Sehanat Prasongsuk

Polycyclic aromatic hydrocarbons (PAHs) degradation by laccase from a tropical white rot fungus Ganoderma lucidum

Laccase enzyme was produced from an isolate of the white rot fungus, Ganoderma lucidum Chaaim-001 BCU. The enzyme was subsequently evaluated for its degradative ability towards sixteen types of polycyclic aromatic hydrocarbons (PAHs). The G. lucidum laccase degraded antracene completely with or without a redox mediator (2 mM 1-hydroxybenzotriazole) and also degraded benzo[a]pyrene, fluorine, acenapthene, acenaphthylene and benzo[a]anthracene up to 100.0, 98.6, 95.4, 90.1 and 85.3 %, respectively, when the mediator was present. In the absence of the mediator, the ability to degrade these compounds dropped to 71.71, 62.9, 80.49, 85.85 and 9.14% respectively. Compared to the laccase enzyme from Trametes vesicolor, G. lucidum laccase appeared to retain more of its capability to degrade these PAHs when the mediator was absent.

Purification, Characterization, and Potential of Saline Waste Water Remediation of a Polyextremophilic α-Amylase from an Obligate Halophilic Aspergillus gracilis

An obligate halophilic Aspergillus gracilis which was isolated from a hypersaline man-made saltern from Thailand was screened for its potential of producing extracellular α-amylase in the previous studies. In this study the α-amylase was extracted and purified by the help of column chromatography using Sephadex G-100 column. Presence of amylase was verified by SDS-PAGE analysis, showing a single band of approximately 35 kDa. The specific activity of the enzyme was found to be 131.02 U/mg. The Lineweaver-Burk plot showed the V max and K m values of 8.36 U/mg and 6.33 mg/mL, respectively. The enzyme was found to have the best activity at 5 pH, 60°C, and 30% of NaCl concentration, showing its polyextremophilic nature. The use of various additives did not show much variation in the activity of enzyme, showing its resilience against inhibitors. The enzyme, when tested for its use for synthetic waste water remediation by comparing its activity with commercial amylase in different salt concentrations showed that the α-amylase from A. gracilis was having better performance at increasing salt concentrations than the commercial one. This shows its potential to be applied in saline waste water and other low water activity effluents for bioremediation.

Purification and Characterization of a Polyextremophilic α-Amylase from an Obligate Halophilic Aspergillus penicillioides Isolate and Its Potential for Souse with Detergents

An extracellular α-amylase from the obligate halophilic Aspergillus penicillioides TISTR3639 strain was produced and enriched to apparent homogeneity by ammonium sulfate precipitation and Sephadex G100 gel filtration column chromatography. The mass of the purified amylase was estimated to be 42 kDa by SDS-PAGE. With soluble starch as the substrate it had a specific activity of 118.42 U·mg−1 and V max⁡ and K m values of 1.05 µmol·min−1·mg−1 and 5.41 mg·mL−1, respectively. The enzyme was found to have certain polyextremophilic characteristics, with an optimum activity at pH 9, 80°C, and 300 g·L−1 NaCl. The addition of CaCl2 at 2 mM was found to slightly enhance the amylase activity, while ZnCl2, FeCl2, or EDTA at 2 mM was strongly or moderately inhibitory, respectively, suggesting the requirement for a (non-Fe2+ or Zn2+) divalent cation. The enzyme retained more than 80% of its activity when incubated with three different laundry detergents and had a better performance compared to a commercial amylase and three detergents in the presence of increasing NaCl concentrations up to 300 g·L−1. Accordingly, it has a good potential for use as an α-amylase in a low water activity (high salt concentration) and at high pH and temperatures.

Enhanced water-solubility and mucoadhesion of N,N,N-trimethyl-N-gluconate-N-homocysteine thiolactone chitosan.

A water-soluble chitosan with improved mucoadhesion was prepared by modifying 19.4% of the amine groups of chitosan to trimethylammonium and conjugation of gluconolactone (GLU) and homocysteine thiolactone (HT) onto the remaining amine groups of the chitosan backbone. The derived trimethyl-gluconate-HT-chitosan (TM-GN-HT-chitosan) was confirmed by Fourier Transform Infrared spectroscopy, NMR and thermogravimetric analysis. The total thiol and disulfide group level on the TM-GN-HT-chitosan were 17.96 ± 0.03 and 7.36 ± 0.03 μmol/g, respectively. The water solubility of the TM-GN-HT-chitosan conjugate was 79.0 ± 0.15%, more than that of TM-chitosan and chitosan, with an enhanced solubility over a broad pH range ranging from 85.6 ± 10.4% to 58.5±1.1% maximal solubility at pH 2 to 11. Finally, TM-GN-HT-chitosan showed a nearly ∼9.5-, 5.0- and 5.6-fold higher mucoadhesiveness than chitosan at pH 1.2, 4.0 and 6.4, respectively, and was optimal at pH 4.0.

