Seyda Bucak

Protein Separations Using Colloidal Magnetic Nanoparticles

Phospholipid‐coated colloidal magnetic nanoparticles with mean magnetite core size of 8 nm are shown to be effective ion exchange media for the recovery and separation of proteins from protein mixtures. These particles have high adsorptive capacities (up to 1200 mg protein/mL adsorbent, an order of magnitude larger than the best commercially available adsorbents) and exhibit none of the diffusional resistances offered by conventional porous ion exchange media. Protein‐laden particles are readily recovered from the feed solution using high‐gradient magnetic filtration.

Effect of Surface Modification on Magnetization of Iron Oxide Nanoparticle Colloids

Magnetic iron oxide nanoparticles have numerous applications in the biomedical field, some more mature, such as contrast agents in magnetic resonance imaging (MRI), and some emerging, such as heating agents in hyperthermia for cancer therapy. In all of these applications, the magnetic particles are coated with surfactants and polymers to enhance biocompatibility, prevent agglomeration, and add functionality. However, the coatings may interact with the surface atoms of the magnetic core and form a magnetically disordered layer, reducing the total amount of the magnetic phase, which is the key parameter in many applications. In the current study, amine and carboxyl functionalized and bare iron oxide nanoparticles, all suspended in water, were purchased and characterized. The presence of the coatings in commercial samples was verified with X-ray photoelectron spectroscopy (XPS). The class of iron oxide (magnetite) was verified via Raman spectroscopy and X-ray diffraction. In addition to these, in-house prepared iron oxide nanoparticles coated with oleic acid and suspended in heptane and hexane were also investigated. The saturation magnetization obtained from vibrating sample magnetometry (VSM) measurements was used to determine the effective concentration of magnetic phase in all samples. The Tiron chelation test was then utilized to check the real concentration of the iron oxide in the suspension. The difference between the concentration results from VSM and the Tiron test confirmed the reduction of magnetic phase of magnetic core in the presence of coatings and different suspension media. For the biocompatible coatings, the largest reduction was experienced by amine particles, where the ratio of the effective weight of magnetic phase reported to the real weight was 0.5. Carboxyl-coated samples experienced smaller reduction with a ratio of 0.64. Uncoated sample also exhibits a reduction with a ratio of 0.6. Oleic acid covered samples show a solvent-depended reduction with a ratio of 0.5 in heptane and 0.4 in hexane. The corresponding effective thickness of the nonmagnetic layer between magnetic core and surface coating was calculated by fitting experimentally measured magnetization to the modified Langevin equation.

Peptide Nanotube Nematic Phase.

The self-assembly of the trifluoroacetate salt of the short peptide (ala)6-lys (A6K) in water has been investigated by cryo-transmission electron microscopy and small-angle X-ray scattering. For concentrations below ca. 12%, the peptide does not self-assemble but forms a molecularly dispersed solution. Above this critical concentration, however, A6K self-assembles into several-micrometer-long hollow nanotubes with a monodisperse cross-sectional radius of 26 nm. Because the peptides carry a positive charge, the nanotubes are charge-stabilized. Because of the very large aspect ratio, the tubes form an ordered phase that presumably is nematic.

Liposomes as Potential Drug Carrier Systems for Drug Delivery

Lipids are amphiphilic molecules, where one part of the molecule is water-loving (hydrophilic) and the other water-hating (hydrophobic). When lipids are placed in contact with water, the unfavorable interactions of the hydrophobic segments of the molecule with the solvent result in the self assembly of lipids, often in the form of liposomes. Liposomes consist of an aqueous core surrounded by a lipid bilayer, much like a membrane, separating the inner aqueous core from the bulk outside. They were first discovered by Bangham and his co-workers in 1961 [1] and described as swollen phospholipid systems [2]. In the following years, a variety of enclosed phospholipid bilayer structures were defined which were initially called bangosomes and then liposomes, which was derived by the combination of two Greek words, “lipos” meaning fat and “soma” meaning body.

