Seung Jun Choi

Protein-Stabilized Nanoemulsions and Emulsions: Comparison of Physicochemical Stability, Lipid Oxidation, and Lipase Digestibility

The properties of whey protein isolate (WPI) stabilized oil-in-water (O/W) nanoemulsions (d(43) ≈ 66 nm; 0.5% oil, 0.9% WPI) and emulsions (d(43) ≈ 325 nm; 0.5% oil, 0.045% WPI) were compared. Emulsions were prepared by high-pressure homogenization, while nanoemulsions were prepared by high-pressure homogenization and solvent (ethyl acetate) evaporation. The effects of pH, ionic strength (0-500 mM NaCl), thermal treatment (30-90 °C), and freezing/thawing on the stability and properties of the nanoemulsions and emulsions were compared. In general, nanoemulsions had better stability to droplet aggregation and creaming than emulsions. The nanoemulsions were unstable to droplet flocculation near the isoelectric point of WPI but remained stable at higher or lower pH values. In addition, the nanoemulsions were stable to salt addition, thermal treatment, and freezing/thawing (pH 7). Lipid oxidation was faster in nanoemulsions than emulsions, which was attributed to the increased surface area. Lipase digestibility of lipids was slower in nanoemulsions than emulsions, which was attributed to changes in interfacial structure and protein content. These results have important consequences for the design and utilization of food-grade nanoemulsions.

Stability of Citral in Oil-in-Water Emulsions Prepared with Medium-Chain Triacylglycerols and Triacetin

Citral is widely used in the beverage, food, and fragrance industries for its characteristic flavor profile. However, it chemically degrades over time in aqueous solutions due to an acid-catalyzed reaction, which leads to loss of desirable flavor notes and formation of off-flavor notes. The objective of this research was to examine the impact of organic phase composition [triacetin and medium-chain triacylglycerols (MCT)] on the oil-water partitioning and chemical degradation of citral in oil-in-water emulsions. MCT was present as emulsion droplets (d approximately 900 nm), whereas triacetin was present as microemulsion droplets (d approximately 10 nm). In the absence of organic phase, the rate of citral degradation increased as the aqueous phase pH was reduced from 7 to 3. The percentage of citral within the aqueous phase increased with increasing triacetin concentration at both pH 3 and 7, which was attributed to a reduction in MCT droplet concentration. There was no significant change in the particle size distribution of the emulsions during storage, independent of triacetin concentration and pH, which indicated that they were physically stable. Both 5 wt % MCT as emulsion droplets and 5 wt % triacetin as microemulsion droplets were able to appreciably slow citral degradation at pH 3. These results may have important implications for understanding and improving the chemical stability of citral in beverage emulsions.

Inhibition of Ostwald Ripening in Model Beverage Emulsions by Addition of Poorly Water Soluble Triglyceride Oils

Beverage emulsions containing flavor oils that have a relatively high water-solubility are unstable to droplet growth due to Ostwald ripening. The aim of this study was to improve the stability of model beverage emulsions to this kind of droplet growth by incorporating poorly water-soluble triglyceride oils. High pressure homogenization was used to prepare a series of 5 wt% oil-in-water emulsions stabilized by modified starch that had different lipid phase compositions (orange oil : corn oil). Emulsions prepared using only orange oil as the lipid phase were highly unstable to droplet growth during storage, which was attributed to Ostwald ripening resulting from the relatively high water-solubility of orange oil. Droplet growth could be effectively inhibited by incorporating ≥ 10% corn oil into the lipid phase prior to homogenization. In addition, creaming was also retarded because the lipid phase density was closer to that of the aqueous phase density. These results illustrate a simple method of improving the physical stability of orange oil emulsions for utilization in the food, beverage, and fragrance industries.

Influence of Droplet Charge on the Chemical Stability of Citral in Oil-in-Water Emulsions

The chemical stability of citral, a flavor component widely used in beverage, food, and fragrance products, in oil-in-water emulsions stabilized by surfactants with different charge characteristics was investigated. Emulsions were prepared using cationic (lauryl alginate, LAE), non-ionic (polyoxyethylene (23) lauryl ether, Brij 35), and anionic (sodium dodecyl sulfate, SDS) surfactants at pH 3.5. The citral concentration decreased over time in all the emulsions, but the rate of decrease depended on surfactant type. After 7 d storage, the citral concentrations remaining in the emulsions were around 60% for LAE- or Brij 35-stabilized emulsions and 10% for SDS-stabilized emulsions. An increase in the local proton (H(+)) concentration around negatively charged droplet surfaces may account for the more rapid citral degradation observed in SDS-stabilized emulsions. A strong metal ion chelator (EDTA), which has previously been shown to be effective at increasing the oxidative stability of labile components, had no effect on citral stability in LAE- or Brij 35-stabilized emulsions, but it slightly decreased the initial rate of citral degradation in SDS-stabilized emulsions. These results suggest the surfactant type used to prepare emulsions should be controlled to improve the chemical stability of citral in emulsion systems.

Branch chain elongation by amylosucrase: production of waxy corn starch with a slow digestion property.

