Shailendra Naik

Leading Edge Film Cooling and the Influence of Shaped Holes at Design and Off-Design Conditions

Keywords: Heat Transfer ; Turbomachinery ; GTT ; LTT Reference LTT-CONF-2007-005View record in Web of Science URL: http://igti.asme.org/ Record created on 2007-05-22, modified on 2016-08-08

Heat Transfer in an Oblique Jet Impingement Configuration With Varying Jet Geometries

Experimental and numerical heat transfer results in a trapezoidal duct with two staggered rows of inclined impingement jets are presented. The influence of changes in the jet bore geometry on the wall heat transfer is examined. The goal of this project is to minimize the thermal load in an internal gas turbine blade channel and to provide sufficient cooling for local hot spots. The dimensionless pitch is varied between p/djet = 3 –6. For p/djet = 3 , cylindrical as well as conically narrowing bores with a cross section reduction of 25% and 50%, respectively, are investigated. The studies are conducted at 10,000 ≤ Re ≤ 75,000 . Experimental results are obtained using a transient thermochromic liquid crystal technique. The numerical simulations are performed solving the RANS equations with FLUENT using the low-Re k-ω-SST turbulence model. The results show that for greater pitch, the decreasing interaction between the jets leads to diminished local wall heat transfer. The area averaged Nusselt numbers decrease by up to 15% for p/djet = 4.5 , and up to 30% for p/djet = 6 , respectively, if compared to the baseline pitch of p/djet = 3 . The conical bore design accelerates the jets, thus increasing the area-averaged heat transfer for identical mass-flow by up to 15% and 30% for the moderately and strongly narrowing jets, respectively. A dependency of the displacement between the Nu maximum and the geometric stagnation point from the jet shear layer is shown.Copyright

Heat Transfer in a Confined Oblique Jet Impingement Configuration

Impingement cooling is widely used in cooling configurations for gas turbine components. Relatively high local heat transfer rates and the possibility of jet adjustment to specific geometries are advantageous for internal turbine blade cooling designs. In this paper a confined impingement cooling configuration is investigated. The assembly consists of four non-perpendicular walls of which one holds two rows of staggered inclined jets, each impinging on a different adjacent wall. The flow extraction is realized through two staggered rows of holes opposing the impingement holes wall. Heat transfer experiments were carried out using a transient liquid crystal technique for a series of jet Reynolds numbers between 10,000 and 75,000. The obtained local heat transfer data was evaluated regarding spatially resolved Nusselt numbers as well as line and area averaged values. The results include measurements of the discharge coefficients for the flow through the impingement holes. Numerical simulations of the flow field were carried out, complementary to the experiments. The simulations yield information for a better understanding of the main flow structures. The jets cause high heat transfer in the flow impinging regions with Nusselt numbers up to 180 for Re = 45,000. By contrast, for the same Reynolds number the Nusselt number drops below 20 in flow recirculation regions. For area-averaged Nusselt numbers, the correlation Nu ∝ Rex was found to be valid with slightly modified exponents for each passage wall.Copyright