Evaluation of the overall process on bioethanol production from miscanthus hydrolysates obtained by dilute acid pretreatment

In this study, dilute sulfuric acid pretreatment was performed to improve the sugars recovery from Korean Miscanthus straw. The effect of pretreatment conditions on solubilized xylose was fundamentally investigated for the efficient removal of xylan. The optimal conditions were determined using a statistical method, and were shown to be a temperature of 121.6°C, an acid concentration of 1.1%, and a reaction time of 12.8 min. The combined severity factor was shown to be 1.1 under the optimum conditions. Following the pretreatment, the solubilized xylose in liquid fraction was found to be 71.2%, and about 72.6% of the solid was recovered. After enzymatic hydrolysis, about 86.4% glucose conversion was achieved when the pretreated biomass was used as a substrate, with the conversion being improved 4-fold compared with the control (untreated). The hydrolysates, approximately 10 g/L glucose, were applied to the fermentation of Saccharomyces cerevisiae K35, and the ethanol yield was about 96%. The overall process was evaluated based on the material balance, and the results show that approximately 172 g bioethanol can be produced when 1,000 g Miscanthus straw is loaded into the process.

Rapid Detection of Aflatoxigenic Aspergillus sp. in Herbal Specimens by a Simple, Bendable, Paper‐based Lab‐on‐a‐chip

Postharvest herbal product contamination with mycotoxins and mycotoxin‐producing fungi represents a potentially carcinogenic hazard. Aspergillus flavus is a major cause of this issue. Available mold detection methods are PCR‐based and rely heavily on laboratories; thus, they are unsuitable for on‐site monitoring. In this study, a bendable, paper‐based lab‐on‐a‐chip platform was developed to rapidly detect toxigenic Aspergillus spp. DNA. The 3.0‐4.0 cm2 chip is fabricated using Whatman™ filter paper, fishing line and a simple plastic lamination process and has nucleic acid amplification and signal detection components. The Aspergillus assay specifically amplifies the aflatoxin biosynthesis gene, aflR, using loop‐mediated isothermal amplification (LAMP); hybridization between target DNA and probes on blue silvernanoplates (AgNPls) yields colorimetric results. Positive results are indicated by the detection pad appearing blue due to dispersed blue AgNPls; negative results are indicated by the detection pad appearing colorless or pale yellow due to probe/target DNA hybridization and AgNPls aggregation. Assay completion requires less than 40 min, has a limit of detection (LOD) of 100 aflR copies, and has high specificity (94.47%)and sensitivity (100%). Contamination was identified in 14 of 32 herbal samples tested (43.75%). This work demonstrates the fabrication of a simple, low‐cost, paper‐based lab‐on‐a‐chip platform suitable for rapid‐detection applications.

The current status of Aureobasidium pullulans in biotechnology

Different strains of the saprophytic yeast-like fungus Aureobasidium pullulans (Ascomycota: Dothideales) exhibit different biochemical characteristics, while their ubiquitous occurrence across diverse habitats and environmental conditions makes them an easily accessible source for biotechnological exploitation. They are useful in agricultural and industrial applications. Their antagonistic activities against postharvest pathogens make them suitable bioagents for the postharvest preservation of fruits and vegetables, while they possess antimicrobial activities against bacteria and fungi. Additionally, A. pullulans appears to be a potent source of single-cell protein. Many strains of A. pullulans harbor a wide range of industrially important enzymes, while the trademark exopolysaccharide pullulan that they produce has been extensively studied and is currently used in many applications. They also produce poly (β-l-malic acid), heavy oil liamocins, siderophore, and aubasidan-like β-glucan which are of interest for future applications. Ongoing studies suggest that A. pullulans holds many more interesting properties capable of further potential biotechnological applications.

Comparative Study of Physical Factors and Microbial Diversity of Four Man-Made Extreme Ecosystems

Ten soil samples were collected from four man-made extreme ecosystems, located adjacent to each other, at Ban Laem district, Phetchaburi province, Thailand. The area is used for sea salt extraction produced in artificial solar salterns. Soil analysis was performed which revealed the extreme conditions in terms of salinity, moisture content, organic matter and nitrogen content. Selective medium was provided for the isolation of microorganisms. Bacteria were found to be the most dominating group of microorganisms followed by fungi, actinomycetes and algae. Morphological and biochemical identification were performed to determine the genus of each microorganism. An actinomycete genus: Streptomyces, an algal genus: Dunaliella, three bacterial genera: Halobacillus, Halobacterium and Halomonas, and a fungal genus: Aspergillus, were the most frequently found microbes in these extreme man-made ecosystems. Interesting inter and intra relationships were observed between physical factors and microbial diversity. Except pH and salinity all physical factors were found to have positive correlation effect on microbial numbers. Actinomycetes was found to favor the fungal populations in man-made extreme ecosystems.