Starches with high slowly digestible starch (SDS) contents were prepared by treating completely gelatinized waxy corn starch with amylosucrase. The structural properties of the prepared starches were then investigated. The content of SDS increased by up to 38.7% after amylosucrase modification, and the portion of chains with degree of polymerisation (DP) 25-36 increased, while the portion of chains with DP⩽12 decreased. Amylosucrase-modified starches showed a weak B-type crystalline structure. A slight increase in the degree of relative crystallinity was observed with increased reaction time. The thermal properties, including melting temperature and enthalpy, of the amylosucrase-modified starches were higher than for the control starch. Although the amylosucrase-modified starches showed varying structural properties according to reaction time (1-45 h), their digestibilities did not change much after 6 h. By controlling the reaction time of the amylosucrase treatment, a tailored starchy food containing the desired amount of SDS can be produced.

Preparation of slowly digestible sweet potato Daeyumi starch by dual enzyme modification

Sweet potato Daeyumi starch was dually modified using glycogen branching enzyme (BE) from Streptococcus mutans and amylosucrase (AS) from Neisseria polysaccharea to prepare slowly digestible starch (SDS). Dually modified starches had higher SDS and resistant starch (RS) contents than control starch. The branched chain length distributions of the BE-modified starches indicated an increase in short side-chains [degree of polymerization (DP)≤12] compared with native starch. AS treatment of the BE-modified starches decreased the proportion of short side-chains and increased the proportion of long side-chains (DP≥25) and molecular mass. It also resulted in a B-type X-ray diffraction pattern and an increased relative crystallinity. Regarding thermal properties, the BE-modified starches showed no endothermic peak, whereas the BEAS-modified starches had a broader melting temperature range and lower melting enthalpy compared to native starch. The combined enzymatic treatment resulted in novel glucan polymers with slow digestion properties.

Digestibility and physicochemical properties of granular sweet potato starch as affected by annealing

The effects of annealing on the digestibility, morphology, and physicochemical characteristics of four types of granular sweet potato starches [Yulmi (YM), Yeonwhangmi (YHM), sweet potato starch from Samyang Genex (SSPS), and commercial sweet potato starch (CSPS)] were investigated. Annealing was performed at 55°C and 90% moisture content for 72 h. Morphology, the branched chain distribution of amylopectin, and the X-ray diffraction pattern remained unchanged during the annealing process. The slowly digestible starch content in annealed YM, YHM, and SSPS starches increased, but did not change in annealed CSPS. The gelatinization temperatures increased, but the gelatinization temperature range decreased with annealing. The swelling factor and amylose leaching decreased, while the close packing concentration increased. Rapid Visco Analyser analysis revealed that annealed starches possessed thermal stability and higher pasting temperatures. It is suggested that the enhanced packing arrangement formed during annealing impacts the digestibility and physicochemical properties of sweet potato starches.

Erythorbyl laurate as a potential food additive with multi-functionalities: Interfacial characteristics and antioxidant activity.

The interfacial characteristics and antioxidant activities of erythorbyl laurate were investigated to provide information on practical applications as a multi-functional food additive. The critical micelle concentration (CMC) of erythorbyl laurate was 0.101mM and its foam stability was three times (half-life 24.33±0.94h) higher than that of Tween 20 (8.00±1.63h). In free radical scavenging assay, the negligible decrease in EC50 of erythorbyl laurate compared to erythorbic acid manifested that C-5 selective esterification of erythorbic acid with an acyl group (lauric acid) did not reduce the inherent antioxidant activity of the donor (erythorbic acid). Erythorbyl laurate formed lipid peroxides slower (i.e. retarded oxidation) in an emulsion system than did erythorbic acid. The localization of erythorbyl laurate as an emulsifier allowed the antioxidant molecules to be concentrated at the oil-water interface where oxidation is prevalent, which led to more effective retardation of lipid oxidation.

Improving Flavonoid Bioaccessibility using an Edible Oil-Based Lipid Nanoparticle for Oral Delivery

To enhance the oral bioaccessibility of flavonoids, including quercetin, naringenin, and hesperetin, we prepared an edible oil-based lipid nanoparticle (LNP) system. Flavonoid-loaded LNPs were similar to the blank LNP in physicochemical characteristics (z average <154.8 nm, polydispersity index <0.17, and ζ potential < -40.8 mV), and their entrapment efficiency was >81% at 0.3 wt % flavonoid concentration of the lipid phase. In the simulated digestion assay (mouth, stomach, and small intestine), LNPs were hydrolyzed under small intestine conditions and protected successfully incorporated flavonoids (≥94%). Moreover, the relative bioaccessibility of flavonoids was >71%, which was otherwise <15%, although flavonoids were released rapidly from LNPs into the medium. In conclusion, since the flavonoids incorporated in LNPs were preserved well during oral digestion and had improved bioaccessibility, the designed LNP system may serve as an encapsulation strategy to enhance the bioavailability of nonbioaccessible nutraceuticals in foods.

Citral degradation in micellar structures formed with polyoxyethylene-type surfactants

In a micellar solution, the chemical degradation of poorly water-soluble food flavours can be influenced by the properties of the surfactants forming the micelles in aqueous solutions. To evaluate how hydrophilic head size and hydrophobic tail length influence the chemical degradation rate of food flavour, micelles were prepared with Brij surfactants (Brij 35, 58, 78 and 700), each of which had very similar molecular structures (polyoxyethylene fatty acid ether). The chemical degradation of citral in Brij micelles was found to be highest in an acidic environment. There was no significant difference in the chemical degradation rate of citral in Brij micelles in non-acidic conditions, regardless of the hydrophilic head size or hydrophobic tail length. Brij surfactants with larger hydrophilic heads effectively retarded the chemical degradation of citral in an acidic environment. Our findings suggest that the length of the hydrophobic tail rarely influenced the micelles ability to chemically stabilize citral.