge. For unequivocal identification and confirmation two selected reaction monitoring (SRM) transitions are monitored per compound, thus four identification points are achieved. Quantification is performed by the internal standard approach, indispensable to correct the losses during the solid phase extraction, as well as the matrix effects. The main advantages of the method developed are high sensitivity (limits of detection in the low ng L(-1) range), selectivity due the use of tandem mass spectrometry and reliability due the use of 51 surrogates and minimum sample manipulation. As a part of the validation procedure, the method developed has been applied to the analysis of various environmental and sewage samples from a Spanish river and a sewage treatment plant.

Quantitative analysis of polycyclic aromatic hydrocarbons in sewage sludge from wastewater treatment plants

Polycyclic aromatic hydrocarbons (PAHs) are an important group of organic contaminants present in sewage sludge. Due to their persistence and toxic potential, information about their presence in sewage sludge is needed in order to assess applicability on agricultural land. A method for the gas chromatographic-mass spectrometric (GC-MS) determination was developed and applied to the trace determination of PAHs present in sewage sludge samples from six wastewater treatment plants (WWTPs) differing in the type of treatment and the origin of wastewater. PAHs were extracted from freeze-dried samples by a dichloromethane-methanol (2:1) mixture in a sonication bath. The sludge extracts were cleaned-up by an alumina column. The method showed recovery values varying from 60 to 98%. Four surrogate standards ([2H8]naphthalene, [2H10]anthracene, [2H12]benzo[a]anthracene, and [2H12]benzo[ghi]perylene) were used for quantitation by GC-MS. A reference sludge sample was analysed in order to validate the method. The sum of the 16 US Environmental Protection Agency PAHs analysed in the sewage sludge samples varied from 1.13 to 5.52 mg/kg. No significant difference between the different WWTPs was found.

Toward a fast, easy, and versatile immobilization of biomolecules into carbon nanotube/polysulfone-based biosensors for the detection of hCG hormone.

The aim of this study was the fabrication and characterization of biomembranes by the phase inversion (PI) method followed by their subsequent casting onto screen-printed electrodes (SPE) for biomedical applications. The combination of multiwalled carbon nanotubes (MWCNT) as a transducer with polysulfone (PSf) polymer enables easy incorporation of biological moieties (hormones or antibodies), providing a 3D composite with high electrochemical response to corresponding analytes. Antibody/MWCNT/PSf biosensors were characterized by confocal scanning laser microscopy (CSLM), scanning electron microscopy (SEM), and electrochemical methods. For biomedical purposes, human chorionic gonadotropin (hCG) hormone was tested by competitive immunoassay. The detection limit was determined to be 14.6 mIU/mL with a linear range up to 600 mIU/mL. We concluded that the easy and fast incorporation of biomolecules by the PI method, as well as their stability and distribution throughout the 3D polysulfone composite, are testament to the utility for the versatile fabrication of biosensors for clinical diagnosis.

Achievements and future trends in the analysis of emerging organic contaminants in environmental samples by mass spectrometry and bioanalytical techniques.

Several groups of organic compounds have emerged as particularly relevant as environmental pollutants. These compounds, including new brominated flame retardants, disinfection by-products, drugs of abuse and their metabolites, hormones and other endocrine disrupting compounds, nanomaterials, perfluoroalkyl substances, pharmaceuticals and siloxanes among others, constitute new risks for environmental and human health. In order to face up to these new risk challenges there is an increasing need to assess their occurrence and behaviour in the environment, as well as, that of their degradation products. Therefore, during recent years an important part of research has been focused on to the improvement of analytical schemes for complex matrices, in which the new tendencies in sample preparation (e.g. online clean up systems), the development of new materials and new mass spectrometry analysers have played an important role. This paper presents a general overview of new analytical trends and potentials in trace analysis of emerging pollutants in the environment, including chromatographic techniques coupled to mass spectrometry, and bio analytical approaches (biosensors).

Wastewater reuse in Mediterranean semi-arid areas: The impact of discharges of tertiary treated sewage on the load of polar micro pollutants in the Llobregat river (NE Spain).

The presence of sewage-borne micro contaminants in environmental waters is directly related to the discharge of treated effluents from wastewater treatment plants (WWTP) and the flow rate of the receiving river waters. Mediterranean rivers, in particular, are characterized by important fluctuations in the flow rates and heavy pollution pressures resulting from extensive urban, industrial and agricultural activities. This translates into contamination levels in these rivers often higher than those in other larger European basins. The present work provides an overview of the occurrence of five groups of organic contaminants (131 compounds) namely pharmaceuticals, illicit drugs, polar pesticides, estrogens, alkylphenols and related ethoxylates in WWTP tertiary treatment effluents. Data gathered during a period of water reuse carried out in the lower stretch of the Llobregat river (NE Spain), in the surroundings of the town of Barcelona as a consequence of the severe drought that took place along the years 2007-2008 are presented as illustrative example. In general, measured concentrations of the target compounds were in the low to mid ngL(-1) range. The total concentration of each compound class downstream to the discharge point was similar or slightly higher than that found upstream. Regarding the loads calculated for each compound, the relative contribution from the river upstream and the tertiary effluent were highly compound depending with no apparent trend. However, estimation of the overall bulk loads for each compound class determined in the Llobregat river showed the following rank order: pharmaceuticals>alkylphenols>pesticides>illicit drugs≫estrogens.