Enhancement of thermal conductivity upon application of magnetic field to Fe3O4 nanofluids

Enhancement of thermal conductivity of fluids upon addition of nanoparticles has been previously observed. In this study, Fe3O4 magnetite particles were used and thermal conductivity enhancements both in water and in heptane with increasing volume fraction have been shown. Upon measuring thermal conductivity under externally applied magnetic field, it has been shown experimentally that thermal conductivity can be further increased even at low concentrations and low magnetic field strengths in both fluids. Theoretical calculations are presented to support the effect of magnetic field on the thermal conductivity enhancement. This enhancement is attributed to the thermomagnetic convection which due to a temperature gradient, results in a non-uniform magnetic body force resulting in more efficient thermal conductance.

Structure of single-wall peptide nanotubes: in situ flow aligning X-ray diffraction

The structure of single wall peptide nanotubes is presented for the model surfactant-like peptide A(6)K. Capillary flow alignment of a sample in the nematic phase at high concentration in water leads to oriented X-ray diffraction patterns. Analysis of these, accompanied by molecular dynamics simulations, suggests the favourable self-assembly of antiparallel peptide dimers into beta-sheet ribbons that wrap helically to form the nanotube wall.

Magnetic Nanoparticles: Synthesis, Surface Modifications and Application in Drug Delivery

© 2012 Bucak et al., licensee InTech. This is an open access chapter distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/3.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. Magnetic Nanoparticles: Synthesis, Surface Modifications and Application in Drug Delivery

Cell Clarification and Size Separation Using Continuous Countercurrent Magnetophoresis

Nonmagnetic microparticles (e.g., cells, polymer beads) immersed in a magnetic fluid (ferrofluid) under a nonuniform magnetic field experience a magnetophoretic force in the direction of decreasing magnetic field strength. This phenomenon was exploited in the development of a continuous magnetophoretic countercurrent separation for the removal and concentration of micron‐sized particles from aqueous suspensions, and in particular as a viable approach for cell clarification of raw fermentation broth. A magnetic fluid is added to the cell suspension, the mixture is introduced to the magnetic separator, which consists of an open flow tube passing between pairs of magnets that move in a direction counter to the flow of the suspension. The cells are pushed ahead of the magnet pairs owing to the magnetophoretic forces acting on them, collected in a tube upstream of the feed injection point, and removed as a concentrated suspension for further treatment.

Assembly of magnetic nanoparticles into higher structures on patterned magnetic beads under the influence of magnetic field

The self-assembly of nanoparticles into higher organizations in a controlled manner has critical importance for the utility of the unique properties of nanoparticles. The behavior of magnetic Fe(3)O(4) nanoparticles (MNPs) with an average size of 6 nm under an enhanced magnetic force is reported. Upon evaporation of the solvent where the MNPs are suspended, formation of unique micrometer-sized structures is achieved only when there is a patterned surface constructed from sub-micrometer size magnetic beads in between the applied magnetic field and the MNPs. The preliminary results indicate that the combined effect of magnetic field and evaporation rate might help the control of nanoparticle behavior on surfaces and interfaces in constructing higher structures.

The effect of Fe3O4 nanoparticles on the thermal conductivities of various base fluids

Conventional heat transfer fluids have intrinsically poor heat transfer properties compared to solids. Enhancing the efficiency of heat transfer is of great interest for various industrial applications. Suspending solid particles in a fluid increases the thermal conductivity of the resulting suspension and enhances the heat transfer properties. In this work, changes in thermal conductivities of fluids upon the addition of magnetic nanoparticles have been investigated. Fe(3)O(4) nanoparticles are synthesized using different synthesis methods and are suspended in various oils. The effect of the base fluid and the type of magnetic particle on the thermal conductivity is investigated in detail. Up to 28% increase in the thermal conductivity is obtained with 2.5 wt% magnetic particles in hexane. The thermal conductivity enhancement is found to depend on the particle concentration, method of preparation and base fluid. The enhancements obtained are higher than those estimated using any theoretical model present in the literature.