Evidence for the microbially mediated abiotic formation of reversible and non-reversible sulfamethoxazole transformation products during denitrification.

The antibiotic sulfonamide drug sulfamethoxazole (SMX) is extensively used in both human and veterinary medicine. Since it cannot be completely eliminated by the typical state-of-the-art wastewater treatment technology, it is frequently detected in the water cycle. SMX, as aromatic amine, can undergo abiotic transformations with the under denitrifying conditions produced nitrogen species nitric oxide (NO) and nitrite (NO(2)(-)). NO and aromatic amines are commonly known to form diazonium cations. Depending on the reaction conditions the diazonium cation disintegrates under cleavage of elementary nitrogen and substitutes its diazo-group by an NO(2)-group or by hydrogen. Following this approach, two transformation products (TPs) of the persistent SMX under denitrifying conditions were hypothesized and synthesized: 4-nitro-N-(5-methylisoxazol-3-yl)-benzenesulfonamide (4-nitro-SMX) and N-(5-methylisoxazol-3-yl)-benzenesulfonamide (desamino-SMX). The synthesized compounds were identified by Nuclear Magnetic Resonance (NMR) spectroscopy and used as reference standards for their confirmation and quantification in denitrifying water/sediment batch experiments and in environmental samples. During the denitrifying degradation experiment SMX was no longer detected after 10 days whereas increasing concentrations of the two TPs were observed. However, at day 87 the SMX concentration recovered to 53 ± 16% of the initial concentration after most of the nitrate was consumed. A retransformation of 4-nitro-SMX to SMX was postulated and confirmed by another anoxic water/sediment test in the absence of nitrate as electron acceptor. Both TPs were also detected in karst spring samples, highlighting the need and benefit of focusing on transformation products in environmental studies. Furthermore, the consideration of the retransformation potential of 4-nitro-SMX can substantially improve the understanding of SMX behavior during processes such as bank filtration and artificial recharge.

Occurrence of polycyclic aromatic hydrocarbons in sewage sludge and their contribution to its toxicity in the ToxAlert® 100 bioassay

The contribution of polycyclic aromatic hydrocarbons (PAH) present in sewage sludge samples to toxicity was investigated. Chemical analysis using gas chromatography mass spectrometry (GC-MS) and the ToxAlert 100 bioassay, based on the inhibition to Vibrio fischeri, were applied to sludge extracts after purification by column chromatography. The levels of the 16 US EPA PAH analyzed in the sewage sludge samples varied from 17 to 2,030 microg kg(-1). In all samples examined phenanthrene was the most prominent compound. The toxicity data obtained by ToxAlert 100 can be explained by the levels and composition of the different PAH in sewage sludge samples. The present approach can contribute to evaluate the toxicity of sewage sludge.

Identification and structural characterization of biodegradation products of atenolol and glibenclamide by liquid chromatography coupled to hybrid quadrupole time-of-flight and quadrupole ion trap mass spectrometry

In this paper we report about the biodegradation of the beta-blocker atenolol and the hypoglycaemic agent glibenclamide. The biodegradation tests were performed in batch reactors under aerobic conditions, using as inocculums sewage sludge from a conventional activated sludge treatment and a laboratory-scale membrane bioreactor. Pharmaceuticals were used as sole carbon sources, spiked at 50ng/L and 10mg/L concentrations. Quadrupole time-of-flight mass spectrometry coupled to ultra-high-pressure liquid chromatograph was used for the screening and the structural elucidation of biodegradation products. A microbial metabolite of atenolol with [M+H](+) at 268 was detected in the positive electrospray ionization mode. This new compound was determined to be a product of microbial hydrolysis of the amide of the parent compound. Biodegradation of glibenclamide by activated sludge proceeded via bacterial hydroxylation of the cyclohexyl ring, which resulted in formation of metabolite with a protonated molecule, [M+H](+)=510. MS(3) experiments performed by hybrid quadrupole linear ion trap (QqLIT) mass spectrometry coupled to high-performance liquid chromatography enabled further structural elucidation of the identified metabolites. Moreover, the highly sensitive QqLIT instrument in the MRM mode enabled the detection of parent compounds and one of the microbial metabolites identified in real wastewater samples. The methodology used in this study permitted for the first time the identification and detection of biodegradation product of beta-blocker atenolol in real wastewater samples.

Photodegradation of azithromycin in various aqueous systems under simulated and natural solar radiation: Kinetics and identification of photoproducts

This article describes the photolysis of azithromycin, a macrolide antibiotic with reported occurrence in environmental waters, under simulated solar radiation. The photodegradation followed first-order reaction kinetics in five matrices examined. In HPLC water, the degradation rate was the slowest (half-life: 20h), whereas in artificial freshwater supplemented with nitrate (5mgL(-1)) or humic acids (0.5mgL(-1)) the degradation of azithromycin was enhanced by factors of 5 and 16, respectively, which indicated the role of indirect photolysis involving the formation of highly reactive species. Following chromatographic separation on a UPLC system, the characterization of the transformation products was accomplished using high-resolution QqToF-MS analysis. The presence of seven photoproducts was observed and their formation was postulated to originate from (bis)-N-demethylation in the desosamine sugar, O-demethylation in the cladinose sugar, combinations thereof, as well as from hydrolytic cleavages of the desosamine and/or cladinose residue. Two of these photoproducts could also be detected in natural photodegradation process in river water which was spiked with azithromycin.